H2O Audio Cell Phone Accessories S9 75 20070823 User Manual

!WARNING!  
H2O Audio stands behind our products.  
Failure to follow our instructions could destroy  
your iPod and will void the Warranty. If you have  
any concerns, or experience any difficulties with  
your H2O Audio product, we are here to help you,  
so please contact us directly. We can be reached at:  
1.800.708.6080 or 858.623.0339  
S9-75 20070823  
Please take a moment and visit  
For updated Instruction Manuals,  
Product Registration and to  
complete your warranty.  
STOP  
iV6 - 75 20071012  
Belt Clip and Sport Armband  
Your Waterproof Case for iPod nano comes with a  
removable, reversible Belt Clip and a neoprene Sport  
Armband suitable for most active sports. The Belt  
Clip is held in place by two screws that can be  
installed using a standard Phillips Head screwdriver.  
The Belt Clip can be reversed to change the access  
direction of the stereo jack.  
iN3-39 20071106  
3. Introduction  
2. Case Features  
The H2O Audio Waterproof Case lets you to listen to digital audio during  
active watersports. It houses the Apple iPod nano (3rd Gen) digital media  
player.  
CASE: The H2O Audio case features the LatchTightTM Locking System which  
keeps the unit waterproof during operation and allows for functional control  
of the player while in the water with the CommanderTM Scroll Wheel.  
h2oaudio.com  
LatchTightTM Locking  
System  
Compatible with  
NOTE: The iPod is NOT waterproof without the H2O Audio case and  
Waterproof Headphones and is NOT covered under the product warranty.  
Any attempt to use the case with an audio player other than the Apple iPod  
nano (3rd Gen) will void the Warranty.  
iPod nano (3rd Gen)  
iN3  
Lens Clear  
Display Window  
HEADPHONES: The case is only waterproof when combined with H2O Audio  
waterproof headphones (sold separately). Use of other headphones with a  
3.5mm stereo connector will result in a water resistant case, and should not  
be submerged.  
Waterproof Case for the  
iPod® nano (3rd Gen)  
Printed Instructions  
CommanderTM Scroll  
Wheel Control  
4. Leak Test  
Before utilizing the system for the first time, it is highly recommended to  
perform a 'Leak Test'. Follow the instructions below.  
DO NOT INSTALL THE iPod nano (3rd Gen)  
INSIDE THE CASE FOR THE LEAK TEST  
SealTightTM Connector  
1. Open the case (Section 5), and verify the T-Seal is clean and free of debris.  
2. Close the case (Section 5) and attach H2O Audio Waterproof Headphones.  
3. Immerse the case, (without the iPod nano 3rd Gen) in water and soak for 30 min.  
4. Manipulate the CommanderTM Scroll Wheel during submersion.  
5. Remove from the water, dry the exterior. Visually inspect the case for any sign of leaks  
before opening.  
H2O Audio cases are designed for specific Apple iPod models, which vary by  
generation and storage size. You must ensure the correct case is purchased  
for your specific iPod model.  
6. Open the case upside down to prevent water from dropping into the case during  
opening.  
IMPORTANT: Make sure the seal is fully seated against the housing base each time you close the  
housing. Use the lid to compress the seal into the base if required.  
Before using this system, please be sure to read, understand, and follow the instructions in this manual.  
5. Unlocking & Locking the Case  
6. The T-Seal  
7. Installing the iPod into the Case  
Installing the iPod  
Unlocking your case  
Locking your case  
The removable, black, T-Seal (retained in  
the lid), between the base and the lid of  
T-Seal  
the case is, what keeps your iPod safe and  
dry.  
T-Seal  
Water  
iPod nano  
Contact Surfaces  
Housing  
1.Slide latch button towards the  
1.Close the lid, and hook the  
unlock  
icon.  
buckle under the base.  
1.Align the audio port with the  
2.Gently snap the player into the  
audio jack. Verify the player is  
completely plugged into the  
audio jack.  
IT IS EXTREMELY IMPORTANT YOU ENSURE THE T-SEAL IS PROPERLY  
SEATED DURING EACH CLOSURE. If it is out of alignment or twisted you  
will cause damage to or destroy your iPod.  
stereo jack in the case.  
IMPORTANT: Remove any skins or  
covers from your iPod before installing  
it into the housing.  
Prior to use, verify:  
Do NOT use if:  
Compatible with iPod nano (3rd Gen)  
1. T-Seal is aligned properly in the  
Contact Surface of the lid prior  
to closure.  
1. T-Seal is twisted or out of  
alignment during closure.  
Removing the iPod  
2.While holding the latch button  
2.Pull the latch towards the case  
2. T-Seal and contact surface have 2. T-Seal and Contact Surfaces  
towards the unlock  
icon,  
and snap close.  
been cleaned as necessary using  
a soft, lint-free cloth.  
have any dirt, lint, hair, and/or  
other debris.  
push away from the case to open  
the latch.  
1.Slide the player off  
of the stereo jack.  
Now the player can  
slide straight out of the  
case.  
3. T-Seal and Contact Surface are  
free of scratches and other  
imperfections.  
3. You see scratches or imperfections  
on the T-Seal or Contact Surfaces.  
DO NOT USE SILICONE GREASE as this will damage the seal.  
3.Verify the lid & latch are closed  
with the button positioned on the  
icon prior to entering the water.  
Verify the T-Seal is aligned properly.  
To ensure the T-Seal is fully seated in the base of the case, firmly squeeze  
both sides (the base and lid) of the case together after each insertion of the  
player. Always check to make sure the latch is closed and locked prior to use.  
If you have any questions or doubts, please contact H2O Audio Customer Support  
NOTE: Do not disturb the T-Seal during removal of the player. If the T-Seal is moved, Please use the  
case lid to completely seat the T-Seal.  
3.Unhook the buckle from the base.  
iN3 - 70 20071106  
8. Connecting the Headphones  
9. CommanderTM Scroll Wheel Control  
10. General Storage Procedures  
The SealTightTM Connector is what keeps your audio connection safe and  
dry underwater. It is designed specifically to create a seal around the  
H2O Audio Waterproof Headphones (sold separately). Using any other  
headphones will not have a complete waterproof connection, and  
reduces the waterproof rating to water-resistant.  
The CommanderTM Scroll Wheel Control is a waterproof assembly, which  
allows you to maintain complete control over the iPods Click wheel  
functions. Refer to iPod Instruction Manual for complete details of how  
to use the player.  
For long-term storage, store in a plastic bag out of direct sunlight.  
CAUTION: The life of a T-Seal is typically one (1) year. Contact H2O Audio  
for spare T-Seals or a maintenance kit. Always remember to reinstall the  
T-Seal before next use. Do not expose the housing to extreme heat, such  
as the inside of a hot car, or in hot direct sunlight, such as on a beach, or  
boat deck. Doing so may cause damage and subsequent flooding.  
Menu Button  
CAUTION: The housing is succeptible to internal condensation with  
extreme temperature fluctuations. Use above 105°F(40C) can result in  
internal condensation. When used in temperatures below freezing, frost  
will appear on the interior of the housing.  
1. To create a waterproof connection, align the 3.5mm stereo plug on the  
CAUTION: Do not store housing in the following environments:  
* Solvents or other chemical fumes  
* High humidity  
Next / Fast-  
Forward Button  
headphones with the stereo jack of the case.  
* High Ozone  
* Extreme temperature fluctuations  
Select Button  
Storing the housing in these conditions may lead to a damaged housing,  
causing it to leak.  
Scroll Wheel rotates  
Clockwise &  
Counter- Clockwise  
Rinse the EXTERIOR of the system in fresh water after EACH use:  
1. Make sure the housing is securely closed with headphones attached.  
2. Soak in clean fresh water for 30 minutes.  
3. Rinse the entire system with freshwater  
2. Insert the headphones into the stereo jack of the housing, ensuring  
that the plug mates securely into the SealTightTM Connector.  
CAUTION: The SV Series Headphones do not fit with the SealTightTM Connector boot  
featured on the H2O Audio Series housings. If your headphones have a connector  
that looks like the one shown below, you can not use them with this housing.  
4. Completely dry the entire exterior of the system using a clean soft  
cloth.  
Play / Pause Button  
5. Dry face down so water can properly drain from the CommanderTM  
Scroll Wheel.  
Previous / Rewind  
Button  
Strong detergents, soaps, and chemicals MUST NEVER be used to clean  
the system.  
SV Series Headphones Connector  
11. Available Accessories  
14. Warranty Coverage  
13. General Use Notice  
H2O Audio guarantees, to the original purchaser only, that the equipment purchased  
(EXCLUDING THE iPod ) is free of defects in material and/or under normal recreational use  
for a period of one year (1) from date of consumer purchase from an Authorized Dealer;  
provided that proper care and maintenance have been performed as prescribed by the  
owner's guide included with the equipment. Should this product prove to be defective for  
any reason (other than those listed as limitations below) the product will be serviced or  
replaced at H2O Audio's sole discretion at no charge (excluding shipping and handling).  
This warranty shall be void if the registration is not completed and sent to H2O Audio  
Customer Services within 30 days of purchase. This warranty shall be void if the  
equipment has been tampered with by anyone not authorized to perform service. The  
warranty is non-transferable and extends to the original purchaser only and is valid only if  
the equipment was purchased from an authorized dealer. Warranty does not extend to  
cover damage from accident, abuse, tampering, lack of maintenance, theft, or loss. Service  
or modifications by anyone other than an Authorized H2O Audio agent will void the  
warranty. H2O Audio will not be responsible for recovery or replacement of the product in  
the event of loss or theft. H2O Audio, its Authorized International Distributors, and  
Authorized Dealers make no other warranties, either express or implied or orally, or in  
writing, with respect to any other warranty coverage except those expressly stated within  
the preceding sentences. H2O Audio will not be held responsible for any agreements orally  
or in writing with the exception of those expressly included in this warranty statement. The  
warranty registration card and the terms contained herein supersede all statements  
contained in any and all owner's guides, instruction cards, or other equipment literature or  
catalogs. In no event will H2O Audio, its Authorized International Distributors, and  
Authorized Dealers be held responsible or liable for any personal injuries resulting from the  
use of the covered equipment, or for any other damages, whether direct, indirect,  
incidental, or consequential; even if H2O Audio has been advised of such damages.  
Warranty does not extend to any damages that may occur to the iPod or loss of any data.  
READ THIS MANUAL CAREFULLY. IF YOU HAVE ANY  
QUESTIONS PLEASE CONTACT H2O AUDIO CUSTOMER  
SUPPORT PRIOR TO USE.  
H3 Waterproof Headphones  
(required for use underwater)  
IMPROPER USE OF THIS SYSTEM MAY CAUSE THE USER TO  
MAKE MISTAKES OR DECISIONS THAT MAY LEAD TO SERIOUS  
INJURY OR DEATH.  
SISTM - Sports Integration System  
Universal Locking Plate  
Bike Mount  
Belt Clip Mount  
Backpack Mount  
IMPORTANT WARNING AND DISCLOSURE:  
IT CAN BE POTENTIALLY DANGEROUS TO PLAY YOUR HEAD-  
PHONES WHILE ENGAGING IN ACTIVITIES THAT REQUIRE  
YOUR FULL ATTENTION. YOU SHOULD EXERCISE EXTREME  
CAUTION OR DISCONTINUE USE IN POTENTIALLY HAZARDOUS  
SITUATIONS. DO NOT USE THE HEADPHONES WHILE DRIVING,  
CYCLING, OR OPERATING ANY MOTORIZED VEHICLE. IT MAY  
CREATE A TRAFFIC HAZARD AND IS ILLEGAL IN SOME AREAS.  
*Sport Armband Not Included  
Swimbelt designed by swimmers  
AVOID USING HEADPHONES AT HIGH VOLUME. HEARING  
EXPERTS ADVISE AGAINST CONTINUOUSLY LOUD AND  
EXTENDED PLAY. IF YOU EXPERIENCE RINGING IN YOUR EARS,  
REDUCE VOLUME OR DISCONTINUE USE.  
12. Contact Us  
Customer Support is available Monday to Friday 9AM to 5PM PT.  
15. Returns  
THE MANUFACTURER DOES NOT WARRANT AND WILL NOT BE  
HELD RESPONSIBLE IN ANY WAY FOR DAMAGES TO THE iPod,  
OR LOSS OF DATA, INCLUDING LOSS OF DATA STORED IN THE  
iPod, RESULTING FROM AN EXCESSIVE IMPACT, THUNDER, OR  
AN ELECTRICITY FAILURE, OR WATER DAMAGE. YOU WILL BE  
RESPONSIBLE FOR SAFE GUARDING ALL DATA STORED ON  
YOUR DEVICE.  
P. 800.708.6080 or 858.623.0339  
F. 858.225.0815  
Prior to any return, a Return Authorization (RA) number must be obtained. To receive an  
instructions on how to return a product. Proof of purchase from an Authorized Dealer  
will be required. A copy of the original sales receipt and a copy of the owner's portion of  
the warranty card must accompany all correspondence regarding the equipment covered  
by this warranty agreement or in direct reference to this warranty.  
Copyright Notice:  
This owners manual is copyrighted, all rights reserved. It may not, in whole or in part, be copied,  
photocopied, reproduced, translated, or formed into any electronic format without prior consent in  
writing. H2O Audio is a registered trademark of H2O Audio, Inc. Apple and iPod are registered  
trademarks of Apple Inc.  
Patents 6396769, 6614722, 6954405, 7263032 Others Pending.  
iN3 - 70 20071106  

Motorola V70 User Manual
Lenovo THINKCENTRE 8084 User Manual
Kenwood KDC 9017 User Manual
JVC KD LH7R User Manual
JVC GET0561 001A User Manual
Hypertec HYFLUSB028GB User Manual
Centon electronic DataStick Designer DSD4GB 005 User Manual
Cambridge Audio TOPAZ CD10 User Manual
Belkin P35772ec User Manual
Addonics Technologies AD44MIDE2CF User Manual