Canon EF S60MM User Manual

EF-S60mm f/2.8 MACRO USM  
ENG  
Instruction  
This device complies with Part 15 of the FCC Rules. Operation is  
subject to the following two conditions: (1) This device may not  
cause harmful interference, and (2) this device must accept any  
interference received, including interference that may cause  
undesired operation.  
Do not make any changes or modifications to the equipment  
unless otherwise specified in the instructions. If such changes or  
modifications should be made, you could be required to stop  
operation of the equipment.  
This equipment has been tested and found to comply with the  
limits for a class B digital device, pursuant to part 15 of the FCC  
Rules. These limits are designed to provide reasonable protection  
against harmful interference in a residential installation. This  
equipent generates, uses and can radiate radio frequency  
rgy nd, if not installed and used in accordance with the  
istructions, may cause harmful interference to radio  
communications.  
However, there is no guarantee that interference will not occur in  
a particular installation. If this equipment does cause harmful  
interference to radio or television reception, which can be  
determined by turning the equipment off and on, the user is  
encouraged to try to correct the interference by one or more of  
the following measures:  
a Safety Precautions  
Do not look at the sun or a bright light source  
through the lens or camera. Doing so could  
result in loss of vision. Looking at the sun directly  
through the lens is especially hazardous.  
Whether it is attached to the camera or not, do  
not leave the lens under the sun without the  
lens cap attached. This is to prevent the lens from  
concentrating the sun’s rays, which could cause a  
fire.  
Handling Cautions  
If the lens is taken from a cold environment int
a warm one, condensation may develop on the  
lens surface and internal parts. To prevent  
condensation in this case, first put the lens into an  
airtight plastic bag before taking it from a cold to  
warm environment. Then take out the lens after it  
has warmed gradually. Do the same when taking  
the lens from a warm environment into a cold one.  
• Do not leave the lens in excessive heat such as in  
a car in direct sunlight. High temperatures can  
cause the lens to malfunction.  
• Reorient or relocate the receiving antenna.  
• Increase the separation between the equipment and receiver.  
• Consult the dealer or an experienced radio/TV technician for  
help.  
This Class B digital apparatus complies with Canadian ICES-003.  
ENG-2  
Nomenclature  
Focusing ring (4)  
Hood mount (7)  
Distance scale (8)  
Distance index (8)  
Filter mounting  
thread (9)  
Focus mode switch  
(4)  
Macro flash  
mount (7)  
Contacts (4)  
Lens mount index (4)  
For detailed information, reference page numbers are provided in parentheses (**).  
ENG-3  
Mounting and Detaching the Lens  
Setting the Focus Mode  
1
2
See your camera’s instructions for details on  
mounting and detaching the lens.  
To shoot in autofocus (AF) mode, set the focus  
mode switch to AF.  
o use only manual focusing (MF), set the focus  
ode switch to MF, and focus by turning the  
focusing ring. The focusing ring always works,  
regardless of the focus mode.  
¡After detaching the lens, place the lens with the  
rear end up to prevent the lens surface and  
electrical contacts from getting scratched.  
¡If the contacts get soiled, scratched, or have  
fingerprints on them, corrosion or faulty  
connections can result. The camera and lens  
may not operate properly.  
After autofocusing in ONE SHOT AF mode, focus  
manually by pressing the shutter button halfway  
and turning the focusing ring. (Full-time manual  
focus)  
¡If the contacts get soiled or have fingerprints on  
them, clean them with a soft cloth.  
¡If you remove the lens, cover it with the dust  
cap. To attach it properly, align the lens mount  
index and the ¢ index of the dust cap as shown  
in the diagram, and turn clockwise. To remove  
it, reverse the order.  
ENG-4  
Picture Taking  
3
3. Focus the subject.  
Normal Photography  
While looking through the viewfinder, move the  
camera forward or back to find the point of  
focus.  
4. Touch up the focus.  
Turn the focusing ring for fine focusing.  
The lens can be used as a medium-telephoto  
lens equivalent to 96mm in 35mm format for  
normal photography such as snapshots and  
portraits.  
Closeup Photography  
Close-up photos up to 1x (life-size) magnification  
are possible. The minimum focusing distance of  
20 cm is the distance from the subject to the  
focal plane. The working distance from the front  
of the lens to the subject is about 9 cm.  
When focusing, you can give priority to framing  
or to magnification.  
Since macro shots have a very shallow depth of  
field, focus carefully to obtain proper sharpness.  
¡Image quality deteriorates near the minimum  
aperture opening due to diffraction.  
¡The magnification refers to the ratio between the  
subject’s size and the corresponding image size  
on the focal plane. On the distance index, it is  
indicated as 1:x.  
¡To prevent camera shake, using a Remote  
Switch (both sold separately) and tripod is  
recommended.  
[Framing Priority]  
While looking through the viewfinder and framing  
the subject, focus with the AF or MF mode.  
[Magnification Priority]  
1. Set the lens’ focus mode switch to MF.  
2. Set the magnification.  
¡To check the depth of field, press the camera’s  
depth-of-field preview button.  
While referring to the magnification scale on  
the lens, turn the focusing ring to the desired  
magnification.  
ENG-5  
About Exposure  
4
Setting the Exposure  
Magnification  
Effective f/No.  
Exposure Factor in  
1 : 5 1 : 4 1 : 3 1 : 2 1:1.5 1 : 1  
3.50 3.66 3.89 4.39 4.86 5.84  
When taking photographs using TTL  
metering, no exposure compensation is  
necessary to meter the light coming through  
the lens.  
1
2
1
2
1
2
stops  
stops  
+
+
+
+
+1 +1 +1 12 +2  
+1 +1 13 +1 23 +2  
1
3
2
3
2
3
(stops)  
in  
With TTL metering, AE (autoexposure) is  
possible at all focusing distances. Just set the  
desired picture-taking mode, then check the  
shutter speed and aperture before taking the  
picture.  
¡The correct exposure for a close-up shot largely  
depends on the subject. Therefore, it is  
recommended to take several shots of the same  
subject at different exposures.  
¡When taking close-up shots, it is recommended  
to use aperture-priority AE (Av) or Manual (M)  
picture-taking modes, because depth of field  
and exposure are easy to adjust in those  
modes.  
Magnification and Effective f-number  
The aperture displayed by the camera assumes  
that the focus is set to infinity. The actual aperture  
(effective f-number) becomes darker (effective f-  
number increases) at closer focusing distances  
(magnification increases). This does not cause  
exposure problems for normal picture-taking.  
However, for closeup photography, you cannot  
ignore the change in the effective f-number.  
When you use a handheld exposure meter to  
set the exposure, you must take into account  
the exposure factor shown in the following  
table.  
If your eye will not be covering the eyepiece when  
the picture is taken (with remote control operation,  
etc.), use the eyepiece shutter or eyepiece cover.  
This prevents stray light from entering the  
eyepiece and throwing off the proper exposure.  
ENG-6  
Macro Flash (Sold Separately)  
Hood (Sold Separately)  
5
6
The Canon Macro Ring Lite MR-14EX or the  
Macro Twin Lite MT-24EX enables fully  
automatic macro flash photography up to 1x  
magnification in E-TTL autoflash mode.  
The ET-67B hood can keep unwanted light out of  
the lens, and also protects the lens from rain,  
snow, and dust.  
¡For information on operating the Canon Macro  
Ring Lite MR-14EX or the Macro Twin Lite MT-  
24EX, refer to the individual instruction booklets.  
¡Using aperture-priority AE (Av) or Manual (M) is  
recommended.  
Flash Range (ISO100)  
Flash Head Angle  
Settings for MT-24E
MR-14EX  
MT-24EX  
Attach and align the hood to the hood mount on  
the front of the lens, and turn the hood as shown  
by the arrow to secure it.  
The hood can be reverse-mounted on the lens  
for storage.  
32  
22  
16  
11  
8
Inwrd Angle  
of Flah Hed  
Magnification  
45° 30° 15°  
1 : 1 - 1 : 1.5  
1 : 2  
5.6  
4
¡Part of the picture may be blocked if the hood is  
not attached properly.  
1 : 3  
2.8  
1 : 5  
¡When attaching or detaching the hood, grasp  
the base of the hood to turn it. To prevent  
deformation, do not grasp the rim of the hood to  
turn it.  
1
1.5  
2
3
5
1
1.5  
2
3
5
1:  
Magnification →  
: Flash range  
ENG-7  
Infinity Compensation Mark  
Close-up Lenses (Sold separately)  
7
8
Infinity Compensation Mark  
Attaching a 250D or 500D (52mm) Close-up  
Lens enables close-up photography.  
The magnification will be as follows.  
¡Close-up Lens 250D: 1.33x - 0.25x  
¡Close-up Lens 500D: 1.18x - 0.12x  
Manual focusing is recommended for accurate  
focusing.  
Distance index  
To compensate for shifting of the infinity focus  
point that results from changes in temperature.  
The infinity position at normal temperature is the  
point at which the vertical line of the L mark is  
aligned with the distance indicator on the  
distance scale.  
For accurate manual focusing on subjects at  
infinity distance, look through the viewfinder while  
rotating the focusing ring.  
ENG-8  
Filters (Sold Separately)  
Extension Tubes (Sold Separately)  
9
10  
You can attach filters to the filter mounting  
thread on the front of the lens.  
You can attach Extension Tube EF12 II or EF25  
II for magnified shots. The shooting distance and  
magnification are shown below.  
¡This lens can accommodate both filters and the  
macro flash at the same time.  
¡If you need a polarizing filter, use the Canon  
Circular Polarizing Filter (52mm).  
¡To adjust the polarizing filter, first remove the  
lens hood.  
Camera-to-Subject  
Magnification  
Distance (mm)  
Near  
207  
215  
Far  
445  
289  
Near  
1.28×  
1.61×  
Far  
EF12 II  
EF25 II  
0.20×  
0.44×  
Mnual focusing is recommended for accurate  
focusing.  
ENG-9  
Specifications  
11  
Focal Length/Aperture  
Lens Construction  
Minimum Aperture  
Angle of View  
Min. Focusing Distance  
Max. Magnification  
Field of View  
Filter Diameter  
Max. Diameter and Length  
Weight  
60 mm f/2.8  
8 groups, 12 elements  
f/32  
Diagonal: 24° 30’  
0.2 m/0.7 ft.  
Vertical: 14° 10’  
Horizontal: 20° 40’  
1 ×  
15.1 × 22.7 mm/0.6 × 0.9 inch (at 0.2 m)  
52 mm/2.0 inch  
73 × 69.8 mm/2.9 × 2.7 inch  
335 g/11.8 oz  
Hood  
Lens Cap  
ET-67B (Sold separat)  
E-52U  
Case  
LP1016 (Sold separately)  
¡Equivalent to 96 mm in the 35mm film format.  
¡The lens length is measured from the mount surface to the front end of the lens. Add 21.5 mm when including  
the lens cap and dust cap.  
¡The size and weight listed are for the lens only, except as indicated.  
¡The EF1.4X II/EF2X II extenders cannot be used with this lens.  
¡Aperture settings are specified on the camera.  
¡All data listed is measured according to Canon standards.  
¡Product specifications and appearance are subject to change without notice.  
ENG-10  
CT1-7556-010  
© CANON INC. 2005  
2010.2  

Advent ADV10 User Manual
AOC Car Video System e1620Sw User Manual
Canon EOS 60D User Manual
Casio Calculator SF 5580 User Manual
Casio Graphing Calculator Calculators Translators CLASSPAD330PLUS User Manual
FujiFilm FinePix 16233283 User Manual
Hypertec TSV12WFV2HY User Manual
Insignia NS DV111080F User Manual
Jensen Tools JCD2006 User Manual
JVC GR DF450 User Manual