SAFETY
CONTROLS
1SLEEP/ RADIO ON
8ALARM 2 - BUZZ and also PRESET 2
– selects buzzer mode on or off for alarm 2
– stores and selects PRESET station 2
9ALARM 1 - RADIO and also PRESET 1
– selects radio mode on or off for alarm 1
– stores and selects PRESET station 1
0VOLUME
CANADA
Know these
safety
symbols
– displays/ adjusts/ switches off sleep time
– switches on radio; displays radio frequency
3SNOOZE/ BRIGHTNESS CONTROL
– switches off the alarm for 9 minutes period
– changes the brightness of the display illumination
3ALARM RESET/ RADIO OFF
– stops the active alarm for 24 hours
– stops radio /sleep function
1
C AUTION
1
2
RIS K OF ELECTRIC S HOCK
DO NOT OP EN
English: This digital apparatus does not exceed
the Class B limits for noise emissions
from digital apparatus as set out in the
Radio Interference Regulations of the
Canadian Department of
CAUTION: TO REDUCE THE RIS K OF ELECTRIC S HOCK, DO NOT
REM OVE COVER (OR BACK). NO US ER-S ERVICEABLE P ARTS
INS IDE. REFER S ERVICING TO QUALIFIED S ERVICE P ERS ONNEL.
– adjusts the sound level
!SET control
4BAND
– selects FM/AM waveband
– sets the times for •ALARM 1, •ALARM 2, •TIME
and to RUN on clock time
This “bolt of lightning” indicates uninsulated
material within your unit may cause an
electrical shock. For the safety of everyone in
your household, please do not remove
product covering.
The “exclamation point” calls attention to
features for which you should read the
enclosed literature closely to prevent
operating and maintenance problems.
7
3
4
5
5TIME SET/ TUNING: 1 MIN and HR 2
– adjusts the hours (HR 2) and minutes (1 MIN)
for clock/ alarm times
@Power cord
Communications.
– for AC power supply and improve FM reception
– tunes (1 , 2) to radio stations
6PRESET 3, 4 and 5
The type plate is located on the bottom of the set.
Français: Cet appareil numérique n’émet pas de
bruits radioélectriques dépassant les
limites applicables aux appareils
5
8
9
0
– stores and selects preset stations
7Display
6
– shows the clock/ alarm times and status of the set
numériques de Classe B prescrites
dans le Régelement sur le Brouillage
Radioélectrique édicté par le Ministère
des Communications du Canada.
WARNING: TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS EQUIPMENT TO
RAIN OR MOISTURE.
Environmental information
All unnecessary packaging material has been omitted to make the packaging easy to separate into two materials: paper (box
and paper pulp), polyethylene (bags, protective foam).
Your set consists of materials, which can be recycled if disassembled by a specialized company. Please observe
the local regulations to dispose of packing materials, dead batteries and old equipment.
CAUTION: To prevent electric shock, match wide
blade of plug to wide slot, and fully insert.
INSTALLATION
BASIC FEATURES
IMPORTANT SAFETY INSTRUCTIONS – Read before operating equipment
PHILIPS CONSUMER ELECTRONICS COMPANY
A Division of Philips Electronics North America Corporation
Knoxville, Tennessee 37914-1810, U.S.A.
POWER SUPPLY AND DEMO MODE
If power supply returns after 3 minutes and the display shows:
• clock time blinking – indicates you need to re-adjust the
clock time
• PHILIPS demo mode – indicates you need to re-enter preset
stations and the clock and alarm times.
This product was designed and manufactured to meet strict
quality and safety standards. There are, however, some
installation and operation precautions which you should be
particularly aware of.
1. Read these instructions – All the safety and operating
instructions should be read before the appliance is
operated.
2. Keep these instructions – The safety and operating
instructions should be retained for future reference
3. Heed all warnings – All warnings on the appliance and
in the operating instructions should be adhered to.
4. Follow all instructions – All operating and use
instructions should be followed
5. Do not use this apparatus near water – for example,
near a bathtub, washbowl, kitchen sink, laundry tub, in a
wet basement or near a swimming pool, etc.
6. Clean only with a damp cloth. The appliance should be
cleaned only as recommended by the manufacturer
7. Install in accordance with the manufacturers
instructions. Do not block any of the ventilation
openings. For example, the appliance should not be situated
on a bed, sofa, rug, or similar surface or placed in a built-in
installation, such as a bookcase or cabinet that may impede
the flow of air through the ventilation openings.
8. Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat
9. Do not defeat the
1. Check if the power voltage, shown on the type plate on the
bottom of the set, corresponds to your local power supply. If
it does not, consult your dealer or service centre.
2. Connect the power plug to the wall outlet. The power
supply is now switched on and the display will show the
PHILIPS demo mode.
™ PH..IL ..IPS scrolls across the display continuously.
• Turn the SET control to SET TIME to exit the demo mode.
3. To disconnect the set completely from the power supply,
withdraw the power plug from the wall outlet.
2
safety purpose of the polarized or
grounding-type plug. A polarized
plug has two blades with one wider
than the other. A grounding type
AC Polarized
Plug
plug has two blades and a third grounding prong. The wide
blade or the third prong are provided for your safety. When
the provided plug does not fit into your outlet, consult an
electrician for replacement of the obsolete outlet.
ILLUMINATION BRIGHTNESS
1. Check if the SET control is turned to CLOCK position and the
radio is switched off.
2. Press SNOOZE/ BRIGHTNESS CONTROL once or more.
– The brightness of the display will change in this
sequence:
10.Protect the power cord from being walked on or
pinched particulary at plugs, convenience receptacles, and
the point where they exit from the apparatus
11.Only use attachments/accessories specified by the
manufacturer
!
POWER BACK-UP
BRIGHT yMEDIUM yLOW yBRIGHT...
The power back-up conveniently allows your preset stations,
alarm and clock time settings to be stored for up to 3 minutes
when there is a power interruption e.g. AC mains failure.
The complete clock radio and display illumination will be
switched off. As soon as the power supply returns, the display
will indicate the correct time.
Note:
when an alarm or the SLEEP function is active, brightness
cannot be adjusted.
12.
Use only with a cart, stand, tripod, bracket,
or table specified by the manufacturer, or sold
with the apparatus. When a cart is used, use
caution when moving the cart/apparatus
combination to avoid injury from tip-over
RESET
Should the display and electronic functions of your set receive
interference e.g. static electricity from carpets, thunderstorms,
etc. RESET allows you to clear all previous settings and start
up again.
• Use a ballpoint pen to press the RESET hole found on the
bottom of the set.
13.Unplug this apparatus during lightning storms or when
unused for long periods of time
14.Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been damaged
in any way, such as power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped
MG-C200
MG-C205
@
™ Both the model number and production number are on the bottom of the set.
Printed in Hong Kong
EL 4562-E004: 99/3
|