Ge 29898 User Manual

WIRELESS MOTION SENSOR LED LIGHT BAR  
OWNER’S MANUAL  
Model # BRRC124M  
1
FIG. 1  
LOCATION OF CONTROLS:  
1. ON/OFF Tap Lens  
2. Manual/Motion Sensor Switch  
3. Pivoting Motion Sensor  
4. Battery Compartment  
2
3
4
INSTALLATION:  
Adhesive Tape:  
1. Make sure the area where you want to attach  
the light is clean and clear of debris and dust.  
2. Attach adhesive tape to mounting bracket (Fig. 2).  
3. Place mounting bracket in desired location.  
Press firmly to ensure adhesive sticks.  
FIG. 2  
CAUTION: Adhesive tape may remove paint or damage  
surface when removed.  
Screws:  
1. Remove mounting bracket from light.  
2. Use the mounting bracket as a guide to drill two (2) pilot  
holes. Secure mounting bracket to surface with screws  
(included). Do not over tighten screws.  
3. Attach light to mounting bracket.  
Attach adhesive tape here  
FIG. 3  
OPERATING INSTRUCTIONS:  
ON/OFF Tap Lens:  
1. Set manual/motion sensor switch to manual ( ) (Fig. 3).  
2. Press lens to turn light ON/OFF.  
Pivoting Motion Sensor:  
1. Set manual/motion sensor switch to motion sensor ( ) (Fig. 3).  
2. Pivot motion sensor to desired angle.  
Motion Sensor Manual  
3. Motion will turn the light ON for 30 seconds.  
Light will remain ON if motion continues.  
Light will turn OFF after 30 seconds if no motion is detected.  
Motion sensor only senses motion in darkness.  
Light may activate when batteries are inserted. Move light to a dark  
room, allow the light to adjust (up to 1 minute), then test motion sensor.  

Whirlpool Ace244pt1 User Manual
Schumacher Se 70ma User Manual
Savin 9027l User Manual
Ricoh Aficio Dsm620d User Manual
Nutone Video Door Vsm4rk User Manual
LG DG1 User Manual
FUJITSU SCANSNAP S1100 03 User Manual
CANON TS5100 User Manual
CANON S500 User Manual
ACER B103H User Manual