HAND OPERATED
SIPHON PUMP
OPERATING INSTRUCTIONS
VENT CAP
SQUEEZE BULB
DISCHARGE TUBE
HOSE CLAMP
IN-TAKE TUBE
1. INSERT INTAKE (NON-FLEXIBLE) TUBE
INTO THE SENDING CONTAINER.
2. INSERT DISCHARGE (FLEXIBLE) TUBE
INTO THE RECEIVING CONTAINER OR
FUEL TANK (KEROSENE HEATER)
3. TIGHTEN THE VENT CAP BY TURNING
CLOCKWISE TO CLOSE VENT.
LOOSEN
VENT CAP
TIGHTEN
4. SQUEEZE LARGE BULB A FEW TIMES TO
START SIPHON ACTION. (AUTOMATIC
SIPHON ACTION WILL CONTINUE AS
LONG AS FLUID LEVEL IN SENDING
CONTAINER IS HIGHER THAN THE
LEVEL IN THE CONTAINER THAT FLUID
IS BEING TRANSFERRED INTO.
5. BEFORE RECEIVING CONTAINER IS
COMPLETELY FULL; STOP FLUID FLOW
BY TURNING VENT CAP COUNTER
CLOCKWISE. GENTLY LIFT DISCHARGE
HOSE SLIGHTLY TO ALLOW ANY
REMAINING FUEL TO DRAIN.
6. REMOVE INTAKE HOSE FROM SENDING
CONTAINER. CONNECT DISCHARGE
HOSE TO HOSE CLAMP TO PREVENT
DRIPPING.
7. CLEAN UP ANY SPILLED FLUIDS AND
DISPOSE OF CLEANING MATERIALS
OUTSIDE THE LIVING AREA.
8. STORE SIPHON PUMP OUTDOORS.
CAUTION
1. NOT FOR USE WITH CORROSIVE
CHEMICALS.
2. WHEN USING WITH A KEROSENE
HEATER -
* ALWAYS TURN HEATER OFF AND
ALLOW TO COOL BEFORE
REFUELING.
* ALWAYS FUEL HEATER OUTDOORS
AND CLEAN UP ANY SPILLS.
* ACCEPTABLE FOR USE WITH
NON-FLAMMABLE LIQUIDS SUCH
AS KEROSENE, SOAPS, ETC.
3. DO NOT LEAVE UNATTENDED DURING
USE.
Made in China
|