Please read this document before using the product, and save this document for future
reference.
Panasonic Network Camera Website:
Important Information
Network Camera (PoE Ready)
Indoor Use Only
Model No.
BB-HCM527
Outdoor Ready
BB-HCM547
14. Refer all servicing to qualified service personnel. Servicing is required
when the unit has been damaged in any way, such as when the AC
adaptor, the AC adaptor cord, or the AC cord is damaged, the unit
does not operate normally, or has been dropped.
15. Prolonged exposure to direct sunlight or halogen light may damage
the image sensor.
16. For BB-HCM527: The camera is intended for indoor use only.
For BB-HCM547: The camera features a splash-resistant body, but it
is not waterproof.
17. Keep the SD memory card (customer-provided) out of reach of
children to prevent swallowing.
18. Unplug this unit from power supply if it emits smoke, an abnormal
smell or makes unusual noise. These conditions can cause fire or
electric shock. Confirm that smoke has stopped and contact an
authorized service center.
19. The AC adaptor, the AC adaptor cord, and the AC cord are not splash
resistant, and are intended for indoor use only.
20. When installing cables through the ground, do not connect cables
under the ground. Install cables through a conduit to protect them from
water.
How to Use the Documentation
This manual is written for both the BB-HCM527 (Indoor Use Only) and the
BB-HCM547(Outdoor Ready). Available features and operations vary
slightly depending on the model. You can confirm the model no. of your
camera by checking the model no. printed on the front of the camera.
Model number suffix “A” is omitted from the following model numbers
shown in this document, unless necessary. BB-HCM527A, BB-HCM547A
All documentation can be found on the included CD-ROM.
• Important Information (PDF format; printed version also included)
This document. Provides general information and safety instructions for
using the camera.
• Installation Guide (PDF format; printed version also included)
For BB-HCM527: Describes how to physically connect the camera to
the power supply and network, as well how to mount or place the
camera for regular use.
For BB-HCM547: Describes how to connect the camera to the power
supply and network physically.
• Mounting Guide (PDF format; printed version also included)
For BB-HCM547: Describes how to mount or place the camera for
regular use.
• Setup Guide (PDF format; printed version also included)
Describes how to set up the camera so that it can be accessed using a
PC.
• Operating Instructions (HTML format)
Explains how to operate, program, and maintain the camera.
• Troubleshooting Guide (HTML format)
SAVE THESE INSTRUCTIONS
FCC and Other Information
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Provides solutions for problems you may have when using the camera.
• Stand-alone SD Memory Card Recording Guide (PDF format; printed
version also included)
Describes how to record images to an SD memory card without using a
PC.
Abbreviations
• The Network Camera is referred to as “the camera” in this document.
• The Setup CD-ROM is referred to as “the CD-ROM” in this document.
• The term “SD memory card” is used in this document to refer to SD
memory cards and SDHC memory cards.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
IMPORTANT SAFETY INSTRUCTIONS
When using this unit, basic safety precautions should always be followed
to reduce the risk of fire, electric shock, or personal injury.
Note:
• References to the AC adaptor and the AC cord apply when using the
optional BB-HCA3A AC Adaptor.
Environment:
For BB-HCM527: Do not install the camera where the temperature is less
than +0 °C (+32 °F) or greater than +40 °C (+104 °F). Allow 10 cm
(4 inches) clearance around the unit for proper ventilation. Avoid excessive
smoke, dust, mechanical vibration, shock, or direct sunlight.
For BB-HCM547: Do not install the camera where the temperature is less
than -20 °C (-4 °F) or greater than +50 °C (+122 °F). Allow 10 cm (4 inches)
clearance around the unit for proper ventilation. Avoid excessive smoke,
dust, mechanical vibration, shock, or direct sunlight.
1. Read and understand all instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Attach the Safety Wire to the camera to prevent it from dropping.
6. After taking away the sand or the dust on the lens cover, wipe the lens
cover with a dry cloth.
7. Do not block any ventilation openings. Install in accordance with
instructions.
8. Do not install near any heat sources such as radiators, heat registers,
stoves, or other devices (including amplifiers) that produce heat.
9. Protect the AC adaptor cord and the AC cord from being walked on or
pinched particularly at plugs, convenience receptacles, and the point
where they exit from the unit.
Routine care:
Wipe the unit with a soft cloth. Do not use benzine, thinner, or any abrasive
powder.
When you leave the unit unused for a long period of time, disconnect the
LAN cable (when using PoE) from the camera, or disconnect the AC
adaptor from the outlet (when using the AC adaptor).
If you have any problems:
Consult an authorized Panasonic Factory Service Center.
CAUTION:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this device.
10. The AC adaptor is used as the main disconnect device. Ensure that
the AC outlet is installed near the product and is easily accessible.
11. Only use attachments/accessories such as stand specified by the
manufacturer.
12. Do not touch the unit, the LAN cable, the AC adaptor, the AC adaptor
cord, or the AC cord during lightning storms.
13. Unplug the unit from power supply when unused for long periods of
time.
No responsibility will be taken by our company with respect to
consequences resulting from the use, damage or both of the
camera.
© 2008 Panasonic Communications Co., Ltd. All Rights Reserved.
PQQX16398ZA KK0608CM0
|