Power Mac G4 / Macintosh Server G4
CD/DVD Drive
Replacement Instructions
Follow the instructions in this sheet carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Note: Written and video instructions covering customer-installable parts are available at
Warning: During this procedure, keep small parts away from chlldren.
Tools Required
The only tool required for this procedure is a Phillips screwdriver.
Opening the Computer
Warning: Always shut down your computer before opening it to avoid damaging its
internal components or causing injury. After you shut down the computer, the
internal components can be very hot. Let the computer cool down before
continuing.
1. Place your computer on a clean, flat surface.
2. If you think your computer is in sleep, press the power button on the front of the
computer to wake it.
3. Shut down your computer and wait five minutes before continuing.
4. If you attached a security cable through the computer’s lockable cover latch, remove
the cable.
5. Unplug all other cables from the computer except the power cord.
6. Touch the metal PCI access covers on the back of the computer. (Figure 1)
Important: To avoid electrostatic discharge, always ground yourself by touching the
port access covers before you touch any parts or install any components inside the
computer. To avoid static electricity building back up in your body, do not walk
around the room until you have completed the installation and closed the computer.
073-0624 Rev. B
2. Connect the cables to the Zip drive and CD/DVD drive:
• middle connector on the power cord bundle to the Zip drive.
• middle connector on the ribbon cable to the Zip drive.
• end of the power cord bundle to the CD/DVD drive.
• end of the ribbon cable to the CD/DVD drive.
3. Reattach the ribbon cable tape to the top of the carrier.
4. Insert the drive carrier into the computer, making sure the pegs on the bottom of the
carrier fit into the two notches in the drive shelf. (Figure 7)
5. Reinsert the four carrier mounting screws you removed earlier and tighten them to
secure the drive carrier to the chassis.
Closing the Computer
1. Raise the side access panel, lift the latch, and press the panel against the case until it
snaps securely into place.
2. Reconnect all cables and restart your computer.
Warning: Never turn on your computer unless all of its internal and external
parts are in place and it is closed. Operating the computer when it is open or
missing parts can damage your computer or cause injury.
Power Mac G4 CD/DVD Drive - 3
Apple Computer, Inc.
© 2001 Apple Computer, Inc. All rights reserved.
Under the copyright laws, this document may not be copied, in whole or in part, without the
written consent of Apple.
The Apple logo is a trademark of Apple Computer, Inc., registered in the U.S. and other
countries. Use of the “keyboard” Apple logo (Option-Shift-K) for commercial purposes
without the prior written consent of Apple may constitute trademark infringement and
unfair competition in violation of federal and state laws.
Every effort has been made to ensure that the information in this document is accurate.
Apple is not responsible for printing or clerical errors.
Apple Computer, Inc.
1 Infinite Loop
Cupertino, CA 95014-2084
USA
+ 1 408 996 1010
Apple, the Apple logo, Mac, Macintosh, and the Mac logo are trademarks of Apple
Computer, Inc., registered in the U.S. and other countries.
Power Mac is a trademark of Apple Computer, Inc.
Power Mac G4 CD/DVD Drive - 4
1
2
Power Mac G4 CD/DVD Drive - 5
3
4
Power Mac G4 CD/DVD Drive - 6
5
6
Power Mac G4 CD/DVD Drive - 7
7
Power Mac G4 CD/DVD Drive - 8
|