SB-K-SL-12W0v2 INSTR_SKU# 011315
InstallatIon
d I F F I C u lt Y :
If you choose to perform the installation yourself, it is absolutely vital that
the Stealthbox® be properly mounted to the vehicle according to these
instructions. Failure to mount the enclosure properly presents two problems:
out
oF
I n s t a l l a t I o n G u I d e
for the
1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
25
SB-K-SL-12W0v2
sKu#94493,94494
2010 +
2) A loose enclosure presents a serious safety hazard in the event of a collision
or sudden deceleration.
estImated tIme:
1 HouR
s t e P
1
Empty out the trunk of the car so that you have a clean area
to work in.
Thank you for choosing a JL Audio Stealthbox® for your automotive sound system. With proper
installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.
s t e P
2
Lift the floor, remove the compartmented foam spacer this
will not remain in the vehicle.
We strongly recommend that you have your new Stealthbox® installed by your authorized JL Audio
dealer. The installation professionals employed by your dealer have the necessary tools and experience
to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage
extends to 2 years if your system is installed or approved by your authorized JL Audio dealer. If you
prefer to perform your own installation, please read this installation guide completely
before beginning the process.
s t e P
3
Remove the tool kit that resides inside the spare tire and the
spare tire itself, set aside the hardware as it will be re-used.
Continued on Next Page
SB-K-SL-12W0v2 INSTR_SKU# 011315
I n C l u d e d H a R d W a R e
s t e P 1 2
Replace the tool kit that was removed in step 2.
1) 8mm x 38mm Coupling Nut
3) 3/8-16 x 2-1/4” Allen Head Set Screw
3) 3/8” x 1-1/4” Fender Washer
3) 3” x 3” Wax Square
2) 1/4-20 x 2” Phillips Flathead Screw
1) Custom Mount Strap
1) 8mm x 16mm Hex Cap Screw
3) 3/8-16 Hex Nut
3) 3/8” Split Lock Washer
4) 1/4-20 x 1-1/2” Allen Head Bolt
1) 5/16” Split Lock Washer
s P e C I F I C a t I o n s
Enclosure Type: Acoustic Suspension (sealed)
Driver Type: 12W0v2-4
Nominal Impedance: 4 Ohms
Continuous Power Handling: 300 Watts
s t e P 1 3
The recess on the top of the Stealthbox® was specifically
designed to be a good mounting location for an amplifier.
The amplifier shown is the Jl audio Xd400/4. See
recommendations below if this is where the amp will be
mounted.
P o W e R R e C o m m e n d a t I o n
JL Audio recommends high quality amplifiers such as the JL Audio XD400/4. The picture below shows the
recommended settings for the XD400/4. If another amplifier is being used, please reference this illustration and
use similar settings on that amplifier. All JL Audio amplifiers are very versatile audio components. Please consult
the owner’s manual for even more detailed information about installing and tuning your amplifier.
s t e P 1 4
If mounting an amplifier in the recess make sure to mount
the amplifier panel to the Stealthbox® first and then the amp
to the panel so that extra holes will not be drilled into the
Stealthbox®.
C o n n e C t I o n s
Using quality power, signal and speaker wire is essential in ensuring the performance of your Stealthbox®.
JL Audio recommends using a 4 AWG power kit such as the XC -PCS4-1B for your Stealthbox® amplifier, other
kits are available should you be using more than one amplifier. Signal wire such as the JL Audio Premium
Audio Interconnect Cables should be used that will provide signal for both channels of the amplifier. JL Audio
recommends using 12AWG speaker wire for subwoofers such as our XC-BCS12-25.
m I d / H I G H F R e q u e n C Y d R I v e R F I t m e n t
s t e P 1 5
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Including a full Slampak® system designed for the Soul (SKU-94494)
C o n G R a t u l a t I o n s !
You have completed the installation for this model!
Enjoy your new Stealthbox®!
Front/ Rear Speaker Size - Front Location: 6-1/2”- Front Doors
Fits JL Audio Models: TR650-CXi, C2-650x, C3-650, C5-650, C5-650x & ZR650-CSi
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
(954) 443-1100
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve”and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU# 011315 08.09.2010
•
Printed in USA
•
©2010 JL Audio, Inc.
•
U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902 #6,243,479
#6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign patents pending.
Page 3• JL Audio, Inc 2010
1
0
3
6
9
N
O
R
T
H
C
O
M
M
E
R
C
E
P
A
R
K
W
A
Y
•
M
I
R
A
M
A
R
,
F
L
O
R
I
D
A
•
3
3
0
2
5
•
U
S
A
|