Accessing the Conduit Knockouts on the
Control 300 Series Backboxes / Backcans
1. On the inside of the backbox (MTC-300BB12)
/ backcan (MTC-300BB8), locate the general area
Knockout
of the knockout. Note: Because of the dampening
material’s thickness, you may not be able to feel the
wood cut out however, a cut out is located at each
knockout point.
(Exterior View)
1
2
3
2. Using a utility knife, cut the dampening material
and remove it from the inside of the box to expose
the conduit knockout. IMPORTANT! To avoid
injury, always wear safety glasses when cutting away
dampening materials.
3. Using a hand held punch, strike the knockout
and remove the seal.
JBL Professional
8400 Balboa Blvd
Northridge, CA 91329 USA
© 2006 JBL Professional
|