Ionic Breeze®
QUADRA®
Silent Air Purifier
INCLUDES IMPORTANT
SAFETY INFORMATION
SI637
SI697 Instructions
READ ALL INSTRUCTIONS
BEFORE USING THIS
APPLIANCE
SAVE THESE
INSTRUCTIONS
WARNING: To reduce the risk of fire, electric shock,
or injury when using any electrical appliance, basic
precautions should always be followed, including:
•This appliance operates at 110v AC and 60Hz only.
•Connect to a properly grounded outlet only.
•Use indoors only.
•Unplug from outlet when not in use and before servicing.
•Do not allow the appliance to be used as a toy.
Close attention is necessary when the appliance is operated
near children.
•Use only as described in this user manual.
•Do not use if cord or plug appears to be damaged. If the appli-
ance is not working properly, or has been dropped, damaged,
left outdoors, or dropped into water, return it to a service
center or to the original place of purchase.
•Do not pull, lift, or carry by the power cord. Do not use the
cord as a handle, close a door on the cord, or pull the cord
around or against sharp edges or corners.
•Keep the cord away from heated surfaces.
READ AND SAVE THESE INSTRUCTIONS
WARNING: To reduce the risk of fire, electric shock,
or injury when using any electrical appliance, basic
precautions should always be followed, including:
•Damaged power cord must only be replaced by qualified
service personnel. There are no user-serviceable parts inside
the unit. Any attempt to open the unit will void the warranty
and could lead to serious damage to the unit and/or personal
injury to the operator.
•Turn off all controls before unplugging unit from outlet.
•Do not unplug by pulling the cord. Grasp the plug itself, not
the cord, when unplugging from an outlet.
•Do not handle the plug or appliance with wet hands.
•Do not put any object into openings. Do not continue to use
with any opening blocked. Keep all openings free of dust, lint,
hair, or anything that may reduce airflow.
•Keep hair, loose clothing, fingers, and all parts of the body
away from openings.
•Do not operate the unit in areas where flammable or
combustible products or vapors may be present.
READ AND SAVE THESE INSTRUCTIONS
Important Information - Please Read
The collection grid has many edges and areas that can trap
water. It must be completely dry before being re-inserted or
the unit could be damaged. If water is used to clean the grid,
please allow at least 24 hours for the collection grid to dry.
This unit should not be located near a fireplace, whether or not
the fireplace is actually in operation. Dust and soot from the
chimney could be rapidly drawn through the Ionic Breeze and
deposited on or around the unit.
In rooms where candles or oil lamps are frequently burned, the
smoke from these products will tend to stick to the outside of
the Ionic Breeze. Avoid placing the Ionic Breeze in a location
where it will be subjected to smoke from oil lamps or candles.
In any area where this product will be subjected to heavy
pollution or smoke, it will be necessary to clean the collection
grid more frequently.
If the unit begins to arc or make a “static” type of sound, turn
the unit off, then slide the collection grid out and invert the unit
slowly, several times. Replace the grid.
Frequently Asked Questions
About the Ionic Breeze Quadra
®
TM
How often is cleaning required?
About every two weeks or anytime the Ionic Breeze makes an
audible sound or the CLEANING INDICATOR flashes.
How should it be cleaned?
Wipe the removable collection grid with a damp cloth, paper towel
or wash in your kitchen sink. It is very important that the collec-
tion grid be allowed to dry completely before returning it to
the main housing.
What is the clean fresh scent I smell?
This scent is ozone, (O3), a combination of three oxygen atoms.
(The U.S. government has set safe standards for ozone, and the
Ionic Breeze complies with those standards.)
Which power setting should I use?
If the odor of ozone is strong (for instance in a smaller room), you
may prefer to have the power setting on medium or low.
Please read this product instruction manual for important safety
information and operating instructions.
Set-Up and Operation
Place Ionic Breeze on a level
surface, at least twelve inches
from the wall.
Plug into a grounded 110v out-
let (read warnings for details).
12”
Activate the unit by pressing
the CONTROL BUTTON located
on top of the unit.
The unit will clean, ionize
and circulate the air with
periodic bursts, ramping the
air-flow up and down in a
preprogrammed cycle.
CONTROL
BUTTON
Set-Up and Operation
HIGH
MED IUM
LOW
Select the desired power
level by pressing the
CONTROL BUTTON to rotate
through the HI, MED, LO or OFF
settings.
Selected level is indicated by
the green LEDs.
CONTROL
BUTT ON
RED LED
This unit must be cleaned at
least once every two weeks.
If cleaning is neglected, the
unit will shut down.
(Indicated by a red LED.)
Normal operation can only
be resumed after the grid has
been cleaned.
Cleaning the Collection Grid
Cleaning of the grid is required every one or two weeks.
COLLECTION
GRID
Unplug the unit before
cleaning.
Remove the collection grid
by pulling it from the top of
the unit.
Use a dry or slightly damp
towel or sponge to quickly
wipe the dust from each of
the three collection bars.
3 sec.
Invert the entire unit for three
seconds before replacing the
collection grid.
Thorough Cleaning
If the unit makes noise during operation, a thorough cleaning of the
grid and ionizing wires may be required.
Remove the collection grid by
pulling it from the top of the
unit.
Wash the grid with warm
soapy water, rinse, and allow
to dry for 24 hours before
returning to unit.
Invert the main housing sev-
eral times before replacing
the collection grid.
This action will remove any
accumulated particles from
the ionizing wires.
Additional Information
The exterior of the unit can be safely cleaned using a soft cloth
or sponge and a solution of one part household bleach to five
parts water.
Allow the surface to dry for 24 hours before plugging it back
into an outlet.
The Ionic Breeze® complies with U.S. safety standards
for low ozone emission (less than 50 parts per billion).
We recommend that individuals with a history of
respiratory disease consult with their doctor about
possible heightened sensitivity to very low ozone.
Statement of FCC/DHHS compliance
Model: SI637
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE:
This product complies with DHHS Rule 21 subchapter J at date of manufacture.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for assistance.
FULL FIVE-YEAR WARRANTY
What Is Covered
This warranty covers any defects in materials or workmanship, with the excep-
tions stated below.
How Long Coverage Lasts
This warranty runs for five years from the date of original purchase.
What Is Not Covered
This warranty does not cover damage caused by misuse or use other than as
intended and described in the instruction manual, or damage caused by failure
to properly clean and maintain this product.
What The Sharper Image Will Do
The Sharper Image will repair any defects in materials or workmanship. Or, The
Sharper Image will have the option to either replace this product with a fully
warranted, reconditioned unit, or refund the purchase price of the product.
How to Obtain Service
Return the product and receipt, along with a brief explanation of the problem,
to:
T.S.I. - Returns Department
2901-A West 60th Street
Little Rock, AR 72209
If You Have Questions
Please feel free to contact our customer service representatives at
1-800-344-5555 or by email at [email protected].
This warranty gives you specific legal rights, and you may have other legal rights
that vary from state to state.
Copyright 2001, 2002, 2003
Sharper Image Corporation
Printed in China
V10
|