4
5
Unpack the ink cartridges that came with your printer
and remove the yellow tape from the top.
2 Attach the
2
CAUTION: Install both ink cartridges
and leave them installed for all types
of printing, or the printer won’t work.
Paper Holders
Slide the paper support into its three slots on the
®
EPSON Stylus Photo 825
1
back of the printer.
Tilt each cartridge toward you as you lower
it into the holder.
Start
Here
Make sure the tabs rest on the hooks in the back.
2
Slide the roll paper adapter behind the paper support,
into the two slots on the back of the printer.
6
7
Lower the clamps so they snap shut.
NOTE: For information on loading and
printing on roll paper, see your Printer
Basics book.
3
Insert the tabs on the roll paper holders into the slots
on the back of the printer.
Press the
ink replacement button and
close the cover.
The green light flashes as your printer
charges ink for about 21/2 minutes.
CAUTION: Don’t turn off the printer
or interrupt charging while the green
light is flashing or you’ll waste ink.
3Turn On the Printer
1
Plug the printer’s power cord into a grounded electrical outlet.
5 Load Paper
CPD-14525R1
4042683-00
1
2
3
Load some paper against the right side of the feeder
(up to the arrow inside the edge guide).
Press in the tab on the edge guide and slide it
to fit lightly against the paper stack.
1Unpack
2
Press the dark gray
button to turn on the printer.
power
1
Remove everything from the box.
Pull out the output tray extensions.
Printer Software
Ink cartridges
CD-ROM
Paper support
Printer
CompactFlash™
card adapter
6 Connect the Printer
6
4 Install Ink Cartridges
Printer Basics
Quick Reference
Roll paper
holders
Roll paper
adapter
card
book
1
Make sure you have a USB cable (not included with your printer).
Multi-card
adapter
1
2
Open the output tray.
Open the printer cover.
2
Remove the tape and packing material.
Peel off the
plastic film
2
Plug the
square end of the USB cable into your printer’s USB port.
3
Peel off the tape beneath the cover
and remove the insert.
3
Lift up both ink cartridge clamps.
3
Plug the
flat end of the cable into any available USB port on your computer.
Continue
Turn over
|