Thank you for purchasing the SXV200V1 SiriusXM Connect Vehicle Tuner Kit.
Route the Antenna Cable
Install the Magnetic Mount Antenna
Make the Connections
Secure the Tuner
Secure the SXV200 Vehicle Tuner behind the vehicle headunit location or
under the dash using wire ties (not included).
Subscribe
If you are installing the antenna at the edge of the roof or hood, install the
Antenna Cable Routing Adapter to direct the
cable downward. Place the antenna cable
into the groove of the adapter and slide the
adapter down the cable until the adapter is
flush with the bottom of the antenna.
This kit comes with everything you need to add Satellite Radio to your
SiriusXM-Ready headunit. Consult your headunit User Guide for features and
detailed operational instructions.
Proper placement of the Magnetic Mount Antenna is very important. Consult
a professional installer if you are uncomfortable with installing the antenna
yourself. More detailed installation instructions and illustrations can be found at
You’ll need to access the back of the SiriusXM-Ready headunit so you can
plug the SXV200 Vehicle Tuner into it. This may require you to remove
the headunit from the dashboard. If you are uncomfortable with this step,
consult a professional installer.
Once the SXV200 Vehicle Tuner begins receiving the satellite signal, a
courtesy period is initiated that allows you to tune to channels and listen to
SiriusXM Radio programming for up to 5 days.
Thread the wire ties through the molded brackets on the underside of the
Tuner as shown. Then secure it to a bracket or wiring harness using the wire
ties. Avoid brackets with sharp edges and any moving parts such as gas and
brake pedals.
You can subscribe to the SiriusXM service anytime by following these steps:
• Locate the Magnetic Mount Antenna on the
outside of your vehicle on a horizontal surface
that always faces the sky.
Be sure to turn OFF the SiriusXM-Ready headunit before connecting the
SXV200 Vehicle Tuner. Locate the SiriusXM connector on the headunit and
connect the SXV200. The headunit may have a panel mount type connector,
or it may have a pigtail type connector.
1
Make sure your vehicle headunit is turned on and that Satellite Radio is
selected. Verify that you are receiving the SiriusXM signal so that you
can hear the SiriusXM audio.
What’s In the Box?
The SXV200V1 kit includes the following:
Use care when routing the antenna cable into and through the vehicle
interior, avoiding sharp objects that can damage the cable. Keep the antenna
cable away from moving parts such as gas and brake pedals, trunk and door
hinges, and sliding seat brackets.
• Avoid placing the antenna near obstacles that
could block a clear view of the sky (such as
roof racks, other antennas like AM/FM, cellular,
and GPS), preventing the satellite signal from
reaching the antenna.
SXV2TU
0
NE
0R
2
Make a note of your Radio ID. You can find it on channel 0, on a label on
the bottom of the packaging, and on the label on the bottom of your
SXV200 Vehicle Tuner.
VEHICLE
Antenna Cable
Routing Adapter
NOTE! The Radio ID does not use the letters I, O, S, or F.
Activate your service:
3
Select the Best Location for the Magnetic Mount Antenna
Connector
Hide the antenna wire inside the vehicle cabin by routing the cable under the
carpet and behind plastic trim, toward the headunit location. Coil and secure
any excess cable in a hidden location, such as under the carpet, using wire
ties (not included).
orientation
Alcohol
For most vehicles the best location is on the roof,
centered above the rear window or front windshield.
Consult a professional installer to find an alternate
antenna mounting location if your vehicle roof is made
from a non-magnetic material such as aluminum,
fiberglass, or carbon fibre.
• First see our Customer Agreement for complete terms at
Prep Pad
may vary
PANEL MOUNT
TYPE CONNECTOR
OR
CAUTION! Do not kink or sharply fold the antenna cable.
Alcohol Prep
Pad
PIGTAIL TYPE
To disconnect,
CONNECTOR
1. Feed cable under
• By phone: Call 1-866-635-2349
2. Route cable out of window
slide lock back
rubber moulding
around window.
moulding and into weather-
• Sedan or Coupe: Recommended mounting location
is above the rear window or front windshield.
4
5
Activation usually takes 10 to 15 minutes, but may take up to an hour.
We recommend that your vehicle headunit remain on until subscribed.
When your service is activated, you will see the SUBSCRIPTION
UPDATED, PRESS ENTER TO CONTINUE or similar message displayed
on the headunit. Once subscribed, you can tune to channels in your
subscription plan.
stripping around trunk opening.
SXV200 Vehicle Tuner
Magnetic Mount Antenna
• Pickup or SUV: Recommended mounting location is
above the front windshield.
Check Your Headunit For Compatibility
If your headunit has the official SiriusXM-
Ready logo it is compatible with the
SXV200 Vehicle Tuner. All SiriusXM-
Ready headunits include a dedicated
connector, allowing for quick and easy
connection of the SXV200 tuner.
5. Bring cable out from trim and
route under carpet and behind
the dash to the headunit. Coil
and secure excess cable under
carpet or behind dash.
• Convertible: Recommended mounting location is
above the front windshield, or alternately on the
trunk lid, on the front hood, or on top of the front
fender.
Products with this logo are compatible
Plug the Magnetic Mount Antenna
into the SXV200 Vehicle Tuner.
3. Route cable along trunk
wall and into cabin.
Activation signals can be sent again at any time by visiting
Reinstall the vehicle headunit if it had been removed from the dashboard.
4. Route cable from trunk under interior trim,
Products with these logos are not compatible
into cabin and towards front of vehicle.
1
2
3
4
5
6
|