INSTRUCTIONS
HZ-CA13U Cine Lens Adapter
Thank you for purchasing the HZ-CA13U Cine lens adapter.
HZ-CA13U is an adapter for mounting 16mm cine lens to JVC ProHD Camcorder.
Compatible camcorder : HZ-CA13U can be used on Camcorder which lens mounting method is 1/3-inch Bayonet type.
GY-HD100U/E, GY-HD101E, GY-HD110U/E, GY-HD111E, GY-HD200U/E, GY-HD201E
GY-HD250U/E, GY-HD251E
Pin
Mounting Cine lens
(PL Mount)
1/3-inch Bayonet Mount
(For Camcorder)
1/4-inch UNC20 Screw hole
Back Focus Adjust Ring
Attaching the Cine Lens Adapter to the Camcorder
5.When zoom lens is mounted, use Back focus adjust ring to
Hole
adjust if the back focus is out of adjustment. Firstly, set to
Telephoto position and adjust the lens focus, then set to
Wide-angle position and adjust using Back focus adjust ring
such that the focus is adjusted properly.
Pin
CAUTION
• Be sure to tighten the mount ring completely. Incomplete
tightening may result in the lens dropping off or disturbed
back focus.
Back focus adjust ring
• Set the Camcorder’s power switch to “OFF” before the zoom
lens is attached or detached.
1.Loosen the mount ring of the camcorder.
2.Attach the cine lens adapter with its pin aligned with the
• This adapter is exclusively for 16mm Cine lens.
• 1/4-inch UNC screw holes for lens support are provided on
this adapter. Attach the lens support always when using the
cine lens.
hole in the mount.
3.Tighten the mount ring of the camcorder.
4.In the case of fixed-focus lens, adjust the lens focus to t ∞,
• When taking picture using this adapter, the image will be
displayed upside-down on the monitor. A menu to restore
the upside-down image is available on GY-HD200/201/250/
251.
take picture of object (30m far away or above) and then
adjust using Back focus adjust ring such that the back focus
is adjusted properly.
Specifications
Conversion Ratio
Aperture
: x 0.47
ꢀ Dimensions (unit: mm)
: f / 1.4
F.B 52in air
F.B 31in air
138.2 (Mount to Mount)
Size length
Diameter
: 138.2 mm (Mount to Mount)
: φ78 mm
Weight
: 860 g
Mount for lens side
: PL Mount
Mount for Camera side : 1/3-inch Bayonet Mount
78.5
1/4-inch UNC20
© 2007 Victor Company of Japan, Limited
LST0570-001A
|