Sharp Af S125rx User Manual

AF-S100RX  
AF-S120RX  
AF-S125RX  
AF-S100RX, AF-S120RX  
AF-S125RX  
AF-S100RX, AF-S120RX, AF-S125RX  
20mm  
20mm  
20mm  
Is the unit plugged in or is the plug loose?  
Is the fuse blown or the circuit breaker tripped?  
Did you restart the unit within 3 minutes after a power failure? If the power was off  
for less than 3 minutes, and you restarted the air conditioner within 3 minutes, a  
protective device may cause the compressor to shut off, preventing cooling for  
about 5 minutes.  
Is the MODE set to fan only Mode?  
Cooling will not take place in the fan only mode. Change the MODE setting  
Is the filter clogged with dust?  
A dirty filter can cause the cooling coils to freeze. If this happens, clean the filter and  
replace. Run the air conditioner on the MED FAN setting until all ice dissipates.  
Is the temperature set properly?  
If your room is too warm, adjust the temperature setting lower.  
Is the window exposed to direct sunlight?  
Close curtains or blinds to minimize solar energy heating the room.  
Are the windows or doors open?  
Close all windows and doors for maximum cooling.  
Water will collect in the bottom tray of the unit. This is normal. Water condenses on the  
evaporator coil at the front of the unit and is channeled to the rear where it is picked up  
by the condenser fan. The water is blown onto the condenser coil fins and this creates  
a "splashing" noise which is normal. If excess water builds up in this tray it will drain  
outside through a grooved channel in the tray.  
The operating sound may seem rather loud for 2 to 3 minutes when the unit is first turned  
on. This is the sound of the compressor's start-up and is normal.  
A soft, swishing noise can be heard immediately after the unit is turned on or off, and also  
during operation. This is the sound of the refrigerant flowing inside the unit.  
Check the remote control batteries. Replace if necessary.  
Try to send the signal again with the remote control pointed directly at the unit's receiver  
window.  
Check whether the remote control batteries are installed with the polarities properly  
aligned.  
Printed in China  
2020215A0343  

Xerox Workcentre 7345 User Manual
Wagan 2045 User Manual
Savin Sdc306a User Manual
Panasonic Uf 7100 User Manual
NEC MULTISYNC XT5000 User Manual
HP 4280A User Manual
EMERSON SR600 User Manual
D LINK DES 1081MP User Manual
CRAFTSMAN 917.370413 User Manual
BLACK DECKER WORKMATE WM325 User Manual