•
C L
®
For lights switched from one location
(For lights switched from two locations, see instructions on reverse)
dimmer
oPEraTion
determine wiring type
remove middle sections (if ganging devices)
Mount dimmer using the provided screws
1
4
6
MacL-153M
120 V~ 60 hz
P/N 0301771 REV A
For lights switched from two locations, see instructions on
the reverse side.
Remove middle sections if mounting 2 or more devices side by
side. See Maximum Ratings chart for the new wattage limits.
Tap to toggle lights
on/off.
Indicator Lights (IL)
NOTE: No derating is required when using only CFLs or LEDs.
150 W
600 W
Displays the current light level
cFL/LEd
incand./hal.
For lights switched from one location, proceed to Step 2
below.
Double-tap to turn
lights on to full
intensity.
Keep
T
+
Press & hold for
delayed fade-to-off.
If using CFL or LED bulbs,
they must be Lutron®
compatible!
r
L
Remove
Turn power on at circuit breaker
7
Raise lights
Turn power oFF at circuit breaker!
For the compatible bulb list...
Helpful videos...
2
Lower lights
MaXiMUM raTingS For MiXEd Load TYPES
LED
cFL
incandescent/halogen
Advanced programming &
operation...
FaSSTM
Pull tab out for bulb replacement.
Additional wiring scenarios...
oPTionaL For incandEScEnT/haLogEn
Replacing a dimmer with a dimmer...
or
Warning: Shock hazard.
May result in serious injury or death. Turn off
power at circuit breaker or fuse before installing.
0 W
+
+
+
+
+
+
+
600 W
500 W
400 W
300 W
200 W
100 W
0 W
500 W
400 W
300 W
200 W
100 W
50 W
400 W
300 W
200 W
100 W
50 W
0 W
adjust dimming range for LEds and cFLs
8
1 W – 25 W
26 W – 50 W
51 W – 75 W
76 W – 100 W
101 W – 125 W
126 W – 150 W
If you have three or more switches
controlling a light...
Hold T & L until an indicator light
(IL) blinks on the MACL dimmer.
iL
Please visit:
T
&
L
0 W
0 W
remove existing device
connect the new dimmer (MacL)
3
5
Fully wrap the wires around the screw and tighten (a), or strip
insulated wires to 1/2 in (13 mm) and insert into the push-in
terminals (B).
help
a
B
IMPORTANT
U.S.A. | Canada | Caribbean
Hold L until bottom indicator light (IL)
is reached.
1.800.523.9466
1. CAUTION: Use only with permanently installed fixtures with
dimmable screw-in compact fluorescent, dimmable screw-in
LED, halogen, or incandescent lamps. To avoid overheating
and possible damage to other equipment, do not use to
control receptacles, motor-driven appliances, or low-voltage
transformer-supplied appliances.
or
r
Tap
until all bulbs in the room are
1/2 in
(13 mm)
Mexico
+1.888.235.2910
on and stable (no flickering).
T
r
Use 12/14 AWG
Use 14 AWG
or
Single tap T to save setting.
L
Others
+1.610.282.3800
2. Install in accordance with all national and local electrical codes.
3. When no “grounding means” exists in wallbox, the 2011 National
Electrical Code® (NEC®) allows a control to be installed as a
replacement if 1) a nonmetallic, noncombustible faceplate is
used with non-metallic attachment screws or 2) the circuit is
protected by a ground fault circuit interrupter (GFCI). When
installing a control according to these methods, cap or remove
green wire before screwing control into wallbox and use an
appropriate faceplate such as Claro® or Satin Colors® series
wallplates by Lutron.
MacL
Fax
+1.610.282.6311
Disconnect wires.
Brass screw
Single tap T to turn off bulbs.
•
4. 3-way wiring must use only one Maestro® C L® Dimmer and a
Single tap T again.
Maestro® Companion Dimmer
(MA-R, MSC-AD) or an existing switch.
4-way wiring must use only one Maestro® C L® Dimmer and up
to 9 Maestro® Companion Dimmers (MA-R, MSC-AD).
Limited Warranty:
369-119_Wallbox_Warranty.pdf
Black screw
If all bulbs do not turn on or are not
stable, repeat step 1, and in step 2
increase light with r .
T
r
•
5. For indoor use only between 32 °F and 104 °F
(0 °C and 40 °C).
©2013-2015 Lutron Electronics Co., Inc.
•
6. Maestro® C L® Dimmers may feel warm to the touch during
•
Lutron, Lutron, Claro, Satin Colors, Maestro, and C L
normal operation.
are registered trademarks of Lutron Electronics Co., Inc.
7. Maximum wire length between the Master Dimmer and the last
Companion Dimmer (MA-R, MSC-AD) is 150 ft (46 m).
8. Clean dimmers with a soft damp cloth only.
Do not use any chemical cleaners.
If your bulbs are flickering, buzzing or dropping out, your bulbs
check the Compatible Bulb List.
Green wire
Ground wire (bare or green)
|