3-261-583-22(1)
English
Presetting Stations Manually
“WALKMAN” is a registered trademark of Sony Corporation to
represent Headphone Stereo products.
Preparations
To Insert Battery A
Precautions
On batteries
1 Press FM or AM to select the desired band
Radio
is a trademark of Sony Corporation.
and to turn on the radio.
• Do not carry dry batteries with coins or other metallic objects.
It can generate heat if the positive and negative terminals of the
batteries are accidentally contacted by a metallic object.
• When you are not going to use your Walkman for a long time,
remove the battery to prevent damage from battery leakage
and corrosion.
Cassette Player
“WALKMAN” est une marque déposée par Sony Corporation pour
représenter les produits stéréo dotés d’écouteurs.
2 Press ENTER.
1 Slide open the battery compartment lid,
and insert one R6 (size AA) dry battery with
correct polarity.
The frequency digits will flash in the
display.
est une marque de Sony Corporation.
Operating Instructions
3 While the frequency digits are flashing, tune
in to a station you wish to store using
The validity of the CE marking is restricted to only those
countries where it is legally enforced, mainly in the
countries EEA (European Economic Area).
Replace the battery with new one when "
flashes in the display.
"
Mode d’emploi (au verso)
Gebruiksaanwijzing (achterzijde)
On handling
• Do not leave the unit in a location near heat sources, or in a
place subject to direct sunlight, excessive dust or sand,
moisture, rain, mechanical shock, or in a car with its windows
closed.
PRESET/TUNING + or – and press ENTER.
The preset number will flash in the display.
La marque CE est valable uniquement dans les pays où
elle a force de loi, c’est-à-dire principalement dans les
pays de l’EEE (Espace Economique Européen).
Playing a Tape
4 While the preset number is flashing, select
the preset number you want using
• We do not recommend the use of tape longer than 90 minutes.
They are very thin and tend to be stretched easily. This may
cause malfunction of the unit or sound deterioration.
• The LCD display may become hard to see or slow down when
using the unit at high temperatures (above 40°C/104°F) or at
low temperatures (below 0°C/32°F). At room temperature, the
display will return to its normal operating condition.
• If the unit has not been used for a long time, set it in the
playback mode to warm it up for a few minutes before you
start using it again.
1 Insert a cassette. B
2 Press N PLAY.
PRESET/TUNING + or – and press ENTER.
De geldigheid van het CE-keurmerk is beperkt tot de
landenwaarditkeurmerkwettelijkmoetwordennageleefd,
hoofdzakelijk in EER (Europese Economische Ruimte).
Notes
Adjust the volume with VOL.
•If you cannot complete step 3 or 4 while the indicators
are flashing, repeat from step 2.
•If a station is already stored, the new station replaces
the old one.
To
Press
Stop playback
Wind rapidly*
x STOP
On headphones/earphones
Road safety
M FF or m REW
WM-FX290
Playing the Preset Radio Stations
Do not use headphones/earphones while driving, cycling, or
operating any motorized vehicle. It may create a traffic hazard
and is illegal in some areas. It can also be potentially dangerous
to play your headphones/earphones at high volume while
walking, especially at pedestrian crossings.
©2004 Sony Corporation Printed in China
* If you leave the unit after the tape has been wound or
rewound, the battery will be consumed rapidly. Be
sure to press x STOP.
1 Press FM or AM to select the desired band
and to turn on the radio.
2 Press MENU repeatedly to set the cursor in
the display to TUNE MODE. Then press
SET to display “PRESET”.
You should exercise extreme caution or discontinue use in
potentially hazardous situations.
Note
Do not open the cassette holder while the tape is
running.
Preventing hearing damage
A
B
Do not use headphones/earphones at high volume. Hearing
experts advise against continuous, loud and extended play. If
you experience a ringing in your ears, reduce the volume or
discontinue use.
3 Press PRESET/TUNING + or –.
To cancel a stored station
Listening to the Radio
1Follow the procedure above and in step 3, select
the preset number you want to cancel and then
press ENTER. The frequency digits will flash in the
display.
2Press and hold PRESET/TUNING + or –. The
frequency digit starts running up or down. Keep
holding down the button until “- - - -” is displayed.
3Press ENTER while “- - - -” is flashing. A preset
number will flash in the display.
Caring for others
Keep the volume at a moderate level. This will allow you to hear
outside sounds and to be considerate to the people around you.
AA (R6) x 1
1 If the HOLD function is turned on, set the
HOLD switch in the opposite direction of
the G mark to unlock the controls. Make
sure that the tape has stopped completely.
On maintenance
FM
AM
C
• Clean the tape head and tape path using a cotton swab and
commercially available cleaning solvent after every 10 hours of
use.
2 Press FM or AM to select the desired band
• To clean the exterior, use a soft cloth slightly moistened in
water. Do not use alcohol, benzine or thinner.
• Clean the headphones/earphones plugs periodically.
and to turn on the radio.
4Press ENTER to cancel the stored station.
3 For manual tuning:
1 Press MENU repeatedly to set “_” (the
cursor) in the display to TUNE MODE
and press SET to choose “MANUAL”.
2 Press PRESET/TUNING + or –
repeatedly to tune in to the desired
station.
Hold down PRESET/TUNING + or – for
a few seconds to scan for stations.
For preset tuning:
1 Press MENU repeatedly to set the cursor
in the display to TUNE MODE and press
SET to choose “PRESET”.
2 Press PRESET/TUNING + or –
repeatedly to recall the desired preset
station.
Scanning the Preset Radio Stations
— DAPS (Digital Auto Preset Scanning)
1 Press FM or AM to select the desired band
and to turn on the radio.
2 Press and hold FM or AM pressed in step 1
for 2 seconds or more.
The preset stations of the selected band will
be played for about 5 seconds each. (During
DAPS the indicators in the display flash.)
i
HOLD
VOL*
3 Press FM or AM again to select the station
while the desired preset station is being
played.
x STOP
ENTER
Notes
M FF
To use preset tuning, preset the station
first (see “Presetting Radio Stations”).
PRESET/TUNING +/–
SET
•If there are no stations stored, the DAPS function does
not work.
N PLAY**
•Until a station is selected in step 3, the DAPS function
turned on in step 2 will continue.
•In step 2 or 3, if you select a band which you did not
select in step 1 by pressing FM or AM, the newly
selected band will be played normally.
RADIO OFF
m REW
To turn off the radio
Press RADIO OFF.
FM
MENU
To improve broadcast reception C
AM
•For FM: Extend the headphones/earphones cord
(antenna). If the reception is still not good, press
MENU repeatedly to set the cursor in the display to
FM MODE. Then press SET to switch between
“LOCAL” and none (DX), or “MONO” and none
(stereo) for best reception.
*
There is a tactile dot beside VOL on the main unit to show the direction to turn up the
volume.
Using Other Functions
Locking the Controls
Set the HOLD switch in the direction of the G mark
to lock the controls.
** The button has a tactile dot.
•For AM: Reorient the unit itself.
Specifications
• Frequency range
FM: 87.5 - 108 MHz
AM: 530 - 1 710 kHz (North, Central and South America)
531 - 1 602 kHz (Other countries)
• Output
Headphone (i) jack
Load impedance 8 – 300 Ω
• Power requirements
The HOLD function only locks the radio operation
buttons, MENU, SET, PRESET/TUNING + or – and
ENTER.
Battery life* (approximate hours)
Sony alkaline LR6 (SG)** Sony R6P (SR)
Presetting Radio Stations
You can preset up to 40 stations.
For Canada and Central/South America: 30 for FM
and 10 for AM.
For other countries: 35 for FM and 5 for AM.
Tape playback 35
Radio reception 40
9
Emphasizing Bass Sound
14
Press MENU repeatedly to set the cursor to MB
(mega bass) in the display. Then, press SET to turn
MB on. With each press, the indications change as
follows.
MB (mega bass) : emphasizes bass sound
No message: off (normal)
* Measured value by the standard of JEITA (Japan Electronics
and Information Technology Industries Association). (Using
a Sony HF series cassette tape)
**When using a Sony LR6 (SG) alkaline dry battery (produced
in Japan).
1.5V DC, battery R6 (size AA) x 1
Presetting Automatically Scanned
Stations
• Dimensions (w/h/d)
Approx. 83.6 x 112.0 x 28.3 mm (3 3⁄8 × 4 1⁄2 × 1 1⁄8 inches)
excl. projecting parts and controls
Note
• Mass
1 Press FM or AM to select the desired band
The battery life may be shorter depending on the operating
condition, the surrounding temperature and battery type.
Approx. 130 g (4.6 oz) (main unit only)
• Supplied accessories
Stereo headphones or Stereo earphones (1)
Carrying case with belt clip or Carrying pouch (1)
Notes
and to turn on the radio.
•If the sound is distorted with the mode “MB”, turn
down the volume or select normal mode.
•Bass emphasis may not show great effect if the volume
is turned up too high.
2 Press and hold ENTER for more than 3
seconds.
Design and specifications are subject to change without
notice.
Preset number 1 will flash in the display
and the Walkman starts scanning the
stations from the lower frequencies and
stops for about 5 seconds when a station is
received.
Protecting Your Hearing—AVLS
(Automatic Volume Limiter System)
Press MENU repeatedly to set the cursor to AVLS in
the display. Then press SET to show “ ”.
The maximum volume is kept down to protect your
ears.
3 If you wish to preset the currently received
station, press ENTER while the preset
number is flashing.
The received station is preset on preset
number 1 and the unit starts scanning for
the next receivable station.
4 Repeat step 3 until all receivable stations are
preset.
To stop scanning
Press RADIO OFF. The radio is turned off at the
same time.
Notes
•If stations are already stored, the newly preset stations
replace the old ones when the above procedure is
completed.
•If stations cannot be preset automatically, preset them
manually.
|