Samson Rb2030 User Manual

RB2030  
Rechargeable Battery  
for use with the  
EX20 and EX30  
OWNERS MANUAL  
and  
INSTALLATION GUIDE  
®
Instructions for Installation of Battery  
1 With the rear of the Expedition cabinet facing you, lie the cabinet face down  
on a soft surface as not to scratch the front grille. (figure 1)  
2 Using a phillips screwdriver, remove the two M4 x 10 lower rear panel screws  
(to be re-used in step 6) and pole mount thumb screw (figure 1) NOTE: If the  
cabinet is to be pole mounted, it should be secured to the pole at this time.You  
will not have access to the pole mounting screw after the battery is installed.  
3 Replace thumb with the M6 x 16 screw (figure 2)  
4 Align the battery as in figure 2 and set its legs in the bottom of the EX20 or  
EX30 as in figure 3.  
5 Connect the Battery supply cable as in figure 3. IMPORTANT! Both the con-  
nectors on the supply cable (from the battery) and plug (on the cabinet)  
are keyed. Be sure to connect the cable correctly or youll risk shorting  
the battery which may result in fire and or internal amplifier failure.  
6 Lift the battery into place and screw the two M4 x 14 screws into the two outer  
holes and the two M6 x 12 screws in the inner holes on the battery lip. Use  
the two M4 x 10 screws (from step 2) to secure the bottom of the battery to  
the cabinet.  
M4 x14  
M6 x12  
Plug  
Supply  
Cable  
M4 x10  
figure 3  
figure 4  
If you experience any difficulties, or require further assistance, contact Samson  
Customer Service at 1-800-3SAMSON (1-800-372-6766) M–F 9AM to 5PM  
(eastern standard time). For more product information please visit our website at  
Specifications  
Type  
4 x 12VDC, 3.3 Amp/Hours Gel Cell  
Charging time  
68 hours  
Pin out for Cable and Charger (figure 5)  
Pin 1 NC  
Pin 2 CONTB (control one pin of relay for battery supply on/off)  
Pin 3 CONTA (control another pin of relay for battery supply on/off)  
Pin 4 VDC (Voloatge supply for battery charging)  
Pin 5 AGND (Ground of Charger)  
Pin 6 -VBAT (Negative battery supply to power mon.)  
Pin 7 +VBAT (Plus battery supply to Power mon.)  
Dimensions  
8.25 in. (w) x 12.5 (d) x 5.25 (h)  
209.5 mm (w) x 317.5 (d) x 133.35 (h)  
Weight  
12.8 lbs.  
5.8 kg  
CABLE (From Bat t ery)  
CHARGER (Cabinet )  
Key  
Key  
PIN 1 2 3 4 5 6  
7
PIN 7 6 5 4 3 2  
1
figure 5  
specifications are subject to change without notice  
©2000 Samson Technologies  
S A M S O N  
575 Underhill Blvd, P.O. Box 9031, Syosset, N.Y. 11791-9031  

York Dj 036 User Manual
Sanyo Kr Aah User Manual
Quasar Hq 2244uh User Manual
Philips Ss951p User Manual
Panasonic Dp 8130 User Manual
Lexmark All In One Printer 31n User Manual
EPSON ACTION NOTE 800 User Manual
CRAFTSMAN 917.258914 User Manual
CRAFTSMAN 536.885910 User Manual
ASUS T101H User Manual