Model No.:
Vendor No.:
UPC#
191-691
11289
792145354338
NOTE: When installing the remote
control, be sure your fan is set on
“HIGH SPEED” and the light is ON.
REMOTE CONTROL INSTALLATION
GENERAL INFORMATION
This remote control is designed to separately control your ceiling fan speed and light brightness.
The fan button will control the fan speed. (Hi, Med., Low, Off)
NOTE: Frequency Switches
“D”= Incandescent use (Dimming)
“ON”= CFL or LED use (On/Off only)
Select “D” or “ON” in the frequency switches to control the light dimmer or ON/OFF
function based on your light bulbs.
The red indicator on the transmitter will light when the button is pressed.
INSTALLATION AND OPERATING INSTRUCTIONS
NOTE: This remote control unit is equipped with 16 code combinations to prevent possible interference from or to other remote units. The
frequency switches on your receiver and transmitter have been preset at the factory. Please recheck to make sure the switches on
transmitter and receiver are set to the same position, any combination of settings will operate the fan as long as the transmitter and
receiver are set to the same position.
1. SETTING THE CODE
This unit has 16 different code combinations. To set the code, perform these steps:
Caution! The dip switches on the receiver unit are covered with a rubber cover, remove the rubber cover and then place back after making any
changes to the dip switches.
A. Setting the code on the transmitter:
a. Remove the battery cover. Press firmly below the arrow and slide battery cover off.
b. Slide the frequency switches to your choice of up or down position. (Factory setting is all up). Do not use this Position. Use a small screwdriver
or a ballpoint pen to slide firmly up or down (Figure A).
c. For use with incandescent bulbs, use the “D” setting for full range dimming. For fans that use Fluorescent or LED bulbs, use the “ON” setting for
the light to have ON/OFF functions only.
d. Replace the battery cover on the transmitter.
B. Setting the code on the receiver:
a. Slide the frequency switches to the same positions as set on your transmitter (Figure B).
ON
ON
ON ECE
D
1 2 3 4
ON
Frequency switches
ON ECE ON
1
2
3
4
D
Frequency switches
Receiver
Fig. A
Transmitter
Fig. B
2. INSTALLING RECEIVER IN THE CEILING FAN
A. Safety precautions:
WARNING: HIGH VOLTAGE! Household electrical power can cause serious injury or death. Disconnect the source of electrical power
to the ceiling fan by removing the fuse or switching off the circuit breaker.
B. Installing receiver in fan.:
a. Remove the ceiling fan canopy from the mounting bracket.
b. Disconnect the existing wiring between the ceiling fan and supply at the electrical junction box.
c. Lay the black antenna wire on top of the receiver, and put the receiver in the mounting bracket. (Fig. C)
d. Make the connections as follows, using the wire nuts supplied: (Fig. D)
CONNECT
TO
Green fan wire...........................................Bare supply wire
Black receiver wire (AC IN L)..................Black supply wire
White receiver wire(AC IN N)..................White supply wire
White receiver wire (TO MOTOR N).......White fan wire
Black receiver wire (TO MOTOR L)........Black fan wire
Blue receiver wire(FOR LIGHT)..............Blue light wire
AC SUPPLY
BLACK
WHITE
RECEIVER
BLUE
BLACK
WHITE
BLUE
BLACK
WHITE
RECEIVER
BARE
GREEN
Fig. C
Fig. D
|