W1214, W1215, W1216, W1217
PLANER PAL® KNIFE SETTING JIG
INSTRUCTIONS FOR USE
Planer Preparation
1.
2.
3.
Disconnect the planer from its power source.
Remove the planer’s dust cover.
Remove the chip deflector and loosen the springs holding the chipbreaker down, if necessary. Loosening the
springs will allow the chipbreaker to be raised to expose a larger portion of the cutterhead, where space is a limiting
factor.
IMPORTANT: Do not loosen or remove the dull knives before reading instructions for jig
preparation.
If your planer has:
Knives up to 20"
Knives 21" or more
You should use:
Two PLANER PAL® Jigs
Three PLANER PAL® Jigs
Jig Preparation
The middle bar of each Planer Pal® Jig is adjustable to match the height of the knives currently in your planer. By pre-
adjusting each jig to match the height of your knives, you can be assured of consistent results every time you reset your
planer’s knives. To pre-adjust your Planer Pal® Jigs:
1.
2.
Loosen the setscrews that allow the middle bar to slide up and down.
Position the first jig over a blade, right in the middle of the cutterhead. Make sure the middle bar contacts the knife
edge and that the end bars contact the cutterhead securely. (Make a habit of wiping the magnets before using to
ensure that no metal filings get between the magnets and the cutterhead.)
Setscrew
3.
4.
With the jig properly positioned, carefully tighten the setscrews that lock the
middle bar in place.
Mid point of
Center Bar
Remove the first jig and follow the same process for the remainder
of your jigs, making sure that you place additional jigs in the exact
same spot where you adjusted the first. This will result in excel-
lent standardization between all of your jigs as you reset your
knives.
REMEMBER: To get absolute consistency, it’s essential you place
each jig in the same position on each knife. Otherwise, your knife
heights could vary slightly from end to end.
Copyright © 1998, Woodstock International, Inc. 10/05
7646
Download from Www.Somanuals.com. All Manuals Search And Download.
|