IMPORTANT
Please read carefully before use.
CU-VD20
Easy and correct way of copying to a DVD
1. Get ready a recommended disc
3. Copy all images to the DVD
Please use the recommended discs stated below.
Perform operations on the Everio.
(Everio LCD screen display)
Using discs other than those recommended may cause problem when copying to the DVD
and when playing back the DVD.
1
2
Confirm that the display on the right
appears on the Everio LCD screen.
Recommended discs
Select “ALL SCENES”
DVD-R DL
(single-sided double layer)
DVD-R
DVD-RW
1 Select
(move up and down)
Brand JVC
JVC
JVC
Verbatim
TDK
2 Confirm
(press down)
Verbatim
SONY
3
4
Select “ALL”
Caution
1 Select
(move up and down)
Only DVD-R and DVD-RW discs can be used.
DVD-R DL (single-sided double layer) discs can only be used for High definition Everio.
Recording and playback may not function properly if the recording side is scratched or dirty.
•
•
•
2 Confirm
(press down)
2. Set up each device before copying
Select “EXECUTE”
CU-VD20
1 Select
Everio
(move up and down)
Dedicated USB cable
2 Confirm
(press down)
4
1
Wait for the “copy in progress” screen on the
right to disappear, then turn off the power and
disconnect the USB cable.
“Copy in progress” screen
3
2
1
2
Connect the USB cable
Turn on CU-VD20
After turning on the power, wait for approximately 20 seconds before
5
Exit
3
proceeding to step
.
The burner may not function properly within this 20 seconds.
Confirm
(press down)
3
4
Turn on the Everio
Copying completed!
Insert a new recommended disc into CU-VD20
Note
There are other ways of copying which includes copying only the desired files.
For details, refer to the instruction manual of Everio.
•
Next, operate the Everio. Proceed to step 3.
LYT1728-004A
0707MNH-SW-BJ1
|