Clarion SRK 5 SRK5 SRK5 User Manual

Printed in China  
IGSRK5 2003  
R
SRK5  
Installation /Wire Connections Guide  
FEATURES  
High-powered amplifier with maximum of 50W output power.  
5-3/4" full range drivers in the front for high frequency response.  
2 low frequency drivers in the rear for mid bass reinforcement.  
This design delivers clear and stunning sound to your 5.1 surround  
sound system.  
Strong neodymium boron magnets are used in the speaker drivers  
to create powerful playback of audio signals, even though the  
speaker's drivers are 1" and less in diameter.  
Included in with the center speaker are mounting brackets  
and hardware to allow the unit to be installed just about anywhere,  
including a 1/2 din opening.  
ACCESSORIES  
Item  
Q'ty  
Surface mount screws ......... 8  
Bracket mount screws ......... 4  
Brackets .............................. 2  
Owner's Manual .................. 1  
Warranty Card ..................... 1  
SPECIFICATIONS  
Amplifier  
Speaker Box  
Rated Output  
Maximum Output  
Distortion  
20W (1kHz @ into 4 Ohm at 1% THD)  
20W  
0.1% at 1.0W 1kHz  
70dB (0dB=1kHz 1W 4 Ohm)  
200mV to 4V  
Five (5) - 3/4" Full Range Speakers  
Two (2) - 1" Low Frequency Speakers  
Peak Power Input ...................... 50W  
Continuous Power Input ............. 20W  
Dimensions ............................... 1"H x 6-3/4"L x 6-1/2"L  
Weight ....................................... 0.5lb  
S/N  
Input Sensitivity  
Frequency Response  
200Hz to 29kHz  
Power Supply Voltage 10.8V to 15.6V  
Current Consumption  
Dimensions  
Weight  
3A  
1-3/4"H x 3-3/8"W x 5-3/4"L  
1lb  
SPEAKER INSTALLATION  
1. Determine desired location for speaker box and amplifier  
insuring that access is available to all needed items  
(i.e. power source, audio signal input, gain control, etc.).  
2. Install speaker box mounting brackets using provided screws  
(if needed).  
Clear (-)  
Tapping  
Screw  
3. Mount amplifier using provided screws.  
Clear/Red Stripe (+)  
4. Connect the speaker wire from amplifier to speaker's box.  
5. Connect the RCA to your processor or head unit RCA output.  
6. Connect the ground cable from amplifier to a proper grounding  
connection on the vehicle chassis.  
7. Connect the DC power to amplifier.  
8. Adjust amplfier gain appropriately.  
Bracket  
Screw  
Bracket  
Installation of the unit should not be in a location that would  
interfere with the vehicle safety air bag or placed in a location  
that could cause danger or damage to the unit or person.  
Installation Surface  

Audio Authority Car Audio System User Manual
Bosch Appliances Blender MUM6N10UC User Manual
Burnham MEGASTEAM MST288 User Manual
Canon E 700 User Manual
Canon Elura40 User Manual
Crown Boiler BWC090 User Manual
GE CG400 User Manual
JL Audio Stealthbox SB POL RNGR700 User Manual
JVC Car Stereo System KD AHD65 User Manual
JVC GET0651 002A User Manual