R
+
SWRHK-65E
RADIO REPLACEMENT
SWC RETENTION
Radio Replacement with Steering Wheel Retention for
HYUNDAI and KIA Vehicles with 24 & 18 Pin Connectors
INTERFACING SOLUTIONS
PRODUCT FEATURES:
- Retains factory features in select Hyundai and Kia vehicles while functioning with an aftermarket radio.
- Retains factory 3.5mm Aux Input Jack (if equipped).
- Pre-programmed to retain factory Steering Wheel Controls.
- EIA color coded wiring for easy installation.
PARTS INCLUDED:
SWRHK-65E MODULE
SWRHK-65E HARNESS
ANTENNA ADAPTER
SWC CABLE
INSTALLATION DIAGRAM:
illumination (+)
Vehicle Speed Sensor
Antenna Turn ON
+12V Constant
+12V ACC
Orange
Red/White
Blue
AFTERMARKET
RADIO
Yellow
Red
Black
Ground
Right Front (+)
Right Front (-)
Left Front (+)
Left Front (-)
Right Rear (+)
Right Rear (-)
Left Rear (+)
Gray
Gray/Black
White
White/Black
Violet
Violet/Black
Green
HYUNDAI/KIA ANTENNA
ADAPTOR (Included)
HYUNDAI / KIA TYPE
SWC SETTING
AFTERMARKET
RADIO SELECTOR
(See Chart)
Left Rear (-)
Green/Black
(OFF OFF ON ON)
Audio Signal from 3.5mm Jack Aux-In Red & White RCA
ON RADIO VEHICLE
SWC
MODULE
12-Pin Black
Connector
1
2
3
4
5
6
7
8
24 & 18
PIN Connectors
3.5MM SWC CABLE
Plug in the3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS”section.
TO FACTORY
HARNESS
4-Pin
Connector
Insulate with tape
if not used
Kenwood / JVC
Note:
Output signal(s) stated above may not cover all Year/Model.
1 of 2
rev.022221
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
|