F565206
Operating Instructions
Air Conditioner
CS-E24EKRS
CS-E28EKR
CU-E24EKR
CU-E28EKR
ENGLISH
Before operating the unit, read these operating instructions thoroughly and keep them for future reference.
2 ~ 9
Manufactured by:
© 2005 Panasonic HA Air-Conditioning (M) Sdn Bhd
(11969-T). All rights reserved. Unauthorized copying
and distribution is a violation of law.
Panasonic HA Air-Conditioning (M) Sdn. Bhd.
Lot 2, Persiaran Tengku Ampuan, Section 21, Shah Alam Industrial Site,
40300 Shah Alam, Selangor, Malaysia.
REGULATORY INFORMATION
■ Operation Condition
Use this air conditioner under the
following temperature range.
The appliance is not intended for use by young children or the infirm person without supervision. Young
children should be supervised to ensure that they do not play with the appliance.
Indoor
Temperature (°C)
Environmental Requirements
Environmental Requirements
*DBT *WBT
Maximum
Minimum
Maximum
Minimum
32
16
30
16
23
11
–
COOLING
HEATING
Battery Disposal
The batteries must be recycled or disposed of properly.
–
Outdoor
Temperature (°C)
Maximum
*DBT *WBT
End-of-Life Disposal
End-of-Life Disposal
43
16
24
-5
26
11
18
-6
COOLING
Minimum
Maximum
Minimum
HEATING
*DBT: Dry bulb temperature
*WBT: Wet bulb temperature
“Instructions for end-user” for air conditioners:
Information on Disposal in other countries outside the European Union
This symbol is only valid in the European Union. If you wish to discard this product, please contact
your installer, dealer or local authority and ask for the correct method of disposal.
Note:
The illustrations in this manual
are for explanation purposes only
and may differ from the actual unit. It
is subjected to change without notice
for future improvement.
3
PRODUCT OVERVIEW
■ About
Remote Control Preparation
Air intake
Indoor Unit
Indoor Unit
1. Pull out
the cover.
Supersonic air
purifying device
Auto OFF/ON
button
Front panel
Air filter
R
SUPE
USTER
-B
U
N
LER
AL
WER
PO
2. Insert AAA or R03
batteries.
UIET
Q
TIMER
WER
PO
Receiver
3. Close the cover.
4. Press CLOCK.
5. Press to
set time.
TIMER
ON
SET
3
Indicator
Airflow direction
louver
1
2
OFF
CANCEL
AC
RC
SET CHECK COCK
RESET
Ionizer
Do not touch
during operation
Discharged air
6. Press again.
• Timer operation will be based on
current time set.
Outdoor Unit
Outdoor Unit
Air inlet (rear)
• The batteries can be used for
approximately 1 year.
Remote Control Signal
Air inlet (side)
• Make sure it is not obstructed.
• Maximum distances: 10m
Air outlet
• Certain fluorescent lights may
interfere with signal transmission.
Please consult your nearest dealer.
Transmitter
Remote Control
Remote Control
Auto OFF/ON Button
Action
Mode
Press once.
Automatic
Press and hold
until you hear
one beep, then
release.
LCD display
Off/On
Cooling
Heating
Ion operation
Operation mode
Quiet Operation
Press and hold
until you hear
one beep then
release.
Press and hold
again until you
hear two beeps
then release.
Temperature setting
Fan Speed selection
Timer setting
Powerful Operation
Airflow direction
adjustment
Check
• To turn off, press the AUTO OFF/ON
button again.
Clock setting
* For normal operation, the and reset buttons are not in use.
* Press reset button to restore the remote control’s default setting.
Troubleshooting
● In the event of an error, the unit will stop and the timer indicator will blink.
Notes:
2. Press until you hear beep
sound, then jot down the
error code.
1. Press for 5 seconds.
• The unit may be operable (with 4 beeps)
on a limited basis, depending on the error.
TIMER
ON
SET
3
3. Press for 5 seconds to quit
checking.
1
2
OFF
CANCEL
AC
RC
SET CHECK CLOCK
RESET
4. Turn the unit off and reveal the
error code to your nearest dealer.
4
AUTO, HEAT, COOL, DRY
■ Operation Details
AUTO - Automatic Operation
• Unit selects the operation mode
according to temperature setting,
outdoor and room temperature.
• The power indicator blinks during
operation.
1
• Operation mode is reselected
every 30 minutes.
Start the
operation.
HEAT - Heating Operation
• In heating mode, it takes a while
for the unit to warm up. The
power indicator blinks during this
operation.
2
AUTO
HEAT
COOL
DRY
FAN
SP
Select the
desired
COOL - Cooling Operation
• Enjoy cool air at your desired
temperature.
IR
SWING
operation.
ION
DRY - Soft Dry Operation
• Keeps your environment
dehumidified by running a very
gentle cooling operation.
OFF/ON
MODE
ion
QUIET
• During soft dry operation, the
indoor fan operates at low fan
speed.
TEMP
POWERFUL
FAN SPEED
AIR SWING
TIMER
ON
SET
3
■ Hint
3
• A temperature setting 1°C higher
in cooling operation or 2°C lower in
heating operation than the desired
temperature equates to a 10%
power saving.
1
2
Set the
temperature.
(16°C~30°C)
OFF
CANCEL
AC
RC
SET CHECK CLOCK
RESET
INVERTER
● Supersonic air purifying device (super alleru-buster) operates
automatically once the unit is switched on.
●
●
,
and
operations are available in all modes.
Press
again to stop the operation.
Troubleshooting
● Mist emerges from indoor unit.
► Condensation effect due to cooling process.
●
► Ensure temperature is set correctly.
Heating/Cooling operation does not work.
► Make sure windows and doors are closed.
► Make sure filters are cleaned and replaced.
► Make sure inlet and outlet vents are cleared.
● Water flowing sound during operations.
► Cause by refrigerant flow inside the unit.
● The power indicator blinks during the operation and
the indoor fan is stopped.
► The unit is in defrost mode, and the melted frost is drained from the
outdoor unit.
5
FAN SPEED, AIR SWING
■ Operations Details
• There are 5 fan speeds, as well as
automatic*.
* For automatic fan speed, the speed
of the indoor fan is automatically
adjusted according to the operation.
AIR SWING
Select fan
speed.
• Keeps the room ventilated.
• There are 5 options for vertical/
horizontal airflow direction.
• Do not adjust the vertical and
horizontal louvers by hand.
AUTO
HEAT
COOL
DRY
FAN
SPEED
AIR
SWING
Adjust the
airflow
direction louver.
ION
• If automatic vertical airflow direction
has been set, the louvers swing up
and down automatically.
OFF/ON
MODE
ion
• For HEATING operation, the air
blows horizontally for a while, then
starts to blow downwards.
QUIET
TEMP
POWERFUL
FAN SPEED
• If automatic horizontal airflow
direction has been set, the louvers
swing left and right automatically.
AIR SWING
TIMER
ON
• For HEATING operation, the airflow
louvers start to swing left/right after
the temperature rises.
SET
3
1
2
OFF
CANCEL
AC
RC
SET CHECK CLOCK
RESET
INVERTER
Troubleshooting
● The room has a peculiar odour.
► This may be a damp smell emitted by the wall, carpet, furniture or
clothing.
● Indoor fan stops occasionally during automatic fan
speed setting.
► This helps to remove the surrounding odours.
● Indoor fan stops occasionally during heating
operation.
► To avoid unintended cooling effect.
6
POWERFUL, QUIET, ION
■ Operations Details
• To achieve setting temperature
quickly.
• To provide a quiet environment.
Enables
quiet
operation.
Enables ion
operation.
• This setting provides fresh air effect
by producing negative ion.
AUTO
HEAT
COOL
DRY
FAN
SPEED
• Ion operation can be activated
independently. Press
off the operation.
to turn
AIR
SWING
ION
OFF/ON
TEMP
MODE
ion
■ Hint
QUIET
• To reduce power consumption, close
the curtains when operating air
conditioner to prevent the sunlight
and heat from coming in.
POWERFUL
FAN SPEED
AIR SWING
TIMER
ON
SET
3
1
2
Enables
OFF
CANCEL
powerful
operation.
AC
RC
SET CHECK CLOCK
RESET
INVERTER
●
●
and
same time.
operations could not be activated at the
and operations could be cancelled by
,
pressing the respective button again.
Troubleshooting
● Noisy during operation.
► The unit may have been installed at an incline, or the front panel is not
closed properly.
● Operation is delayed a few minutes after restart.
● Outdoor unit emits water/steam.
► The delay is a protection to the unit’s compressor.
► Condensation or evaporation occurs on pipes.
● ION indicator on the indoor unit is blinking.
► Press
twice. If the indicator is still blinking, please consult your
nearest dealer.
7
TIMER
■ Operation Details
• The timer allows you to turn the air
conditioner on or off automatically.
• The unit may start in preliminary
operation before the actual set time
when ON timer has been set.
• The set timer repeats daily once
set.
• If there is a power failure, you can
restore the previous setting (once
power is resumed) by pressing the
button.
AUTO
HEAT
COOL
DRY
FAN
SPEED
2
• If the timer is cancelled, press
to restore the previous setting.
Set the
desired time.
AIR
SWING
ION
1
Select ON or
OFF timer.
OFF/ON
MODE
ion
■ Hints
QUIET
• Press and hold the
for
3
approximately 5 seconds to set
either 12-hour (am/pm) or 24-hour
time indication.
TEMP
POWERFUL
FAN EED
Confirm the
setting.
• To dim the indicator display:
AIR SWN
MER
N
SET
3
Press and
hold for 5
seconds.
1
2
TIMER
ON
To cancel,
press the
SET
3
OFF
ANCEL
1
2
AC
RC
again
for 5 seconds.
OFF
CANCEL
AC
RC
SET CHECK LOCK
RESET
SET HECK CLOCK
RESET
INVERTER
• To switch the temperature setting
to °C or °F, press and hold
approximately 10 seconds.
for
Cancel the
selected timer.
● The timer is valid only when the clock is set correctly.
● You can set your preferred time for ON and OFF timers.
The unit will turn ON or OFF automatically.
● To cancel ON or OFF timer, press
.
or
, then press
Troubleshooting
● Timer indicator always on.
● Remote control does not work.
● The unit does not work.
► The timer setting repeats daily once set.
► The batteries are inserted incorrectly or need replacing.
► The circuit breaker is tripped or the timer is set incorrectly.
● Power indicator blinks before the unit is switched on. ► This is a preliminary step in preparation for the operation when the ON
timer has been set.
8
CARE & CLEANING
■ Washing Instructions
• Do not use benzene, thinner or
scouring powder.
Switch off the power supply
before cleaning
• Use only soaps or neutral household
detergent ( pH7).
≃
• Do not use water hotter than 40°C.
FRONT PANEL
FRONT PANEL
Raise and pull to remove.
Wash and dry.
INDOOR UNIT
• Wipe the unit gently with a soft, dry
cloth.
AIR FILTER
AIR FILTER
AIR FILTER
• Air filters cleaning is needed every
two weeks.
Vacuum, wash and dry.
• Replace any damaged filters.
Part no: CWD001137 (Left)
CWD001138 (Right)
SUPER ALLERU-BUSTER
Remove
• It is recommended to clean this filter
every 6 months.
• Replace the filter every 3 years or
replace any damaged filters.
Part no: CZ-SA13P
Remove
IONIZER
• Ionizer cleaning is recommended
every 6 months.
INDOOR
INDOOR
UNIT
UNIT
Wipe gently.
■ Hints
• Clean the filter regularly for best
performance and to reduce power
consumption.
SUPERSONIC AIR
SUPERSONIC AIR
PURIFYING DEVICE
PURIFYING DEVICE
• Please consult your nearest dealer
for seasonal inspection.
Vacuum the super
alleru-buster filter.
IONIZER
Clean with cotton
bud.
IONIZER
Remove
Vacuum, wash and
dry the frame.
■ For extended non-use
• Activate heating for 2~3 hours to thoroughly dry the unit.
• Turn off the power supply.
• Remove the remote control batteries.
9
SEASONAL INSPECTION AFTER EXTENDED NON-USE:
• Checking of remote control batteries.
• No obstruction at inlet and outlet vents.
• After 15 minutes of operation, it is normal to have the following temperature difference between inlet and outlet vents:
Cooling: ≥ 8°C
Heating: ≥ 14°C
10
NON SERVICEABLE CRITERIAS
TURN OFF POWER SUPPLY and CALL Authorized Distributor under the following conditions:
• Abnormal noise during operation.
• Circuit breaker switches off frequently.
• Power cord becomes unnaturally warm.
• Switches or buttons are not functioning properly.
• Water/foreign particles have entered the Remote Control.
• Water leak from Indoor unit.
11
Printed in Malaysia
OPTH0510-00
Matsushita Electric Industrial Co., Ltd.
F565206
|