Register your product and get support at
AJ1003
EN User manual
EN
1 Important
Safety
a
b
c
d
e
f
g
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with dry cloth.
Do not block any ventilation openings. Install in accordance
with the manufacturer’s instructions.
h
i
Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers)
that produce heat.
Protect the power cord from being walked on or pinched,
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
j
k
l
Only use attachments/accessories specified by the
manufacturer.
Unplug this apparatus during lightning storms or when
unused for long periods of time.
Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way,
such as power-supply cord or plug is damaged, liquid has
been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
m
Battery usage CAUTION – To prevent battery leakage which
may result in bodily injury, property damage, or damage to
the unit:
•
•
Install the battery correctly.
Remove the battery when the unit is not used for a long
time.
n
o
Apparatus shall not be exposed to dripping or splashing.
Do not place any sources of danger on the apparatus (e.g.
liquid filled objects, lighted candles).
p
Where the MAINS plug or an appliance coupler is used as
the disconnect device, the disconnect device shall remain
readily operable.
Warning
•
•
•
•
•
•
Never remove the casing of this apparatus.
Never lubricate any part of this apparatus.
Never place this apparatus on other electrical equipment.
Keep this apparatus away from direct sunlight, naked flames or heat.
Never look into the laser beam inside this apparatus.
Ensure that you always have easy access to the power cord, plug or
adaptor to disconnect this apparatus from the power.
Notice
This product complies with the radio interference
requirements of the European Community.
Any changes or modifications made to this device that are not
expressly approved by Philips Consumer Lifestyle may void the user’s
authority to operate the equipment.
Your product is designed and manufactured with high
quality materials and components, which can be recycled
and reused.
When this crossed-out wheeled bin symbol is attached
to a product it means that the product is covered by the
European Directive 2002/96/EC.
Please inform yourself about the local separate collection system for
electrical and electronic products.
Please act according to your local rules and do not dispose of your
old products with your normal household waste. Correct disposal of
your old product helps to prevent potential negative consequences
for the environment and human health.
Your product contains batteries covered by the European
Directive 2006/66/EC, which cannot be disposed
with normal household waste.Please inform yourself
about the local rules on separate collection of batteries because
correct disposal helps to prevent negative consequences for the
environmental and human health.
Environmental information
All unnecessary packaging has been omitted. We have tried to make
the packaging easy to separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags, protective foam
sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.
2 Your clock radio
Congratulations on your purchase, and welcome to Philips!To fully
benefit from the support that Philips offers, register your product at
Introduction
With this clock radio, you can:
•
•
•
•
enjoy the FM radio
know the time
wake up to buzz or favorite radio tone
set two alarms to ring at different time.
What’s in the box
Check and identify the contents of your package:
•
•
•
•
•
Main unit (with a battery embedded)
AC power adapter
User manual
Quick start guide
MP3 link cable
Overview of the main unit
a
+ TUNING -
•
Tune to a radio station.
b
REPEAT ALARM/BRIGHTNESS CONTROL
•
•
Repeat the alarm.
Adjust the brightness of display panel.
c
AL1, AL2
Enable/disable the alarm timer.
•
•
Activate the alarm time setup.
/ SOURCE
d
e
•
•
Turn on or off the unit.
Switch between FM radio play, MP3 link input, and clock
time display.
- VOLUME +
•
Adjust the volume level of radio.
f
g
Battery compartment
FM ANT
•
Attached FM radio antenna.
h
i
j
k
DC 5V
•
Power supply socket.
MP3 LINK
•
Audio input jack (3.5 mm ) for an external audio device.
SLEEP
•
Set the sleep timer.
SET TIME/PROG
•
•
Activate the clock time setup.
Program radio stations.
l
PRESET +/PRESET -
•
•
•
Adjust the date, clock time and alarm time.
Select time format.
Select a programmed radio station.
m
n
DATE
•
Display the preset time, month, day and year.
Display panel
3 Get started
Caution
•
Use of controls or adjustments or performance of procedures
other than herein may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in sequence.
If you contact Philips, you will be asked for the model and serial number
of this apparatus.The model number and serial number are on the
bottom of the apparatus.Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Activate the battery
Caution
•
•
•
Risk of explosion! Keep batteries away from heat, sunshine or fire.
Never discard batteries in fire.
Risk of product damage! When the apparatus is not used for long
periods, remove the battery.
Batteries contain chemical substances, so they should be disposed
of properly.
1
Remove the protective tab to activate the battery.
To replace the battery (See Figure B):
1
2
Open the battery compartment.
Insert one lithium CR2025 battery with correct polarity (+/-)
as indicated.
3
Close the battery compartment.
Connect power
Caution
•
Risk of product damage! Ensure that the power supply
voltage corresponds to the voltage printed on the back or the
underside of the apparatus.
•
•
Risk of electric shock! When you unplug the AC power adapter,
always pull the plug from the socket. Never pull the cord.
Before connecting the AC power adapter, ensure you have
completed all other connections.
1
Connect the power adapter to
•
•
the DC IN (DC 5V) jack on the back of the main unit.
the power socket.
5
Set time and date
1
In clock mode, press and hold SET TIME/PROG for 2 seconds.
2
Press PRESET +/PRESET -.
»
12-hour or 24-hour format is selected.
Press SET TIME/PROG to confirm.
The hour digits begin to blink.
3
»
4
5
6
7
8
Repeat steps 2-3 to set the hour.
Repeat steps 2-3 to set the minute.
Repeat steps 2-3 to set the year.
Repeat steps 2-3 to set the month.
Repeat steps 2-3 to set the day.
View the preset date
1
Press DATE repeatedly.
»
The clock time, month, day and year are displayed
consequently.
4 Listen to radio
Tune to a radio station
1
Press SOURCE repeatedly to turn on the radio.
FM and the current radio frequency appear.
»
2
Press +/- (on + TUNING -) repeatedly to tune to a radio
station.
Adjust the volume
1
Press +/- (on - VOLUME +) repeatedly.
Program radio stations automatically
Note
•
You can program a maximum of 20 preset radio stations.
1
2
Press SOURCE repeatedly to turn on the radio.
Press and hold SET TIME/PROG for 2 seconds.
»
All available stations are programmed in the order of
waveband reception strength.
»
The first programed radio station broadcasts automatically.
Program radio stations manually
Note
•
You can program a maximum of 20 preset radio stations.
1
2
Press SOURCE repeatedly to turn on the radio.
Press +/- (on + TUNING -) repeatedly to tune to a radio
station.
3
4
Press SET TIME/PROG.
»
The number begins to blink.
Press PRESET +/PRESET - repeatedly to select a preset
number.
5
6
Press SET TIME/PROG to confirm.
Repeat the above steps to program more stations.
Tip
•
To overwrite a programmed station, program another station in
its place.
Select a preset radio station
1
2
Press SOURCE repeatedly to turn on radio.
Press PRESET +/PRESET - to select a radio station.
5 Set the alarm timer
Set the alarm time
You can set two separate alarms.
Note
•
Before you start, ensure that the clock time is set correctly.
1
2
Press and hold AL1 (or AL2) for 2 seconds.
Press PRESET +/PRESET -.
»
The alarm tone is selected.
•
•
FM: The preset radio station.
: The buzz.
3
Press AL1 (or AL2) to confirm.
The hour digits begin to blink.
»
4
5
Repeat steps 2-3 to set the hour.
Repeat steps 2-3 to set the minute.
6
Repeat steps 2-3 to set the volume level (32 maximum) of
alarm tone.
Turn on/off the alarm timer
Note
•
Ensure that you already set the alarms successfully.
1
Press AL1 or AL2 twice.
»
If the alarm timer is turned on, or appears.
»
If the alarm timer is turned off, or disappears.
View the alarm settings
1
Press AL1/AL2.
Repeat alarm
1
When the alarm rings, press REPEAT ALARM/BRIGHTNESS
CONTROL.
The alarm repeats ringing 9 minutes later.
»
Stop alarm ring
1
When the alarm rings, press the corresponding AL1 or AL2.
The alarm stops but the alarm settings remain.
»
6 Other features
Set the sleep timer
You can set the radio to turn off automatically after a certain period of
time.
1
Press SLEEP repeatedly to select a preset period of time.
»
appears.
»
The volume decreases gradually in the last 5 minutes.
To turn off the sleep timer:
Press SLEEP repeatedly until
disappears.
1
(off) appears.
»
Adjust display brightness
1
Press REPEAT ALARM/BRIGHTNESS CONTROL repeatedly.
Listen to an external device
You can use this unit to play audio from an external device.
1
2
3
Connect the MP3 link cable (supplied) to
•
•
the MP3 LINK jack on the back of this unit
the audio output jack of the external device.
Press SOURCE repeatedly to select the audio input from MP3
LINK jack.
»
and
appear.
Press +/- (on - VOLUME +) repeatedly to adjust the volume
level.
7 Product information
Note
•
Product information is subject to change without prior notice.
Specifications
Tuner (FM)
Tuning Range
87.5 - 108MHz
<22 dBf
Sensitivity
- Mono, 26dB S/N Ratio
Search Selectivity
>28dBf
<3%
Total Harmonic Distortion
Signal to Noise Ratio
>50dB
General information
AC Power
Input: 220 - 230 V, 50 Hz
4.0 W
Operation Power Consumption
Dimensions
- Main Unit (W x H x D)
185 x 52 x 85 mm
Weight
- With Packing
- Main Unit
0.56 kg
0.46 kg
8 Troubleshooting
Caution
•
Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair the system yourself.
If you encounter problems when using this apparatus, check the
following points before requesting service. If the problem remains
unsolved, go to the Philips web site (www.philips.com/support).When
you contact Philips, ensure that your apparatus is nearby and the model
number and serial number are available.
No power
•
•
Ensure that the Mains cord is connected securely.
Ensure that there is power at the AC Mains.
No sound
•
Adjust the volume.
No response from the unit
•
Disconnect and reconnect the AC power plug, then turn on
the unit again.
Poor radio reception
•
Increase the distance between the apparatus and your TV or
VCR.
•
•
Fully extend the antenna.
Connect an outdoor antenna instead.
Timer does not work
•
•
Set the clock correctly.
Switch on the timer.
Clock/timer setting erased
•
•
Replace the battery.
Power has been interrupted or the power plug has been
disconnected.
•
Reset the clock/timer.
© 2010 Koninklijke Philips Electronics N.V.
All rights reserved.
AJ1003_12_UM_V2.1
|