Williams Sound Multiple Charger Chg 1269a User Manual

Multiple Charger Instructions  
Multiple Charger Case, Model CHG 1269A  
CHARGING INSTRUCTIONS  
Step 1: Plug the power supply into an AC wall outlet. Plug the power connector into the jack on  
the left side of the CHG 1269’s control panel.  
Step 2: Make sure the units you will charge are turned OFF. DO NOT attempt to recharge  
disposable batteries.  
Step 3: Plug a charger cord into the charge jack on each unit.  
Step 4: When all units are connected, push down the “Press to Charge” button on the CHG  
1269’s control panel. The red “CHARGE” indicator on the CHG 1269’s control panel  
will light during charging.  
Step 5: The CHG 1269 will charge the units for about 16 hours, then shut off automatically.  
Units may be fully charged before the green “DONE” indicator is lit. Units may be connected to  
the CHG 1269 Multiple Charger for more than 16 hours without harm. Williams Sound  
rechargeable 9 V and 6 V batteries can be charged on a daily or less frequent basis.  
EXPECTED BATTERY LIFE PER CHARGE  
9 V Rechargeable (BAT 003): 8 hours for a Receiver or PockeTalker, 3 hours for a Transmitter.  
6 V Rechargeable (BAT 021): 15 hours for a Receiver or PockeTalker, 10 hours for a Transmitter.  
IMPORTANT RECHARGEABLE BATTERY INFORMATION  
1.  
Rechargeable batteries are shipped in a discharged condition. They must be charged for  
12 - 14 hours before use. Follow the directions above to charge.  
2.  
Williams Sound 9 Volt products are designed for use with a NiMH rechargeable battery  
(BAT 003) and matching charger (BAT 004, BAT 005, CHG 1269). This is the only type  
of 9V rechargeable battery and charger we recommend. The BAT 003 has an 8.4 V  
nominal voltage and 100mAh capacity, compared to 7.2V and 60 mAh for other types of  
rechargeable “9V” batteries. The BAT 003 provides significantly longer battery life per  
charge than lower voltage batteries. Williams Sound 6 Volt products are designed for use  
with a special 6 V NiMH battery pack (BAT 021). The BAT 021 can be used with the  
BAT 005 Single Charger or the CHG 1269 Multiple Charger. OTHER CHARGERS  
SHOULD NOT BE USED.  
3.  
Do not mix batteries and chargers from different manufacturers. Using the BAT 003  
battery with chargers designed for lower-voltage batteries can result in under-charging  
and shorter battery life. Using the BAT 004, BAT 005, or BAT 012 Charger with low-  
voltage batteries can result in over-charging and battery failure.  
4.  
5.  
The CHG 1269 Multiple Charger can charge 6 Volt or 9 Volt Williams Sound products.  
6 Volt and 9 Volt units can be mixed in the CHG 1269.  
Do not dispose of batteries in fire. Do not open batteries - toxic chemicals inside.  
© 2006, Williams Sound Corp. FRM 411F  

Mitsubishi Mr Slim Pc42ek User Manual
Murphy Digital Time Meters Hd35 Dc User Manual
Roper 3 User Manual
Samsung As18cm1x User Manual
Samsung Basic 12b User Manual
Sanyo Kr 1500sc User Manual
Sanyo W 3way Eco I Chdzr09053 User Manual
Sears Aerocool Pd6801 User Manual
Smc Networks Robo Cylinder Ra7ad User Manual
Xantrex Technology Prosine Ps30 User Manual