®
DK Elektronisk vinkøleskab......................................................2
UK Electronic wine cooler ........................................................4
758-039
Is indvendig på bagvæggen:
GARANTIEN GÆLDER IKKE
•
Normalt skal vinkøleskabet ikke afrimes, men hvis f. eks
pakningen er defekt, lågen har stået åben for længe,
eller indholdet har været for varmt kan der dannes is på
bagvæggen hvis den får en tykkelse på 3-5 mm er det
nødvendigt med en manuel afrimning.
1.
2.
Hvis ovennævnte ikke iagttages.
Hvis apparatet har været misligholdt, været udsat for
vold, eller lidt anden form for overlast.
Hvis der har været foretaget uautoriserede indgreb i
apparatet.
3.
4.
Fejl som måtte opstå grundet fejl på ledningsnettet.
•
•
•
•
Set termostaten på stop, lad lågen stå åben såedes
isen smelter.
Vi tager forbehold for trykfejl.
Afrim ikke vinkøleskabet med andre elektriske apparater
f. eks en hårtørrer e.l.
IMPORTØR:
Adexi group
Forsøg heller ikke at skrabe is af med skarpe
genstande.
Efter endt afrimning sættes termostaten igen på den
ønskede temperatur.
FABRIKSINDSTILLING
Programmering til fabriksindstilling.
•
•
Tryk og hold WHITE tasten inde, derefter straks
(indenfor ét sekund) på RED tasten, disse holdes inde i
ca. 10 sekunder til der høres et beep, herefter er
indstillingerne tilbage til fabriksindstilling.
Dette kan være nyttigt i forbindelse med fejlfinding på
vinkøleskabet.
UDSKIFTNING AF PÆRE I VINKØLESKABET
•
•
Tag stikket ud af stikkontakten.
Løsn skruen der holder beskyttelsesglasset under
pæren og fjern dette.
•
Skift pæren, og sæt beskyttelsesglasset på igen.
RENGØRING AF VINKØLESKABET
•
Sluk for vinkøleskabet, og tag stikket ud af
stikkontakten inden rengøring.
•
Du må ikke bruge skurepulver, stålsvampe eller andre
stærke rengøringsmidler til rengøring af vinkøleskabets
indvendige og udvendige overflader, da disse
rengøringsmidler kan ridse fladerne.
•
Brug i stedet en klud fugtet med varmt vand, og tilsæt
eventuelt lidt opvaskemiddel, hvis vinkøleskabet er
meget beskidt.
•
•
Til indvendig rengøring kan der tilsættes en smule
eddike.
Plasticdele må ikke vaskes i opvaskemaskine
REPARATION
Reparation skal foretages af et autoriseret værksted.
MILJØTIPS
Et el/elektronik produkt bør, når det ikke længere er
funktionsdygtigt, bortskaffes med mindst mulig
miljøbelastning. Apparatet skal bortskaffes efter de lokale
regler i din kommune, men i de fleste tilfælde kan du komme
af med produktet på din lokale genbrugsstation
3
UK
INTRODUCTION
MANUAL TEMPERATURE SETTING
Please read this instruction manual carefully and familiarise
yourself with your new wine cooler, before using the first time.
Please retain this manual for future reference.
•
If you require a different temperature, use the up and
down arrow buttons as follows. (Possible temperature
settings range from 4° C to 18° C.)
•
•
Press and hold the SET button until you hear a beep
(around 15 seconds).
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions
should always be followed to reduce the risk of fire, electric
shock and/or personal injury, including the following:
Press the up or down arrow to set the temperature you
want; each time you press, the temperature changes
one degree.
-
Check that the voltage of your appliance corresponds
with the mains voltage of your home. The appliance is
fitted with an earth for extra safety.
•
•
Once the temperature you want appears in the display,
press SET to confirm the selected temperature. After
you have set the temperature manually, the indicators
for both RED and WHITE will disappear.
-
-
Read all instructions before using.
To protect against fire, electric shock and personal
injury, do not immerse cord, plug in water or other
liquid.
Please note: The selected temperature must be
confirmed within 10 seconds, otherwise you must start
again from the beginning.
-
Do not operate with a damaged cord or plug. There are
no user serviceable parts.
NOTE
-
-
Do not use outdoors.
The indicator light on the wine refrigerator has 3 functions
Do not place on or near a hot gas or electric burner or
in a heated oven.
1.
2.
It begins to flash just before the compressor starts up.
-
-
Do not use this appliance for other than intended
household use.
It stays on when the wine refrigerator is in cooling
mode.
Remove plug by grasping plug body and pulling it from
the outlet. Never yank or twist the cord.
3.
It goes off when the compressor is not running.
ENERGY-SAVING TIPS
NOTE
•
•
•
•
Avoid opening the door unnecessarily, particularly when
it is warm and humid.
Supplier will accept no responsibility for any damage to the
content, arising as a result of fault or other malfunction of this
unit.
When you do open the door, close it again as soon as
possible.
Ensure there is plenty of air circulation behind the wine
refrigerator.
BEFORE USE
Remove the transport securings before using the device.
If ice forms inside the cabinet, energy consumption will
increase, so you should remove it once it is 3-5 mm
thick.
Before connecting your wine refrigerator following
transportation, leave it to stand for 2 hours in order to avoid
problems in the refrigeration system.
•
If the door seal is damaged, it must be replaced.
AUTOMATIC DEFROSTING
INSTALLATION AND POSITIONING OF THE WINE
REFRIGERATOR
•
It is not necessary to defrost the wine refrigerator, as
this happens automatically.
•
•
•
The wine refrigerator must be placed on a firm, level
surface (some models have adjustable legs) in a dry
and well-ventilated room.
•
When the compressor is running, ice may form on the
rear wall. This ice will be defrosted and the water will be
conducted away to a container above the compressor,
from where it will simply evaporate.
Do not place the wine refrigerator near to heat sources
such as hotplates, radiators or water heaters, or in
direct sunlight.
TROUBLESHOOTING THE WINE REFRIGERATOR
Ensure there is air around the wine refrigerator
The wine refrigerator will not cool:
•
Check the plug is in the wall and that it is switched on
at the wall.
The wine refrigerator has two fixed temperatures, one for red
wine and one for white wine.
•
•
Check that the fuse / HFI relay is OK.
Press the RED button for a temperature of 13°C in the wine
refrigerator, or press the WHITE button for a temperature of
8°C. These fixed temperatures cannot be altered.
Check that the wine refrigerator is switched on.
When you press either the RED or the WHITE button, the
storage temperature for the relevant wine type will appear on
the display for a few seconds, following which the display will
return to showing the current temperature inside the wine
refrigerator.
4
The compressor of the wine refrigerator is running all the
time:
REPAIRS
•
Any repairs must be carried out by an authorised
•
•
•
The door is often open or is open for long periods.
workshop.
The door is not fully shut, or the seal is damaged.
4 sets 35 pieces ENVIRONMENTAL TIP
The wine refrigerator is overfull, or the compressor is
inadequately ventilated.
•
An electronic appliance should, when it is no longer
capable of functioning be disposed with least possible
environmental damage. The appliance should be
disposed according to the local regulations in your
municipality, in most cases you can discharge the
appliance at your local recycling center.
Ice on the inside of the rear wall:
•
The wine refrigerator does not normally need defrosting,
but if, for example, the seal is defective, the door has
stood open for a long period, or the contents were too
warm, ice may form on the rear wall. If it reaches a
thickness of 3-5 mm, manual defrosting is necessary.
THE WARRENTY DO NOT COVER
•
•
If the above points have not been observed.
•
•
Set the thermostat to stop, and leave the door open so
the ice melts.
If the appliance has not been properly maintained, if
force has been used against it or if it has been
damaged in any other way.
Do not use other electrical devices (hair dryer, etc.) to
defrost the wine refrigerator.
•
•
If the appliance has been repaired or modified or
changed in any way or by any person not properly
authorized.
•
•
Do not attempt to scrape ice off using sharp objects.
Once defrosting is complete, set the thermostat back to
the temperature you want.
Errors or faults owing to defects in the distribution
system.
FACTORY SETTING
Programming to factory setting.
We take reservation for printing errors.
Owing to our constant development of our products on both
functionality and design we reserve the right to change the
product without preceding notice.
•
Press and hold the WHITE button, then immediately
(within one second) the RED button, and hold these
down for approximately 10 seconds until you hear a
beep. The settings have now been returned to the
factory setting.
Importer
Adexi group
•
This may be useful when troubleshooting the wine
refrigerator.
CHANGING THE LIGHT BULB IN THE WINE REFRI-
GERATOR
•
•
Remove the plug from the socket.
Loosen the screw holding the protective glass over the
light bulb and remove this.
•
Change the bulb and then replace the protective glass.
CLEANING THE WINE REFRIGERATOR
•
Switch the wine refrigerator off and remove the plug
from the wall socket before cleaning.
•
Never use scouring powder, steel scourers or other
strong cleaning agents to clean the interior or exterior
surfaces of the wine refrigerator, as they may scratch
the surfaces.
•
Instead use a cloth dampened with hot water, and add
detergent if the wine refrigerator is very dirty.
•
•
A little vinegar may be added for cleaning the interior.
The plastic parts are not dishwasher-safe
5
6
|