R
SWC RETENTION
SWR-100
INTERFACING SOLUTIONS
Universal Steering Wheel Control Retention Interface
PRODUCT FEATURES:
- Retains Steering Wheel Controls via built-in, pre-programmed interface.
- Provides +12 volt accessory output.
- Auto detect on CAN Bus vehicles.
- Retains VR Command (Voice Recogniꢀon) funcꢀon on select OEM steering wheel controls to acꢀvate
CarPlay and Android Auto compaꢀble devices.
- Works on the new generaꢀon Sony Radio with CarPlay funcꢀon.
PARTS INCLUDED:
SWR-100 Module
SWR-100 Harness
SWC Cable
SUPPORTED RADIOS:
Alpine
Boss
Clarion
Dual
Fahrenheit
Jensen
JVC
Kenwood
Pioneer
Power Acousꢀk
Sony
Soundstream
INSTALLATION DIAGRAM:
Ground
CAN Low
Black
Pink/Black
White/Red
Red/White*
Red
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See below for DIP switch settings.
iBus & GM LIN
ACC In
Cap or insulate if
not being used
ON RADIO VEHICLE
ACC Out
1
2
3
4
5
6
7
8
SWC Ground
+12V Constant
CAN High
Class II
Black
Kenwood/JVC (BLUE / YELLOW)
Insulate with tape
4-Pin
Connector
LIN BUS (Green)
Yellow
if not being used
Pink
Violet/White
SWC 1 Orange/Black
For aſtermarket radios without a 3.5mm jack for SWC:
SWC 2
SWC 3
Yellow/Black
Green/White
RED to SWC Key 1
WHITE to SWC Key 2
SHIELD to SWC Ground
SWC CABLE
Kenwood/JVC (BLUE / YELLOW)
(included in kit)
LIN BUS (Green)
*For vehicles with analog SWC, connect the Red/White wire to ACC to power the module.
For vehicle specific wiring diagram and connecꢀon, please visit:
1 of 2
rev.042318
Crux Interfacing Solutions • 6860 Canby Ave., Suite 116, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
|