Register your product and get support at
CID3292
1
2
a
b
c
Yellow
Yellow
Rear display
Rear display
Yellow
Green
Blue
Radio antenna
Yellow
GPS antenna
c
Connect to the positive (+) terminal of
reverse driving light
Optional accessory
Gearbox
ENG
Quick Start Guide
d
AV system
AUX
AV system
AUX
Amplifier
Remark:
Connect the AV IN wire which is marked as cto the AV IN socket on front panel.
English
3 Enter default password “0000”.
Receive call
By default, all incoming calls are received
automatically.
3
Play disc
Set date and time
1 Press MENU.
Adjust screen
To turn off the screen
»
if pairing succeeds. phone call record is
3
You can play video, audio or images stored on the
following discs:
ꢀ DVD video, DVD-R, DVD-RW
ꢀ VCD
displayed.
1
Install the car audio
»
The main menu is displayed.
1 Press DISP for over 2 seconds
1 If there is incoming call, [Incoming call...]
ÁDVKHVꢀRQꢀWKHꢀVFUHHQꢁꢀ6SHDNꢀLQWRꢀWKHꢀ
Bluetooth microphone.
To adjust screen brightness
1 Press DISP.
1 If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
ꢀ Audio CD, CD-R, CD-RW
2 Rotate VOL to adjust brightness.
1 Insert the disc into the disc slot with label
2 Take out the original car audio and keep
side facing up.
the screws.
»
»
Play starts automatically.
Use map
3 Mount the supplied mounting brackets
To remove the disc, press the button.
a
onto the unit with the supplied screws.
Note
2
4 Connect wires
.
Make a call
2 Tap [Settings].
5 Take off the two screws on the top side of
You may need to upgrade the map (sold
separately) before using it (see “Upgrade the
map” section)
4
Connect USB device
1 Pair the phone with the unit.
2 Tap to display the home menu.
3 Tap [Bluetooth].
b
the unit.
3 Tap [Time].
2 When conversation ends, tap
(red) to
1 Open the USB door.
6 Slide the unit into the dashboard until a
»
The date/time setup menu is displayed.
terminate the call.
c
click sound is heard.
2 Insert the USB device to the USB socket.
1 Tap the upper left corner to display home
»
The Bluetooth menu is displayed.
7 Fix the unit onto the dashboard with
»
Play starts automatically.
menu.
d
screws.
2 Tap [Navigation].
Note
8 Reconnect the negative terminal of the car
»
The navigation menu is displayed in a
few seconds.
battery.
To remove the USB device, switch to disc,
UDGLRꢀRUꢀRWKHUꢀVRXUFHꢀÀUVWꢁ
3 Refer to the map manual to operate the
4
navigation tool.
Turn on
Set date
Play with Bluetooth device
Caution
1 Tap [Date].
Listen to Radio
4 Tap or to select the paired phone, then
2 Tap the displayed date information.
Risk of road accidents! Never watch video or
adjust settings while you drive.
tap
.
1 Tap to display home menu.
Pair the Bluetooth-enabled devices
To connect your Bluetooth device to the unit, you
need to pair the device to the unit. Pairing needs
only to be done once.
»
A submenu is displayed.
5 Tap or to search for phone number
2 Tap [Radio].
3 Tap or to set year, month and day.
1 Press to turn on the unit.
from the following list:
»
Band and frequency information is
displayed.
Set time mode
»
The available OSD (On-Screen Display)
languages are displayed.
1 Tap [Time mode].
You can pair up to eight devices.
2 Tap [12H] or [24H] to select time mode.
1 Search for Bluetooth device with the device.
Set time
2 Select “CID3292” in the pairing list.
1 Tap [Time].
2 Tap the displayed time.
»
A submenu is displayed.
3 Tap or to set hour and minute.
Or tap to dial number directly, then tap
to dial.
3 Tap on FM or AM to select band:
2 Tap a language.
© 2010 Koninklijke Philips Electronics N.V.
All rights reserved.
4ꢀ %ULHÁ\ꢀWDSꢀ or to tune to a radio station
»
The OSD language is changed to the
by step.
selected language immediately.
CID3292_00_QSG_V2.0
CID3292_00_QSG_V2.0.indd
1
6/4/2010 4:18:58 PM
|