HOW TO USE
CATEYE SINGLE SHOT PLUS
ENG
1
Lighting (lighting pattern selection)
Switch
HL-EL610RC
The lighting pattern is selected using a switch.
Standard continu-
Switch
ous lighting time
Pat. and Design Pat. Pending
Copyright© 2007 CATEYE Co., Ltd.
↔
ON OFF : Long press
Hi
: About 3 hours
↔
Hi Low : Single press
Flash
Low : About 9 hours
EL61RC-070620 066640131
1
: Quick double press Flash : About 36 hours
INTRODUCTION
Before using the light, please read this manual and the attached “NiMh
Batteries” thoroughly, and keep them for future reference.
Thank you very much for purchasing the CATEYE "SINGLE SHOT PLUS HL-EL610RC."
This product is a high power rechargeable light unit that integrates a high power LED and
a nickel metal-hydride rechargeable battery into a compact body.
Double press
ON
Hi
2 sec.
x1
FOR SAFE OPERATION
• Do not place it within children's reach.
Flash
• In preparation for unexpected battery shutoff, we recommend you carry a dry-cell
battery light unit with you.
• If the light unit or parts become dirty with mud, etc., clean with a soft cloth which is
moistened with mild soap. Never apply paint thinner, benzine or alcohol; damage
will result.
Double press
OFF
Low
• Mount the light unit more than 10 cm away from the wireless meter. When it is
mounted too close, the transmission may be affected adversely.
• This product has waterproof features that allow you to use it in rain. Do not use it
soaked in water.
2
Remaining battery capacity
Battery indicator
When the battery indicator lights up red, the bat-
tery is almost shutoff. Charge the battery as soon
as possible.
Before Initial Use
Before shipment, it is charged enough to check the light. Be sure to charge it before use,
according to the instructions "How to charge."
3
How to charge
Charge jack
1
1�Open the charge jack cover at the
back of the light unit to connect the
battery charger plug.
2�Plug the battery charger to an
AC outlet.
COMPONENTS
Charging Indicator
Battery charger
Battery charger
3�After charging, remove the plug
and close the charge jack cover.
Light unit
H34 Bracket
Bracket
2
HOW TO MOUNT
1�Wrap the bracket strap around the
handlebar, and put it in the dial.
2�Securely tighten the strap by turn-
ing the dial.
To AC power outlet
* Be sure to use the special purpose battery
charger.
* Charging and lighting times are approximate
values, and will vary by environmental and
user conditions.
Standard charg-
ing time
Charging indicator state
Bracket rubber pad
Blinking red light : Charging
Approx. 4 hours
Green light : Charging is completed
2
3�Cut off the excess bracket strap
extending from the dial.
HOW TO REPLACE BATTERY
1�Turnoverthelight, andremovethe2
screws at the front of the lens using
a 2.5 mm Allen wrench.
2�Slowly pull out the lens unit from
the body.
3�Remove the battery connector con-
nected to the board, and replace it
with a new battery.
4�Place the battery on the tray, and
insert it to the body in place, and
secure it with 2 screws.
3
4�I n s e r t t h e l i g h t u n i t t o
the bracket until it clicks.
To remove, pull out while pressing
the release button.
1
Bracket strap
Dial
Body
*1
CAUTION!:
• Make sure to tighten the dial by
hand. If you tighten it too hard
with a tool, the screw threads may
be stripped.
Lens unit
Screw
Battery
• When the angle adjustment on the
right and left sides is loose, tighten
the screw (*1).
• Round off the cut edge of the
bracket strap to prevent injury.
Light unit
2
Screw
CAUTION!:
Rubber packing
• The lens unit is a precision part;
therefore, never disassemble
it. Otherwise, the optimum light
distribution may be lost.
4
Release button
How to Adjust Beam Angle
5�Slightly loosen the dial on the
bracket.
6�Adjust the light unit angle so that
the light is not directed to oncom-
ing cars.
* When the dial is too firm to loosen, wash it
slightly with water to loosen it.
* Do not loosen the dial too much, or the bracket
strap may come off. Loosen the dial just enough
to allow the bracket to move slightly. Securely
tighten the dial after adjusting the strap.
* It can also be adjusted 10 degrees to the left
and right.
Battery connector
• To maintain its waterproof features,
assemble the lens unit with a rubber
packing-sheet correctly.
• In order to avoid cable damage,
when re-assembling the light,
make sure the battery cable is
placed inside the rubber seal as
shown below.
Back side of lens
Rubber packing
6
OK
NO!
SPARE PARTS
SPECIFICATIONS
LIMITED WARRANTY
Light source
Battery
High power white LED x 2
NiMH 4.8v 2700mAH
2-year Warranty: Light unit / Battery charger
(Deterioration of the battery is excluded.)
#533-8827
H34 Bracket
Battery charger
Operating time
CHR-2700mAH 4.8v NiMH
Hi : Approx. 3 hours
Low : Approx. 9 hours
Flash : Approx. 36 hours
CatEye products are warranted to be free of defects from materials and workmanship for a period of 2 years from original
purchase. If the product fails to work due to normal use, CatEye will repair or replace the defect at no charge. Service must
be performed by CatEye or an authorized retailer. To return the product, pack it carefully and enclose the warranty certificate
(proof or purchase) with instruction for repair. Please write or type your name and address clearly on the warranty certificate.
Insurance, handling and transportation charges to CatEye shall be borne by person desiring service.
Standard charging time
Approx. 4 hours
Temperature range Charging : 32˚F – 104˚F (0˚C – 40˚C)
Operating : 5˚F – 113˚F (-15˚C – 45˚C)
Recharge/discharge number of times
About 300 times (until the rated capacity drops to
50%)
Dimensions/weight 4-3/32” x 2-29/32” x 1-11/16” (104 x 74 x 43 mm) /
8.92 oz (253 g)
* The specifications and design are subject to change without notice.
#534-1865
NiMH 4.8v 2700mAH
For UK and REPUBLIC OF IRELAND consumers, please return to the place of purchase. This does not affect your statutory rights.
CO.,LTD.
UL:#534-1866
2-8-25, Kuwazu, Higashi Sumiyoshi-ku, Osaka 546-0041 Japan
UK:#534-1867
Attn : CATEYE Customer Service Section Phone : (06)6719-6863 Fax : (06)6719-6033 E-mail : [email protected] URL : http://www.cateye.co.jp
Service & Research Address for USA
EC:#534-1868
AS:#534-1870
CHR-2700mAH 4.8v NiMH
CATEYE Service and Research Center 1705 14th St. 115 Boulder, CO 80302
Phone : 303.443.4595 Toll Free : 800.5CATEYE
Fax : 303.473.0006
E-mail : [email protected]
|