MAMIYA Interface Plate
To use the KODAK PROFESSIONAL DCS Pro Back or DCS Pro Back Plus (Pro Back/Pro Back Plus)
with the MAMIYA RZ67 PRO II camera body (MAMIYA camera body), you must first attach the
MAMIYA Interface Plate to the camera body.
1. Insert the four studs on the MAMIYA camera body into the four holes on the MAMIYA Interface
Plate.
2. Slide the Lock handle downward to secure the plate to the camera body.
Lock handle
3. Turn the lever on the Cable Release plug to O. (Refer to the picture on page 3.) Insert the plug into the
auxiliary release jack on the front of the RZ67, then turn the lever to L to lock the plug. (When
removing the cable, turn the lever from L to O and pull the plug out.)
lever
P/N 6B5813
1
August 24, 2001
Electromagnetic Cable Release
Orange dot
Long time
lever
Cable Release plug
White dots
Release button
Release Button
The Release button is a two-step position button. Each position provides a different function.
•
•
Lightly press the Release button halfway down to collect photometric data.
Press the button fully down to perform a shutter release.
When the two white dots are aligned, the ring is in the correct position for metering and shutter release.
When taking long time (LT) exposures in Bulb mode, lock the Release button by turning the outer ring
clockwise and aligning the orange dot with the white dot. The Shutter release locks. To disengage a locked
Shutter release, turn the ring counterclockwise and return the orange dot to its original position.
NOTE: We do not recommend Pro Back/Pro Back Plus exposures that exceed 1/4 second shutter times.
P/N 6B5813
3
August 24, 2001
|