Top-Loading Washer
PRODUCT MODEL NUMBERS
OVERALL DIMENSIONS
Washer dimensions
WTW4900X, WTW5500X,
WTW5550X, WTW5600X,
WTW5640X, WTW5700X,
WTW4800X, WTW4950X,
WTW4910X, WTW5610X
271/2"
(699 mm)
27"
(686 mm)
For closet installation, with a door,
the minimum ventilation openings
in the top and bottom of the door
are required. Louvered doors with
equivalent air ventilation openings
are acceptable.
Electrical: A 120 volt, 60 Hz., AC only, 15- or 20-amp,
fused electrical supply is required. A time-delay fuse
or circuit breaker is recommended. It is recommended
that a separate circuit serving only this washer be
provided.
42"
(1067 mm)
DRAIN SYSTEM
Floor standpipe drain system
3"
(76 mm)
41/2"
30"
(114 mm)
(762 mm)
48 in.2
Minimum diameter for a standpipe drain: 2" (51 mm).
Minimum carry-away capacity: 17 gal. (64 L) per minute.
Top of standpipe must be at least 39" (990 mm) high;
install no higher than 96" (2.44 m) from bottom of washer.
If you must install higher than 96" (2.44 m), you will need
a sump pump system.
14" max.
(356 mm)
(310 cm2)
17"
(432 mm)
Wall standpipe drain system
24 in.2
(155 cm2)
5"
(126 mm)
41/2"
(114 mm)
1"
(25 mm)
3"
(76 mm)
1"
(25 mm)
See requirements for floor standpipe drain system.
Floor drain system
Dimensions show recommended spacing allowed, except for closet door ventilation
openings which are minimum required. This washer has been tested for installation with
spacing of 0" (0 mm) clearance on the sides. Consider allowing more space for ease of
installation and servicing, and spacing for companion appliances and clearances for walls,
doors, and floor moldings. Add spacing of 1" (25 mm) on all sides of washer to reduce
noise transfer. If a closet door or louvered door is installed, top and bottom air openings in
door are required.
Minimum capacity: 20 gal. (76 L).
Top of laundry tub must be at least
39" (990 mm) above floor; install
no higher than 96" (2.44 m) from
bottom of washer.
Laundry tub drain system
Floor drain system requires a Siphon Break Kit
(Part Number 285834), 2 Connector Kits (Part
Number 285835), and an Extension Drain Hose
(Part Number 285863) that may be purchased
separately. To order, please see toll-free phone
numbers in your Use and Care Guide. Minimum
siphon break: 28" (710 mm) from bottom of
washer. (Additional hoses may be needed.)
IMPORTANT: To avoid siphoning,
no more than 4.5" (113 mm) of drain
hose should be inside standpipe or
below the top of wash tub. Secure
drain hose with cable tie.
41/2"
(114 mm)
30"
(762 mm)
W10240509C
06/2011
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Download from Www.Somanuals.com. All Manuals Search And Download.
|