R
+
SWRHK-65P
RADIO REPLACEMENT
SWC RETENTION
Radio Replacement with Steering Wheel Retention for
HYUNDAI and KIA Vehicles with 24 Pin Connector
INTERFACING SOLUTIONS
PRODUCT FEATURES:
- Retains factory features in select Hyundai and Kia vehicles while functioning with an aftermarket radio.
- Retains factory 3.5mm Aux Input Jack (if equipped).
- Pre-programmed to retain factory Steering Wheel Controls.
- Includes Hyundai/Kia antenna adapter.
- EIA color coded wiring for easy installation.
PARTS INCLUDED:
SWRHK-65P MODULE
SWRHK-65P HARNESS
ANTENNA ADAPTER
SWC CABLES
INSTALLATION DIAGRAM:
illumination (+)
Vehicle Speed Sensor
Antenna Turn ON
+12V Constant
+12V ACC
Orange
Red/White
Blue
AFTERMARKET
RADIO
Yellow
Red
Black
Ground
Right Front (+)
Right Front (-)
Left Front (+)
Left Front (-)
Right Rear (+)
Right Rear (-)
Left Rear (+)
Gray
Gray/Black
White
White/Black
Violet
Violet/Black
Green
HYUNDAI/KIA ANTENNA
ADAPTOR (Included)
HYUNDAI / KIA TYPE
SWC SETTING
AFTERMARKET
RADIO SELECTOR
(See Chart)
Left Rear (-)
Green/Black
(See Radio Type)
Audio Signal from 3.5mm Jack Aux-In Red & White RCA
ON
ON
SWC
1
2
3
1
2
3
MODULE
12-Pin Black
Connector
RADIO BRAND
(See Chart)
3.5MM SWC CABLES (Option A or B)
Use the proper 3.5MM to 4-Pin cable for your radio.
Plug in the selected 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS”section.
HYUNDAI / KIA
SWC
ON
OFF / ON / ON
1
2
3
TO FACTORY
HARNESS
Cap or insulate if
not being used
24-PIN
Connector
Note:
Option B:
BLUE / YELLOW
Insulate with tape
if not being used
Output signal(s) stated above may not cover all Year/Model.
Option A:
1 of 2
rev.051918
Crux Interfacing Solutions • 6860 Canby Ave., Suite 116, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
|