CRUX SWRFD 60 User Manual

Rev. 050915  
RADIO REPLACEMENT W/SWC RETENTION FOR FORD, LINCOLN, MERCURY VEHICLES 2005-2012  
CONNECT THE WIRES,  
work. Following these instructions from “Start” to” Finish” will ensure  
OVERVIEW OF INSTALLATION  
COLOR FOR COLOR.  
SWRFD-60  
auxiliary Input (3.5mm Input)  
9:00 AM – 5:00 PM PDT at 1 (855) 822-1348. We are here to help.  
FORD  
2007 - 2010 Edge  
front left speakers  
front right speakers  
rear left speakers  
rear right speakers  
constant  
PARTS INCLUDED:  
2008 - 2012 Escape  
2007 - 2012 Expedition  
2006 - 2010 Explorer  
2007 - 2010 Explorer Sport Trac  
2009 - 2012 F-150  
2008 - 2012 F-250  
2008 - 2012 F-350  
2008 - 2012 F-450  
2005 - 2007 Five Hundred  
2008 - 2011 Focus  
2006 - 2007 Freestyle  
2006 - 2012 Fusion  
2005 - 2012 Mustang  
2008 - 2012 Taurus  
AFTERMARKET  
(1) FD-60 Analog SWC Interface Module  
(1) FD-60 Digital SWC Interface Module  
accessory  
RADIO  
ground  
(1) FD-60 24-Pin Harness  
(1) FD-60 Sub Harness  
(1) Instruction Sheet  
power antenna  
illumination  
vss  
4-PIN  
PRECAUTIONS:  
TO FACTORY  
HARNESS  
OPTION A  
OPTION B  
- Remove the negative side of the battery to avoid any short circuits  
during the installation.  
CAN-BUS  
- Do not install the interface near any major components or near the  
HVAC system. This may cause damage or overheating to the vehicle.  
INTERFACE  
16-PIN  
ON  
(male plug)  
12-PIN  
4-PIN  
1
2
3
CAN-RADIO  
TYPE  
PRELIMINARY:  
BLACK  
Please read the entire manual before installing this interface.  
(female plug)  
GRAY  
LINCOLN  
24-PIN  
(female plug )  
ON  
1
RADIO  
TYPE  
Before installing this interface please review the options before  
removing the factory radio. Some options may need to be adjusted  
prior to removing the factory radio.  
12-PIN  
(male plug)  
2009 - 2011 MKS  
2007 - 2010 MKX  
2007 - 2010 MKZ  
2007 - 2012 Navigator  
2006 - 2006 Zephyr  
(LH SIDE)  
2
3
ANALOG  
SWC  
12-PIN  
4-PIN  
INTERFACE  
ALL GRAY  
ON  
1
SWC  
TYPE  
(RH SIDE  
)
2
3
WIRING COLOR CODES  
SUB INPUT  
Black  
Red  
= Ground  
= Accessory (2A Max)  
= Constant  
(male plug)  
MERCURY  
8-PIN  
2007 - 2010 Mariner  
2006 - 2010 Milan  
2005 - 2010 Montego  
2006 - 2010 Mountaineer  
2008 - 2009 Sable  
(male plug)  
Yellow  
Orange  
Blue/White  
White  
White/Black  
Gray  
Gray/Black  
Green  
Green/Black  
Purple  
Purple/Black  
Red/Black  
Red/White  
Blue/Yellow  
= Illumination (100mA Max)  
= Antenna Turn-On  
= Left Front (+)  
= Left Front (-)  
= Right Front (+)  
= Right Front (-)  
= Left Rear (+)  
= Left Rear (-)  
= Right Rear (+)  
= Right Rear (-)  
= VSS  
= Reverse  
= SWC for Kenwood  
SETTING THE RADIO TYPE  
USING A RELAY  
This step is done on the module and only needed if the vehicle has  
steering wheel controls and you are installing one of the listed radios.  
The module has been rated for up to 2A max of output.  
For applications demanding a continuous output of 3A or more,  
we recommend using a standard BOSCH (SPDT) relay.  
See your local car audio specialist.  
switches are set on the analog module.  
Below is a diagram on how to install the BOSCH relay.  
DIP:  
1
2
3
RADIO TYPE:  
Pioneer/ Sony/ Jensen  
Alpine  
FUSE  
CAR 12V CONSTANT  
OFF ON ON  
OFF OFF OFF  
ON ON OFF  
ON ON ON  
ON OFF ON  
ON OFF OFF  
Clarion  
Kenwood  
JVC  
ON  
87  
SWC 4-PIN CONNECTORS  
The module allows for both type of SWC connections:  
Option A is used for the Alpine, Clarion, JVC, and Kenwood units.  
(Blue/Yellow wire attached)  
Blaupunkt  
1
2
3
87a  
30  
TO ACC 12V  
CHASSIS  
GROUND  
86  
85  
ANALOG SWC CONNECTION  
Option B is used for the Pioneer, and Sony units. (See Overview)  
If your vehicle is analog you will need to set both dip switches on the  
Analog module. Both the stereo type and the connection types need to  
be set on this module.  
Type 1: Vehicles with 4-Button: Vol +/ Vol -/ Memory/ Media  
Type 2: Vehicles with 4-Button: Vol +/ Vol -/ Next/ Media  
Type 3: Vehicles with 5-Button: Vol +/ Vol -/ Seek +/ Seek -/ Media  
Type 4: Vehicles with 6-Button: Vol +/ Vol -/ Seek +/ Seek -/ Media/ Mute  
Select the proper harness type for your aftermarket radio and  
connect the 4-pin molex to its proper connection.  
NEW ACC 12C (HIGH CURRENT  
DETERMINE IF THE VEHICLE IS ANALOG  
For the vehicles that have a BROWN and WHITE connection on the  
factory connector side, the SWC signal must come from the analog  
INSTALLATION TIPS  
1. Choose the correct interface for your vehicle (Analog or Digital)  
swc module.  
WHITE  
BROWN  
RADIO TYPE:  
Ford Type 1  
Ford Type 2  
Ford Type 3  
Ford Type 4  
DIP:  
1
2
3
that the new radio is getting power. If no power, please revise your  
wiring connections with multi-meter, available at your local dealer  
ON  
OFF OFF OFF  
OFF OFF OFF  
OFF OFF ON  
OFF OFF ON  
Set dip switches  
accordingly.  
Wire View  
1
2
3

White Rodgers Air Conditioner 100e78 User Manual
Sony Mpa Bt1a User Manual
Schumacher Se 125a User Manual
Samsung Clx 6200 User Manual
Mclane 20 Reel Mower User Manual
Lexmark X 4550 User Manual
HP ELITEBOOK X360 1040 G5 User Manual
FUJITSU PRIMERGY TX200 S2 02 User Manual
CRAFTSMAN 358.797550 User Manual
CRAFTSMAN 139.53992 User Manual