CS Series
CS18 and CS14 LED LINEAR LUMINAIRE
8’ and 4’ LUMINAIRE
IMPORTANT SAFEGUARDS
INSTALLATION INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. Before installing this fixture or doing any maintenance, make sure to turn off the power
supply at the circuit breaker or fuse box.
2. Do not handle energized module with wet hands or when standing on wet or damp surfaces,
or in water.
3. Check to make sure that all the fixture connections have been properly made and
the fixture is grounded to avoid potential electrical shocks.
4. Product must be installed in accordance with NEC or your local electrical code. If you
are not familiar with these codes and requirements, consult a qualified electrician.
WARNING - Risk of Electric Shock. Suitable for damp locations. Maximum connected load with
a single power supply shall not exceed maximum ampacity rating of #12 AWG THHN through-
wire conductors. Use only lighting controls with relay or FET-based outputs, or lighting controls
options. Avoid handling LEDs directly. Not intended for use in environments containing airborne
corrosive agents such as chemical solvents, cleaners, or cutting fluids
• The CS Series LED linear luminaire is for suspended, with cable or threaded rod, or surface mount applications using appropriate tong
hangers. Reference individual mounting accessory installation instructions for specific mounting types.
• Designed for use in 120–277V, 50-60 Hertz protected circuit (fuse box, circuit breaker) and supply wire shall be rated minimum 12AWG,
600V, 90 C rated).
TO INSTALL:
NOTE: When removing luminaire from packaging,
keeping protective plastic wrap on fixture during
installation and construction.
1
2
FOR PLASTIC TONG HANGERS (TM):
NOTE: Center hole can accommodate 1/2” diameter
rod maximum.
STEP 1:
Remove cross brace and securely insert it into the
“+” shaped openings in the plastic tong hanger. See
Figures 1 & 2. For single units or end row fixtures, place
the plastic tong hanger assembly into center spine
no more than 18” from each end of fixture and twist
approximately 45 degrees until the plastic tong hanger
assembly is securely in place and approximately 90
degrees to the length of fixture. See Figure 3.
Cross Brace
Cross Brace
3
STEP 2:
For continuous row installation, continue with next fixture
using a minimum of one tong hanger per unit. Each
bracket should be properly snug and be difficult to slide
along the back spine.
18”
18”
FOR OPTIONAL METAL TONG HANGERS (TMM):
NOTE: Center hole can accommodate 3/8” diameter rod
maximum. Recommended for surface mount installations.
4
5
STEP 1:
For single units or end row fixtures, place metal tong
hanger bracket over center spine no more than 18” from
each end of fixture. See Figure 3. Insert supplied bolt
through the metal tong hanger and secure with lock
washer and nut, tightening to secure spine to the metal
tong hanger. See Figure 4 & 5. Additional suspension
points are optional depending on field conditions.
STEP 2:
For continuous row installation, continue with next
fixture using a minimum of one tong hanger per unit.
Each bracket should be properly snug and be difficult to
slide along the back spine.
1 of 2
LPN000106_D
|