R
+
SWRCR-59D
RADIO REPLACEMENT
SWC RETENTION
Radio Replacement with Steering Wheel Control Retention
for Select Dodge, Fiat, Jeep and RAM Vehicles
INTERFACING SOLUTIONS
PRODUCT FEATURES:
- Retains factory features in select Dodge, Fiat, Jeep and RAM vehicles while functioning with an aftermarket radio.
- Retains Steering Wheel Controls via built-in, pre-programmed interface.
- Provides accessory power (2A Max).
- Retains factory backup camera (non LVDS systems only).
- Retains factory Aux input in select vehicles.
- Retains factory analog amplifier on select vehicles.
- Retains factory SWC phone button functionality in select vehicles.
- EIA color coded wiring for easy installation.
PARTS INCLUDED:
SWRCR-59D Module
SWRCR-59D Harness
SWC Cables
INSTALLATION DIAGRAM:
+12V Constant
Ground
Yellow
Black
Red
AFTERMARKET
RADIO
+12V ACC
Reverse Trigger
VSS (Vehicle Speed Sense)
Illumina�on (+)
Amplifier Turn-on
Right Front (+)
Right Front (-)
Red/White
Purple/White
Orange
Blue/White
Gray
Gray/Black
White
ON
Le� Front (+)
Le� Front (-)
Right Rear (+)
White/Black
Violet
1
2
3
Right Rear (-)
Le� Rear (+)
Violet/Black
Green
3.5MM SWC CABLES (Option A or B)
Use the proper 3.5MM to 4-Pin cable for your radio.
Plug in the selected 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS”section.
Le� Rear (-)
Green/Black
To Retain Factory Aux Input
To Retain Factory Backup Camera
Red/White RCA
Yellow RCA
12-Pin
Connector
4-Pin
Connector
To the aftermarket
radio 3.5mm SWC
port or SWC wires
Option B:
TO FACTORY
HARNESS
Cap or insulate if
not being used
BLUE / YELLOW
Insulate with tape
if not being used
Option A:
1 of 2
rev.030821
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
|