KS-124
24-Port 10/100 Workgroup Switch
User’s Guide
DOC.070524-KS124
z
Runt and CRC Filtering eliminates erroneous packets to optimize the
network bandwidth.
z
z
z
z
Support to handle up to 1522 bytes packet.
LED indicators for simple diagnostics and management.
Internal switching power supply.
Plug and Play.
3. Package Contents
z
z
z
z
Rackmount Kit.
User guide.
Power cord.
10/100Mbps Fast Ethernet Switch
4. Hardware Introduction
4.1 Front Panel
The unit front panel provides a simple interface monitoring the Switch.
See the chart in section 4.2 for the status of each LED denotes.
4.2 LED Displays
LED Function Color
Description
PWR
Green
Green
Lit: Power on
LNK/ACT
Lit: Indicates there is a link
Flash: indicates there is an activity
Lit: 100Mbps
10/100
Green
Unlit: 10Mbps
3
4.3 Rear Panel
The rear panel of the 24-port Fast Ethernet Switch indicates an AC inlet,
which accepts 100-240VAC 50-60Hz power input.
Specifications
IEEE 802.3 10Base-T Ethernet
Standard
IEEE 802.3u 100Base-TX Fast Ethernet
- Ethernet
:
10Mbps (half-duplex)
20Mbps (full-duplex)
Data Transfer Rate
- Fast Ethernet : 100Mbps (half-duplex)
200Mbps (full-duplex)
-100Base-TX UTP/STP category 5 cable
-10Base-T UTP/STP category 3 or 5 cable
Network cable
Ports
24 10/100Mbps Auto-MDI / MDI-X Ports
System – Power LED
LED indicators
Individual port – link/activity and speed LEDs
283mm(W) x 178mm(D) x 44mm(H)
Dimension
Temperature
Humidity
Operating 0°C to 50°C (32° to 122° F)
Storage
-20°C to 70°C (-4° to 158° F)
Operating 10% to 90% RH, Non-condensing
Storage 5% to 90% RH, Non-condensing
100 – 240VAC, 50 / 60Hz, Auto-sensing
FCC Part 15 Class B, CE
Power Input
Registrations
4
5. FCC Warning
This equipment has been tested and found to comply with the regulations
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with this
user’s guide, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the
interference at his own expense.
z
z
z
Reorient the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit in a different room
that to which the receiver is connected.
z
Consult the dealer or an experienced radio/TV technician for help.
6. CE Mark Warning
This is a Class B product. In a domestic environment, this product may
cause radio interference, in which case the user may be required to take
adequate measures.
5
|