Sony S2 Sports Walkman WM FS233 User Manual

2-585-049-11 (1)  
Owner’s Record  
Troubleshooting  
The model number is located on the front and the  
serial number is located inside the cassette lid.  
Record these numbers in the space provided below.  
Refer to them whenever you call upon your Sony  
dealer regarding this product.  
Model No. WM-FS233  
Serial No. __________________  
“WALKMAN” is a registered trademark of Sony Corporation to  
represent Headphone Stereo products.  
The display shows incorrect information.  
• The battery is weak. Replace the battery with a new one.  
Radio  
Cassette Player  
is a registered trademark of Sony  
Corporation.  
The display and the operation are not normal.  
• Remove the battery for 30 seconds or more, and then insert it  
again. If this does not solve the problem, remove the battery  
and leave the unit without battery for 30 minutes or more, and  
then insert it again. In this case, preset the stations again, since  
the preset stations are erased from the memory.  
Product registration  
For the customers in the USA  
Please register this product on line at www.sony.com/  
productregistration.  
Operating Instructions  
The cassette lid cannot be opened.  
INFORMATION  
You are cautioned that any changes or modifications not  
expressly approved in this manual could void your authority to  
operate this equipment.  
<http://www.sony.com/productregistration>  
• Open the rubber cap, then open the cassette lid. When the  
cassette lid opens, remember to close the rubber cap to  
prevent intrusion of water.  
Proper registration will enable us to send you periodic mailings  
about new products, services, and other important  
announcements. Registering your product will also allow us to  
contact you in the unlikely event that the product needs  
adjustment or modification. Thank you.  
If you have any questions about this product, you may call;  
Sony Customer Information Services Center 1-800-222-7669  
Preparations  
To use the arm belt A  
Declaration of Conformity  
Trade Name:  
Model No.:  
Responsible Party: Sony Electronics Inc.  
SONY  
WM-FS233  
1 Pass the belt through another side of arm  
belt clip.  
Address:  
16450 W. Bernardo Dr, San Diego,  
CA 92127 USA  
858-942-2230  
2 Slide the arm belt clip into the slot at the  
rear of the Walkman to lock it.  
Telephone No.:  
WM-FS233  
This device complies with Part 15 of the FCC Rules.  
Operation is subject to the following two conditions: (1) This  
device may not cause harmful interference, and (2) this  
device must accept any interference received, including  
interference that may cause undesired operation.  
3 Wear the arm belt on your arm, then  
© 2005 Sony Corporation Printed in China  
tighten and tape it to fit your arm.  
To vary the length of the arm belt to fit  
your arm B  
Move the velcro fastener to the proper  
position.  
A
Precautions  
Arm belt  
Arm belt clip  
On battery  
To remove the arm belt from the  
Walkman  
• Do not carry dry batteries with coins or other metallic objects.  
It can generate heat if the positive and negative terminals of  
the batteries are accidentally contacted by a metallic object.  
• When you are not going to use the Walkman for a long time,  
remove the battery to avoid any damage caused by battery  
leakage and subsequent corrosion.  
While pulling “LIFT RELEASE” of the arm  
belt clip, slide to remove it.  
To use the belt clip C  
On handling  
• Do not leave the unit in a location near heat sources, or in a  
place subject to direct sunlight, excessive dust or sand,  
moisture, rain, mechanical shock, or in a car with its windows  
closed.  
• We do not recommend the use of tape longer than 90 minutes.  
They are very thin and tend to be stretched easily. This may  
cause malfunction of the unit or sound deterioration.  
• The LCD display may become hard to see or slow down when  
using the unit at high temperatures (above 40°C/104°F) or at  
low temperatures (below 0°C/32°F). At room temperature, the  
display will return to its normal operating condition.  
• If the unit has not been used for a long time, set it in the  
playback mode to warm it up for a few minutes before you  
start using again.  
1 Slide the belt clip into the slot at the rear of  
the Walkman to lock it.  
B
C
2 Use the belt clip to attach the Walkman to  
your belt.  
To remove the belt clip from the  
Walkman  
While pulling “LIFT RELEASE” of the belt  
clip, slide to remove it.  
On water resistance  
To insert a battery D  
• Before opening or closing the cassette lid, be sure to wipe off  
water, dust or sand on the exterior of the Walkman. (The  
Walkman is not water-resistant with the cassette lid open.)  
• Since water in the headphones/earphones jack may cause  
rust, cover it with the attached rubber cap when the  
headphones/earphones are not in use.  
• Since the Walkman is airtight, you may not be able to open the  
cassette lid because of sudden change in air pressure inside  
the Walkman, which happens after being transported on a  
plane or moving from a warm place to a cold place. To open  
the cassette lid see “Troubleshooting”.  
1 Unfasten the buckle.  
2 Open the cassette lid.  
3 Release the catch to open the battery  
compartment lid and insert one size AA  
(R6) dry battery with correct polarity.  
• The supplied headphones/earphones are not meant to be  
immersed in water or come in continuous contact with water.  
If they are accidentally dropped into water or get wet, dry  
them with a soft cloth. Never use an electric hair dryer.  
• If the Walkman or the headphones/earphones are immersed  
in salt water, be sure to wash them in non-running fresh water.  
Never wash them under running water, and never use soap or  
detergent.  
• Any sand or dust on the rubber packing will prevent the  
cassette lid from closing tightly, and water may leak in. Brush  
off the dust once in a while.  
• We recommend the packing to be changed every year.  
Replacement packing is available at an authorized Sony  
Service Facility.  
When to replace the battery D  
Replace the battery with the new one when “  
flashes on the display.  
Belt clip  
D
To replace the battery  
1 Release the catch to open the battery  
compartment lid.  
2 Pull the ribbon up slowly and replace the  
battery with new one.  
On headphones/earphones  
Road safety  
Using the supplied  
headphones  
Do not use headphones/earphones while driving, cycling, or  
operating any motorized vehicle. It may create a traffic hazard  
and is illegal in some areas. It can also be potentially dangerous  
to play your headphones/earphones at high volume while  
walking, especially at pedestrian crossings.  
E
Wearing the headphones  
You should exercise extreme caution or discontinue use in  
potentially hazardous situations.  
The following procedures are for wearing on the left  
ear. E  
Preventing hearing damage  
Do not use headphones/earphones at high volume. Hearing  
experts advise against continuous, loud and extended play. If  
you experience a ringing in your ears, reduce volume or  
discontinue use.  
1 Hook the L part over your left ear and the  
R part over your right ear as illustrated.  
2 Hook the headphones around your ears, as  
Caring for others  
Keep the volume to a moderate level. This will allow you to hear  
outside sounds and to be considerate to the people around you.  
you would with glasses.  
3 Adjust the earpieces to comfortably fit your  
ears.  
On maintenance  
• Clean the tape head and tape path using a cotton swab and  
commercially available cleaning solvent after every 10 hours  
of use.  
• To clean the exterior, use a soft cloth slightly moistened in  
water. Do not use alcohol, benzine or thinner.  
• Clean the headphones/earphones plugs periodically.  
Notes on handling the supplied headphones  
Avoid rough handling or mechanical shock.  
Be particularly careful of the headphone part.  
Do not put force or weight on the unit for a long time  
as that may damage or deform the unit.  
Do not leave the unit in a location subject to moisture,  
dust, smoke, steam or direct sunlight.  
Clean the plug with a soft dry cloth. A dirty plug may  
cause the sound quality to deteriorate.  
Clean the headphone part with a soft dry cloth.  
After you use the headphones, keep them with the  
cord slider positioned high to avoid entangling the  
cord.  
(turn over)  

Yorkville Sound Car Speaker LS1004 User Manual
Vizio 3D BLU RAY VBR334 User Manual
Vista Davis &amp; Sanford ATPG User Manual
Tokina MOTORIZED ZOOM LENS TM7Z0614GAIDC User Manual
Sony PS User Manual
Sony CDXGT620U User Manual
Sony Camcorder EX780SP User Manual
Sony Bluetooth Headset Bluetooth Audio System User Manual
Siemens Camera Accessories 6DS2 510 0xx00 0xa0 User Manual
Sharp XE A22S Cash Register XE A22S User Manual