KDS-P901
5.1ch DVD SURROUND PROCESSOR
INSTRUCTION MANUAL
PROCESSEUR SURROUND DVD à 5.1 canaux
MODE D’EMPLOI
5.1 Kan. DVD-SURROUND-PROZESSOR
BEDIENUNGSANLEITUNG
5.1 kan DVD-SURROUNDPROCESSOR
GEBRUIKSAANWIJZING
5.1 canale DVD SURROUND PROCESSOR
ISTRUZIONI PER L’USO
PROCESADOR SURROUND DVD de 5.1 canales
MANUAL DE INSTRUCCIONES
5.1 聲道 DVD 環繞音效處理器
使用說明書
5.1 声道 DVD 环绕音效处理器
使用说明书
© PRINTED IN JAPAN B64-1781-00/01 (W)
2CAUTION
When handling an optical cable for wiring, use
care not to exceed the minimum cable bend
radius of 30 mm.
If you exceed the minimum bend limit, optical
fibers within the optical cable may be damaged.
When installing the DVD player unit on the
vehicle, ensure that the optical cable is not
stuck between the DVD player unit and vehicle
parts.
(Green)
(Green)
DIGITAL IN
CD-CH
DIGITAL IN
DVD
1
(front side)
(rear side)
I N P U T
O U T P U T
( A U X )
L
L I N E
R
L
L I N E
R
L
L
2
2
1
1
R E A R
R
F R O N T
R
S U B W
C E N T E R
H
T
L I N E
L I N E
R E A R
F R O N T
30R
Audio cable
(6m:Accessory i)
2CAUTION
Set the PROTOCOL SWITCH to the "BUS" side.
After the PROTOCOL SWITCH is switched, be
sure to reset the control unit.
Don’t connect anything to the "TO OTHER
HEAD UNIT" terminal.
PROTOCOL SWITCH
Receiver unit (rear side)
PREOUT
REAR
TO MONIUNIT
AV INPUT
L
1
2
R
R
VIDEO
VIDEO
FRONT
NON-FAD
FM /AM
ANTENNA
L
L
L
AV OUTPUT
AV INPUT
L
POWER
VIDEO
R
R
R
BUS
OTHER
NOTE
Leave the output terminals on the receiver unit
open.
Optical cable (Provided with the C929)
I N P U T
O U T P U T
( A U X )
KDS-P901 (rear side)
L
L
L
L
L I N E 1
R
L I N E 1
R E A R
R
F R O N T
R
S U B W
L I N E 2
R
R E A R
F R O N T
C E N T E R
L I N E 2
Subwoofer preout
Center Speaker preout
Front left output (white)
Front right output (red)
Rear left output (white)
Rear right output (red)
Left input 1 (white)
Right input 1 (red)
Left input 2 (white)
Right input 2 (red)
English-3
Installation
Connecting Cables to Terminals (Other connections)
NOTE
Leave the output terminals on the
receiver unit open.
PARKING
8mmMAX
DVD receiver unit
(Black)
Connection cable (6m:Accessory u)
Amplifier unit
(Provided with the
DVD receiver unit)
Audio cable (Provided with
the DVD receiver unit)
2CAUTION
Set the PROTOCOL SWITCH to the "OTHER"
side. After the PROTOCOL SWITCH is
switched, be sure to reset the control unit.
The BUS cable unit can’t be connected.
PROTOCOL SWITCH
BUS
OTHER
DVD Receiver unit:
Z910DVD,Z920DVD,KDV-Z930,KDV-Z940,KDV-Z960
4-English
2CAUTION
When handling an optical cable for wiring, use
care not to exceed the minimum cable bend
radius of 30 mm.
Optical cable (6m:Accessory r)
If you exceed the minimum bend limit, optical
fibers within the optical cable may be damaged.
When installing the DVD receiver unit on the
vehicle, ensure that the optical cable is not
stuck between the DVD receiver unit and
vehicle parts.
(Green)
KDS-P901
PROTOCOL SWITCH
BUS
DIGITAL IN
CD-CH
DIGITAL IN
DVD
OTHER
1
(front side)
(rear side)
I N P U T
O U T P U T
( A U X )
L
L I N E
R
L
L I N E
R
L
L
2
2
1
1
R E A R
R
R E A R
F R O N T
R
S U B W
H E A D U N I T
T O O T H E R
H E A D U N I T
T O M Z - B U S
L I N E
L I N E
F R O N T
C E N T E R
30R
NOTE
TO
DSP UNIT
Do not remove the protection
caps of the unused BUS
terminals.
Audio cable
(6m:Accessory i)
Protection cap
I N P U T
( A U X )
O U T P U T
KDS-P901 (rear side)
L
L
L
L
L I N E 1
R
R E A R
R
F R O N T
R
S U B W
L I N E 2
R
L I N E 2
L I N E 1
R E A R
F R O N T
C E N T E R
Subwoofer preout
Center Speaker preout
Front left output (white)
Front right output (red)
Rear left output (white)
Rear right output (red)
Left input 1 (white)
Right input 1 (red)
Left input 2 (white)
Right input 2 (red)
English-5
Installation
Installation
■
Securing to audio board
1
Remove the caution sticker and fasten the
installation brackets on the both sides of the
KDS-P901 using the sems screws (M4 x 8
mm).
Sems bolts
(M4X8mm)
(Accessorye)
Installation
brackets
(Accessoryw)
2CAUTION
Use the supplied screws for installing the
KDS-P901. Using any other screw may
cause the equipment to improperly
function.
Caution sticker
2
Use the tapping screw (ø4X16mm) to secure
the hideaway unit to the audio board.
Tapping screw
(ø4X16mm)
(Accessoryt)
■
Securing to pile carpet
Peel the protective strips off of the velcro strips,
attach them to the bottom of the hideaway unit,
and secure to the pile carpet.
2CAUTION
Please do not install the unit near the
dashboard, the rear tray, or other important
components. Doing so could lead to injury or
accident should the unit come off due to a
shock and strike a person or an important
component.
Tapping screws should be used for mounting.
(Attachment with velcro strips, although easy,
can come off with a shock.)
Velcro strips
(Accessoryy)
6-English
Accessories
External view
......... Number of items
External view
......... Number of items
External view
......... Number of items
r
t
y
u
i
q
w
e
.........1
.........1
.........4
.........2
.........1
.........1
.........2
.........4
2CAUTION
The use of any accessories except for those provided might result in damage to the unit. Make sure
only to use the accessories shipped with the unit, as shown above.
Specification
Specifications subject to change without notice.
DSP section
D/A Converter ...............................................................................................................................................24 Bit
A/D Converter ...............................................................................................................................................24 Bit
Decorder..................................................................................Linear PCM / Dolby Pro Logic / Dolby digital / DTS
Equalizer
4BAND Parametric equalizer
BAND1 frequency : ...........................................60/80/100/120/160/200/250 Hz
BAND2 frequency : ................................................315/400/500/630/800/1k Hz
BAND3 frequency : ...........................................1.25k/1.6k/2k/2.5k/3.15k/4k Hz
BAND4 frequency : ...............................................5k/6.3k/8k/10k/12.5k/16k Hz
Gain .......................................................................................................................................................... 9 dB
Q control .......................................................................................................................................0.25/0.5/1.0/2.0
Crossover
Highpassfilter frequency : ............................................................................30/60/90/120/150/180/250 Hz
Slope : ..............................................................................................................12/18/24 dB
Lowpassfilter frequency :.............................................................................30/60/90/120/150/180/250 Hz
Slope : ..............................................................................................................12/18/24 dB
Time alignment
(0.15m STEP)................................................................................................................................0 – 3.0 m
(0.5ft STEP) .................................................................................................................................0 – 10.0 ft
(0.3m STEP)...............................................................................................................................3.0 – 6.0 m
(1.0ft STEP) ............................................................................................................................10.0 – 20.0 ft
Center (0.15m STEP) ....................................................................................................................0 – 1.5 m
Center (0.5ft STEP) .......................................................................................................................0 – 5.0 ft
Channel level.............................................................................................................................................. 10 dB
Audio section
Preout level (V) ..................................................................................................................................4.5 V / 10 kΩ
Preout impedance (Ω) ................................................................................................................................≤ 600 Ω
External audio max input level..............................................................................................................1 V / 22 kΩ
S/N Ratio (dB)..............................................................................................................................................100 dB
Harmonic Distortion
(20 kHz LPF , 1kHz)..........................................................................................................................0.01 %
Frequency Response ......................................................................................................................10 Hz – 24 kHz
General
Installation Size (W x H x D) ....................................................................................................208 x 40 x 163 mm
(8-3/16 x 1-9/16 x 6-7/16 in.)
Weight ............................................................................................................................................2.0 lbs (0.9 kg)
English-7
|