Dual-Cool Notebook Cooler Pad
Model #: CF4500U
User’s Manual
Rev. 060801
Package Contents:
Your new Cooler Pad will ship with the following items.
§ Dual-Cool Notebook Cooler Pad
§ USB Power Cable
§ User’s Manual
§ Warranty Information
System Requirements:
Please be sure that you meet all of the system requirements below to avoid difficulties during installation.
§ Available USB Port
§ IBM PCs, 100% Compatibles, or Macs
System Specifications:
Your new Cooler Pad complies with the following specifications.
§ USB Powered
3
Installation:
NOTE: The pictures shown in the User’s Manual are for demonstration purposes only. Your computer or product may look slightly different.
1. Open the Power Cable Storage cover located on the back of your Cooler Pad. Take out the USB Power Cable and the Height
Adjusting Knobs, and then replace the cover.
2. Connect the USB Power Cable to the DC 5V Power Connector located on the side of your Cooler Pad, and then connect the
other end into an available USB port on your notebook.
3. Place your notebook on your Cooler Pad.
4. Turn on your notebook, and then turn on your Cooler Pad using the Cooler Pad Power Switch.
5. To adjust the speed of the fans on your Cooler Pad, use the Fan Speed Scroll Button on the front of your Cooler Pad (NOTE: L
represents low and H represents high).
6. Your Cooler Pad is now ready to be used.
4
5
FCC Information:
FCC
This equipment has been tested and found to comply with limits for Class B digital device pursuant to Part 15 of Federal Communications
Commission (FCC) rules.
FCC Compliance Statement
These limits are designed to provide reasonable protection against frequency interference in residential installation. This equipment generates,
uses, and can radiate radio frequency energy, and if not installed or used in accordance with the instructions, may cause harmful interference to
radio communication. However, there is no guarantee that interference will not occur in television reception, which can be determined by
turning the equipment off and on. The user is encouraged to try and correct the interference by one or more of the following measures:
§ Reorient or relocate the receiving antenna
§ Increase the separation between the equipment and the receiver
§ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected to.
CAUTION!
The Federal Communications Commission warns the user that changes or modifications to the unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
6
Warranty Information:
Gear Head, LLC warrants that this product shall be free from defects in materials and workmanship for the reasonable lifetime of the product. If the
product is defective, Gear Head, LLC’s sole obligation under this warranty shall be at its election, subject to the terms of this warranty, to repair or
replace any parts deemed defective. This warranty is for the exclusive benefit of the original purchaser and is not assignable or transferable. THIS
WARRANTY IS MADE IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, AND ANY IMPLIED WARRANTIES,
INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO
THE TERMS OF THIS WARRANTY, UNLESS OTHERWISE PROHIBITED BY LAW.
Exclusions
To the fullest extent permitted by law, Gear Head, LLC expressly disclaims and excludes from this warranty any liability for damages, including but
not limited to general, special, indirect, incidental, consequential, aggravated, punitive or exemplary damages, and economic loss (even if Gear
Head™ is informed of their possibility), third party claims against you, including for any loss or damages, and claims or damages related to loss of,
or, damage to, your records or data. This warranty does not apply to any product the exterior of which has been damaged or defaced. This warranty
will be voided by misuse, improper physical environment, improper repair, acts of God, war or terror, commercial use, and improper service,
operation or handling.
Technical Support
Gear Head™ provides Technical Support Monday - Friday from 9:00 am – 5:30 pm Eastern Time. Before calling, please make sure you have
available the Model # (located on the front page of your User’s Manual) and information regarding your computer’s operating system.
Please contact our technicians at
1-866-890-7115
Return Merchandise for Service
Any claim under this warranty must be made in writing to Gear Head, LLC, at the address provide by our technician, within 30 days after the owner
discovers the circumstances giving rise to any such claim, and must include a copy of this warranty document, a receipt or copy of your invoice
marked with the date of purchase, and the original packaging. You may obtain service by calling the technician for a Return Merchandise
Authorization (RMA) number. The RMA number must be prominently displayed on the outside of the shipping carton and the package must be
mailed to Gear Head™ postage prepaid.
7
|