Optimus 12 1717 User Manual

12-1717.fm Page 1 Monday, July 12, 1999 9:26 AM  
Cat. No.  
12-1717  
Three-Way Flush-  
Mount Car Speakers  
WIRING THE  
SPEAKERS  
Your Optimus Three-Way Flush-  
Mount Car Speakers provide clean  
sound and each speaker can handle  
up to 30 watts. The panel-mount de-  
sign lets you easily mount the speak-  
ers so that they are flush with the  
mounting surface. To get the best  
sound from your speakers, read this  
entire manual carefully for the proper  
wiring and mounting procedure.  
All RadioShack autosound systems  
come with four color coded speaker  
wires. The following chart shows Ra-  
dioShack’s standard color codes.  
Speaker Terminal  
Left Positive (+)  
Wire Color  
Green  
Left Negative (–)  
Right Positive (+)  
Right Negative (–)  
White  
Brown  
Gray  
BEFORE YOU BEGIN  
Connect your stereo’s speaker wires  
to the speakers, using the color-code  
chart as a guide. Then, turn on your  
stereo to be sure that you properly  
connected the speakers.  
We recommend that you wire the  
speakers to your sound system before  
you mount the speakers so that you  
can test the speakers and the wire  
connections. Then, disconnect the  
wires, route the wires, and mount the  
speakers.  
Note: Other autosound systems are  
also equipped with four wires but the  
wires might not use the same color  
codes. If your autosound system is a  
brand other than Radio Shack, check  
the owner’s manual for the speaker  
wire color codes.  
Note: If you are unsure about wiring  
or mounting, we suggest you have a  
professional install the speakers.  
Caution: Do not connect any of your  
speaker wires to the chassis ground.  
Use all four wires to connect the  
speakers to your vehicle’s auto sound  
system.  
© 1997 Tandy Corporation.  
All Rights Reserved.  
Optimus and RadioShack are registered trademarks used by Tandy Corporation.  
12-1717.fm Page 3 Monday, July 12, 1999 9:26 AM  
3. Drill a starter hole inside the out-  
lined area. Carefully remove the  
area you marked, using a razor,  
tin snip, or a hacksaw blade.  
6. Replace the door panel. Then,  
pull the wires through the hole you  
made for the speaker and connect  
the wires to the speaker’s termi-  
nals. See “Wiring the Speakers.”  
4. Drill three 1/8-inch mounting holes.  
7. Mount the speaker as needed.  
• If you mount the speaker on a  
metal surface, align the mount-  
ing holes on the speaker with  
the three drilled holes and  
secure the speaker with the  
supplied screws.  
• If you mount the speaker on a  
non-metal surface, insert the  
three supplied speed clips into  
the mounting holes to ensure a  
firm mount and to protect the  
mounting holes. Then align the  
mounting holes on the speaker  
with the three drilled holes and  
secure the speaker with the  
supplied screws.  
5. Disconnect the wires from the  
speakers and route them from  
your sound system through the  
door sill and to the speaker’s  
mounting location. You might  
need to drill a hole to route the  
wire through the door sill. Some  
cars have predrilled holes and  
rubber tubes for routing wires.  
Cautions:  
8. Align the speaker grille with the  
speaker and press it onto the  
speaker until it snaps into place.  
• Be sure you allow enough slack  
in the wire to prevent pulling the  
wire front he speaker when you  
open the door all the way.  
Tape any exposed wire to pre-  
vent the wire from being  
pinched or cut when the door is  
closed.  
3
12-1717.fm Page 4 Monday, July 12, 1999 9:26 AM  
SPECIFICATIONS  
Woofer ........................................................................................................ 51/4 Inch  
Midrange ........................................................................................................ 2 Inch  
Piezo Tweeter ................................................................................................ 1 Inch  
Magnet Weight............................................................................17.72 oz (502.65 g)  
Power-Handling Capability ............................................................... 30 Watts Each  
Impedance .................................................................................................. 4 Ohms  
Frequency Response .................................................................. 70 Hz–20,000 Hz  
Sensitivity .................................................................................. 90 dB 1 Watt 50cm  
Specifications are typical; individual units might vary. Specifications are subject to  
change and improvement without notice.  
Limited Ninety-Day Warranty  
This product is warranted by RadioShack against manufacturing defects in material and workmanship under normal use  
for ninety (90) days from the date of purchase from RadioShack company-owned stores and authorized RadioShack fran-  
chisees and dealers. EXCEPT AS PROVIDED HEREIN, RadioShack MAKES NO EXPRESS WARRANTIES AND ANY  
IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE,  
ARE LIMITED IN DURATION TO THE DURATION OF THE WRITTEN LIMITED WARRANTIES CONTAINED HEREIN.  
EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO CUSTOMER OR  
ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR  
INDIRECTLY BY USE OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WAR-  
RANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE, LOSS OF TIME,  
DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAM-  
AGES, EVEN IF RadioShack HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.  
Some states do not allow the limitations on how long an implied warranty lasts or the exclusion of incidental or consequen-  
tial damages, so the above limitations or exclusions may not apply to you.  
In the event of a product defect during the warranty period, take the product and the RadioShack sales receipt as proof of  
purchase date to any RadioShack store. RadioShack will, at its option, unless otherwise provided by law: (a) correct the  
defect by product repair without charge for parts and labor; (b) replace the product with one of the same or similar design;  
or (c) refund the purchase price. All replaced parts and products, and products on which a refund is made, become the  
property of RadioShack. New or reconditioned parts and products may be used in the performance of warranty service.  
Repaired or replaced parts and products are warranted for the remainder of the original warranty period. You will be  
charged for repair or replacement of the product made after the expiration of the warranty period.  
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse, accident, misuse, im-  
proper or abnormal usage, failure to follow instructions, improper installation or maintenance, alteration, lightning or other  
incidence of excess voltage or current; (b) any repairs other than those provided by a RadioShack Authorized Service Fa-  
cility; (c) consumables such as fuses or batteries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or  
(f) costs of product removal, installation, set-up service adjustment or reinstallation.  
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.  
RadioShack Customer Relations, Dept. W, 100 Throckmorton St., Suite 600, Fort Worth, TX 76102  
3/97  
We Service What We Sell  
RadioShack  
A Division of Tandy Corporation  
Fort Worth, Texas 76102  
9A7  
Printed in China  

PYLE Audio PLD 131F User Manual
Profile Car Stereo System CD7200 User Manual
Philips VKR 6843 User Manual
Philips 225BI User Manual
Pelco Boiler MPTV1510 User Manual
Panasonic NV DS60EG User Manual
Oster 133086 User Manual
Orion Car Audio FARAD ORC1D User Manual
Olympus TCON 14D User Manual
Manfrotto ART 055XPROB User Manual