CRYSTAL VIDEO PRO 800 CC8980 User Manual

User Manual  
Version:1.5  
About the User Manual  
Contents  
About the User Manual  
02  
02  
02  
03  
04  
Brief Introduction  
Features  
Packing List  
Specification  
Structure & Interface  
05  
05  
07  
Wireless HD Transmitter:CC8980  
Wireless HD Receiver:CC3865  
Product Installation  
09  
09  
12  
Wireless HD Transmitter:CC8980  
Wireless HD Receiver:CC3865  
OLED Display Description  
14  
Support Full PSF Resolution  
Antenna Installation Recommendations  
Trouble Shooting  
16  
17  
20  
Compatible EDID 1.1, Support HDMI 1.3  
ATC_VITC ATC_LTC  
2-pin Lemo to DTap  
-10 ~ 50  
2-pin Lemo to DTap  
-10 ~ 50  
Product Installation  
OLED Display Description  
Sound Mode:mode 0,display nothing, mode 1 display melody logo.  
Support Full PSF Resolution  
Support Full PSF Resolution  
25PSF in = 25PSF out  
Gain state:H/L:  
"L" is low-gain mode,application for short distance transmission,  
good ability to anti-jamming;  
“H" is high-gain mode,application for long distance transmission,  
normal ability to anti-jamming;  
Wireless  
Video Connect: When connection failed ,displays nothing;  
When connection normally,displays"VIDEO"  
Antenna Installation Recommendations  
Recommended Installation Method under Non-ideal Position  
When the front side of the transmitter is not able to face to the receiver,  
please try to adjust the direction of transmitter antennas to make sure that the  
formative fan-shaped arrangement can face to the receiver for best signal  
transmission. As shown in the diagram 1 and diagram 2  
In order to get the best wireless communication quality and achieve  
the best transmission effec, the installation of the device should  
meet the following requirements.  
a. It is necessary to install transmitter and receiver at least 1.5 meters above groud.  
the height of receiver and transmitter should be conistent.  
(diagram 1)  
b. There is no barrier between transmitter and receiver  
c. The plane of transmitter antennas toward the plane of receiver antennas face-to-face,  
not vertical or oversized.  
Recommended Installation Method under Ideal Position  
Make receiver to stand vertically; adjust antennas to a fan-shaped arrangement;  
Make transmitter to stand vertically; adjust antennas to 90°angle in the same plane  
The plane of transmitter antennas toward the plane of receiver antennas face-to-face  
(diagram 2)  
Because TX and RX are working on ISM band,wireless transmission performance is relevant  
with level of interference intensity.If transmission performance declines,we recommend to  
switch the wireless channel of TX and RX simultaneously for improvement of transmission  
performance.  

Siemens Sql330 User Manual
Panasonic Cw Xc122vu User Manual
NEC NP PH1000U 02 User Manual
MAYTAG MHWE450WJ00 User Manual
Manual Handy Heater User Manual
HITACHI CP X340W User Manual
EPSON COLORWORKS C4050 User Manual
EMERSON FISHER 6354L User Manual
BLACK DECKER FIRESTORM PS130 User Manual
ASUS Y581C User Manual