| HD7816, HD7814, HD7812, HD7811, HD7810   Coffee Machine   2 3 4 5 1 6 7 8 9 A B HD7811   HD7812, HD7810   10   14   18   11   15   19   12   16   20   13   17   21   22   26   23   27   24   25   4 Clean the coffee spout, the pod holders and the   drip tray in hot water, if necessary with some   washing-up liquid, or in the dishwasher (Fig. 21).   Never descale the SENSEO\ coffee machine with the   lid open. Make sure the lid is properly locked.   Problem   Solution   you have placed the water   reservoir properly;   6 Repeat steps 1 to 5 with a new mixture of descaler   and water.   5 Hold the cup tray in your hand while you clean it   with hot water, if necessary with some washing-up   liquid (Fig. 22).   7 Rinse the water reservoir with fresh water to   remove descaler residues.   there is enough water in the water   reservoir (i.e. above the ° MIN   level if you want to brew 1 cup);   You can also clean the cup tray in the dishwasher.   Flush the machine with fresh water at least 3 times   by repeating steps 1 to 5.   Do not refill the water reservoir with used hot   To clean the cup tray, always remove it from the   machine, as it might prove sharp when it is handled   incorrectly.Always handle it carefully.   , the ambient temperature is not   lower than 10°C. If it is, the machine   does not function properly.   water.   6 Clean the pod holders in hot water, if necessary   with some washing-up liquid, or in the   dishwasher. (Fig. 23)   Make sure the sieve in the centre of the pod holder is not   clogged. If the sieve is clogged, unclog it by rinsing the pod If the coffee machine has already been used and   8 Clean the pod holder after descaling to prevent the   sieve in the centre from getting clogged.   Water leaks   from the coffee   machine.   Make sure that:   Frost-free storage   holder under a running tap. If necessary, use a washing-up   brush or a pin to unclog the sieve.   therefore has been flushed with water, it may only be   used and stored in a frost-free place to prevent it from   becoming damaged.   you have closed the lid properly   (the lever must be properly locked);   7 Clean the water reservoir in hot water, if necessary   with some washing-up liquid. (Fig. 24)   you have not filled the water   Replacement   Note:You can remove the cover of the water reservoir   to clean the inside thoroughly.   You can order all removable parts from your Philips   dealer or a Philips service centre.   reservoir beyond the MAX level;   the sieve in the centre of the pod   holder is not clogged. If the sieve   is clogged, unclog it by rinsing the   pod holder under a running tap. If   necessary, use a washing-up brush   or a pin to unclog the sieve;   Note: If you use a washing-up brush, be careful not to   damage the valve in the bottom of the water reservoir.   Environment   , Do not throw away the machine with the normal   household waste at the end of its life, but hand it in   at an official collection point for recycling. By doing   this, you help to preserve the environment (Fig. 27).   8 Rinse the parts with fresh water after cleaning and   put them back into the machine.   9 Clean the water distribution disc with a moist   cloth (Fig. 25).   Be careful when you do this. Make sure that the rubber   sealing ring does not get stuck under the edge of the   water distribution disc. If it does, the coffee machine starts   to leak!   guarantee & service   you have put the coffee   pod properly in the centre of the   pod holder;   If you need service or information or if you have a   problem, please consult the worldwide guarantee leaflet   contact the Philips Customer Care Centre in your   country; they will be happy to help you.   The telephone number fior the United Kingdom is: 0845-   6010354.   the sealing ring is not stuck under   the edge of the water distribution   disc;   Flushing   If you have not used the coffee machine for three days,   flush it with fresh water before you use it again.   Flush the machine in the following way:   the water drops on the worktop are   not the result of placing or removing   the water reservoir or removing used   coffee pods;   You find the telephone numbers for other countries in the   worldwide guarantee leaflet. If there is no Customer Care   Centre in your country, turn to your local Philips dealer   or contact the Service Department of Philips Domestic   Appliances and Personal Care BV.You find their address   and fax number in the worldwide guarantee leaflet.   1 Fill the water reservoir with cold water up to   the MAX indication and put it back onto the   machine. (Fig. 3)   you do not remove the water   2 Put the 1-cup pod holder ° or the 2-cup pod   reservoir when the coffee machine   is heating up.This may cause water   that normally ends up in the water   reservoir to leak out of the machine.   holder °° in the machine without pod(s). (Fig. 6) The purchase of the Philips SENSEO\ coffee machine   does not exhaust any of the rights of Sara Lee/Douwe   Egberts or Philips under any of their patents nor does it   confer upon the purchaser a licence under these patents.   3 Put a bowl (with a capacity of at least 1500ml)   under the coffee spout to collect the water. (Fig. 8)   4 Press the on/off button I and subsequently press   In all other cases, contact the Philips   Customer Care Centre in your   country.   Troubleshooting   the 1-cup button ° and the 2-cup button °°   briefly at the same time. (Fig. 9)   If you have a problem, you may find the solution in the   table below. If the table does not provide the solution to   your problem or if you have a question, see the chapter   ‘Guarantee & service’.   The machine fills itself with water from the water   reservoir.This takes some time and you will probably not   notice that this happens.After a while, the machine starts   to flush and switches itself off after the flushing cycle.   The lid cannot   be opened.   A vacuum may have temporarily   formed under the lid.   Switch off the machine. Pull the   lever up as far as it goes and wait 24   hours before you open the lid.You   may need to use quite some force.   Problem   Solution   Descaling   Regular descaling prolongs the life of the coffee machine   and guarantees optimal brewing results for a long time.   If you use the machine twice a day on average, you must   descale it once every 3 months.   The indicator   light continues   to blink slowly.   You have not yet flushed the coffee   machine (see chapter ‘Preparing the   machine for use’.   Make sure that the sieve in   You have used the SENSEO\ coffee   machine at an altitude higher than   2200 metres above sea level.This   has caused the water in the machine   to start boiling before it has   reached the required temperature.   This prevents the machine from   functioning properly. Switch off the   machine and no longer use it at   altitudes higher than 2200 metres   above sea level.   the centre of the pod holder   is not clogged. If the sieve is   clogged, unclog it by rinsing the   pod holder under a running tap. If   necessary, use a washing-up brush   or a pin to unclog the sieve.   1 Fill the water reservoir up to the MAX indication   with descaler and water according to the   instructions on the package of the descaler.Then   put the water reservoir back onto the coffee   machine. (Fig. 3)   Use a descaler based on citric acid.   2 Press on/off button I. (Fig. 10)   The machine is ready for use when the indicator light   burns continuously.   If problems continue to occur,   contact the Philips Customer Care   Centre in your country.   3 Place the 1-cup pod holder ° in the coffee   machine, preferably with a used coffee pod in it.   Close the lid and make sure it is properly locked.   We advise you to put a used coffee pod in the pod   holder when you descale the machine.This pod serves   as a ‘filter’ to prevent the sieve in the pod holder from   getting clogged with scale residues.   The coffee   machine   produces less   coffee than   before.   Perhaps the sieve in the centre of   the pod holder is clogged. If the   sieve is clogged, unclog it by rinsing   the pod holder under a running tap.   If necessary, use a washing-up brush   or a pin to unclog the sieve.   The SENSEO\ You have not yet flushed the coffee   coffee machine machine.When you use the machine   does not   produce coffee before you can start brewing coffee   when it is (see chapter ‘Preparing the machine   for the first time, you have to flush it   switched on for for use’).   4 Put a bowl with a capacity of at least 1500ml under   the coffee spout to collect the mixture of descaler   and water. (Fig. 8)   the first time.   Descale the machine (see chapter   ‘Descaling’).   The indicator   light continues   to blink rapidly.   Make sure that:   5 Press the 2-cup button °° and let the machine   operate. Repeat this until the water reservoir is   empty. (Fig. 26)   4222.001.9719.8   3/4   Problem   Solution   The SENSEO\ You have not flushed the machine   coffee machine properly before first use.As a result,   brews only a   small quantity   of coffee or   the boiler is not or not completely   filled. Flush the machine properly   (see chapter ‘Preparing the machine   for use’) before you brew another   no coffee at all   when it is used cup of coffee.   for the first   time.   The lid cannot   be closed   properly.   Perhaps a used coffee pod is sticking   to the water distribution disc. If this   is the case, remove the used pod.   The machine   Contact the Philips Customer Care   has been stored Centre in your country.   in a room that   was not frost-   free.   The SENSEO\ Make sure that:   coffee is not   strong enough.   you have used the correct number   of pods and have pressed the right   button. Use 1 pod in combination   with the 1-cup pod holder ° and   the 1-cup button °. Use 2 pods   in combination with the 2-cup pod   holder °° and the 2-cup button   °°;   you have placed the coffee   pod(s) properly in the centre of   the pod holder, to prevent water   from escaping along the edge of the   pod(s).When you use two coffee   pods on top of each other, make   sure that the convex sides of both   pods point downwards and press   the pods lightly into the pod holder;   you have not used the same pod   twice by accident;   the coffee in the pod is evenly   distributed;   If you prefer a more robust flavour,   SENSEO\ coffee pods with a   stronger blend are available.   The SENSEO\ If you prefer a milder flavour,   coffee is too   strong.   SENSEO\ coffee pods with a milder   blend are available.   The coffee is   Do not use cups that are too large,   not hot enough. as they cause the coffee to get cold   more quickly.When you use cups,   make sure they have a capacity of   150ml.When you use a mug, make   sure it has a capacity of 280ml.   4222.001.9719.8   4/4   |