R
Item no. 2012
Industriaal Line
TM
WATT
5000
User's Manual
Download from Www.Somanuals.com. All Manuals Search And Download.
Industrial Line 5000 Watt Power Inverter by Wagan Tech
USER’S MANUAL — Please read before using this equipment.
_______________________________________________________________________________________________________________________
INSTALLATION
Where to install
Grounding
The power inverter has a lug on the rear panel marked
“chassis ground”. This is to connect the chassis of the
power inverter to the ground. The ground terminals in
the AC outlets on the front panel of the inverters are also
connected to the ground lug.
The power inverter should be installed in a location that
meets the following requirements:
a. Dry- Do not allow water to drip or splash onto the
inverter
b. Cool- Ambient air temperature should be between
0C and 40C, the cooler the better
c. Ventilation- Allow at least 2 inches of clearance
around the inverter for airflow. Ensure the ventilation
openings on the rear and bottom of the unit are not
obstructed.
d. Safety- Do not install the inverter in the same
compartment as batteries or in any compartment
capable of storing flammable liquids such as
gasoline.
The chassis ground lug must be connected to the
grounding point, which will vary depending on where the
power inverter is installed. In a vehicle, connect the
chassis ground to the chassis of the vehicle. In a boat,
connect to the boat’s grounding systems. In a fixed
location, connect the chassis ground lug to earth.
The neutral (common) conductor the power inverter AC
output circuit is connected to the chassis ground.
Therefore, when the chassis is connected to the ground,
the neutral conductor will also be grounded. This
conforms to the national electrical code requirements the
separately derived AC sources (such as inverters and
generators) have their neutral tied to ground in the same
way that the neutral conductor from the utility line to
ground at AC breaker panel.
Cables
DC to AC inverters requires high amperage/low
voltage DC power to low amperage/high voltage
AC power. To operate properly connect inverter DC
input terminals direct to battery with heavies wire
available see chart below:
Caution
The negative DC input of the power inverter is
connected to the chassis. Do not install the power
inverter in a positive ground DC system. As positive
ground DC system has the positive terminal of the
battery connected to the chassis of the vehicle or to the
ground point.
3
© 2003 Wagan Corporation.
All Rights Reserved.
Wagan and Wagan.com are trademarks used by Wagan Corporation.
Printed in China
Download from Www.Somanuals.com. All Manuals Search And Download.
Industrial Line 5000 Watt Power Inverter by Wagan Tech
USER’S MANUAL — Please read before using this equipment.
_______________________________________________________________________________________________________________________
QUICK HOOK UP AND TESTING
load into the AC receptacle on the front panel of the
inverter. Leave the test load switch off.
If you would like to quickly hook up the power inverter
and check its performance before going ahead with your
installation, please follow these guidelines:
8. Set power inverter switch to the ON position and
turn the test load on, the inverter should supply
power to the load. If you plan to measure the true
output R.M.S. voltage of inverter, a meter such as
FLUKE 87A, BACKMAN 4410 or TRIPLETT 4200
must be used.
1. Unpack and inspect the power inverter, check to see
that the power switch in the OFF position.
2. Connect the cable to the power input terminals on
the rear panel of power inverter. The red terminal is
positive (+) and black terminal is negative (-).
Connect the cable into the terminals and tighten the
wing nut to clamp the wires securely.
CAUTION:
•
DO NOT USE THE INVERTER IN A POSITIVELY
GROUNDED VEHICLE.
3. Connect the cable from the negative terminal of the
inverter to the negative terminal of the power source.
Make a secure connection.
RECOMMENDATION
•
If the power inverter makes a beeping sound, turn
OFF the power inverter and disconnect all
appliances from inverter and disconnect the inverter
from power supply. The beeping sound is simply the
low battery warning, which indicates that the voltage
of the battery power supply is getting low. Please
restart the vehicle engine before operating the
power inverter.
Caution
Loosely tightened connectors result in excessive
voltage drop and may cause overheated wires and
melted insulation.
4. Before proceeding further, carefully check that the
cable you have just connected connects from the
negative terminal of inverter to the negative output
terminal of the power source.
•
•
When you are not using the inverter, turn the power
switch to OFF and disconnect the inverter from
power supply.
Disconnect the inverter when starting the vehicle’s
engine.
5. When connecting the inverter directly to your battery
terminals, it is important to connect with right polarity
(connect ♁ from inverter to ♁ of battery terminal
and connect ⊖ from inverter to ⊖ of battery terminal)
CAUTION:
THE FOLLOWINGS OPERATION WILL DAMAGE AND
VOID THE WARRANTY OF THE INVERTER:
Warning
You may observe a spark when you make this
connection since current may flow to charge
capacitors in the power inverter. Do not make this
connection in the presence of flammable fumes, as
explosion or fire may result.
•
REVERSE POLARITY BY CONNECTING THE
WIRES TO THE INCORRECT TERMINALS.
CONNECTING THE BATTERY CHARGER TO
REPLENISH BATTERY WITHOUT
•
DISCONNECTING THE INVERTER FIRST.
CONNECTING THE INVERTER TO POWER
SOURCE GREATER THAN 15-VOLT DC.
OPERATING THE INVERTER AND BATTERY IN
OR AROUND WATER.
•
•
6. Set the power switch to the ON position. Check the
meters and indicators on the front panels of the
inverters. The voltage bar graph should indicate 11
to 14 volts, depending on the voltage of the power
source. If it does not, check your power source and
the connections to inverter. The other indicators
should be off.
7. Set power inverter switch to the OFF position, the
indicator lights may blink and the internal alarm may
sound momentarily. This is normal. Plug the test
4
© 2003 Wagan Corporation.
All Rights Reserved.
Wagan and Wagan.com are trademarks used by Wagan Corporation.
Printed in China
Download from Www.Somanuals.com. All Manuals Search And Download.
Industrial Line 5000 Watt Power Inverter by Wagan Tech
USER’S MANUAL — Please read before using this equipment.
_______________________________________________________________________________________________________________________
MEASURING THE AC VOLTAGE
SAFETY PRECAUTION
The output waveform of the AC inverter is a MODIFIED
SINEWAVE. To measure the AC output voltage, you
must use a TRUE RMS VOLTMETER.
Do not open the case of the inverter. The high voltage
inside the unit is the same type of power as your
electrical outlets at home.
Do not let the cord of the inverter or any appliance’s cord
get wet.
Do not operate the inverter in or around water. The
voltage of the unit makes electrical shock hazard if
operated in wet conditions.
Do not connect the AC inverter directly to another AC
power source.
Keep it away from children, the inverter produces power
just like your AC wall outlets at home and should be
treated seriously.
RECOMMENDED BATTERY CONFIGURATION FOR
HEAVY-DUTY APPLICATION
Allow at least 2 inch of clearance around the inverter for
airflow.
If you operate the inverter in a moving vehicle, you need
to secure the inverter to prevent it from shifting around
while the vehicle is moving.
If there is anything wrong with the inverter, disconnect all
of the power.
Heavy-duty alternators rated above 120 Amps should be
used and they are available from RV, marine or auto
parts suppliers. These alternators are designed to
directly replace standard alternators but produce the
higher current and voltage required to charge multiple
battery systems.
An isolator is used to separate the vehicle’s system
batteries and the auxiliary batteries.
We recommend using the same deep cycle type of
batteries in the battery banks.
Notes
The above system should be installed properly. You
need to contact the RV or auto experts for some
instructions.
5
© 2003 Wagan Corporation.
All Rights Reserved.
Wagan and Wagan.com are trademarks used by Wagan Corporation.
Printed in China
Download from Www.Somanuals.com. All Manuals Search And Download.
Industrial Line 5000 Watt Power Inverter by Wagan Tech
USER’S MANUAL — Please read before using this equipment.
_______________________________________________________________________________________________________________________
TROUBLESHOOTING
HEAT DISPERSAL
The inverter generates heat while it is working. This is
not a malfunction. However, if the inverter gets too hot
while working, it will turn off by itself.
Position the inverter where air flows freely around it to
allow the heat to disperse.
The inverter’s thermal protection prevents it from
operating when its temperature exceeds 130 ± 10 °F / 55
± 5 °C.
Condition
Solution
Poor contact
Battery voltage is
too low
Clean contact parts thoroughly
Start the engine to recharge the
battery. Replace the battery if
needed.
Shutdown on
overload
Reduce the wattage of inverter’s load
Thermal shutdown Allow the inverter to cool down by
reducing the load or turn it off for a
SPECIFICATION
while.
Receptacle has no Check the receptacle wiring.
power
Name
Description
12V (10-15V) DC
Input
Output
115V AC
MAINTENANCE
Output waveform
Continuous power
Surge power
Modified Sine Waveform
5000 Watt
10000 Watt
Approx. 90 %
< 0.3 A
10.5 ± 0.5 V DC
10 ± 0.5 V DC
4 outlets of 3-prong
DC input ON/OFF control
20x9x7 in³
Very little maintenance is required to keep the inverter
operating properly.
Efficiency
No load current
Battery low alarm
Battery low shutdown
AC output socket
Power switch
DESCRIPTION
10000W Peak Power — allow you to power appliances
that require a large amount of initial (peak) power to
work (such as many TVs and motor-power equipments).
Dimensions
Net Weight
22 lb
Low Battery Alarm — the inverter sounds an audible
alarm then turns itself off if the source battery becomes
too low.
NOTE
All specifications are typical at nominal line, half load,
and 77° F / 25° C unless otherwise noted. Specifications
are subject to change without notice.
Auto Shutdown/Reset Protection — the inverter shuts
itself down to protect from low battery drained.
Overload/Short Circuit Protection — the inverter
automatically turns itself off if the connected load is too
high or if it shorts.
Fuse — the inverter comes with fuse/s already installed.
4 AC Outlets — allows you to power up many
appliances at the same time.
6
© 2003 Wagan Corporation.
All Rights Reserved.
Wagan and Wagan.com are trademarks used by Wagan Corporation.
Printed in China
Download from Www.Somanuals.com. All Manuals Search And Download.
WAGAN Corp. Limited Warranty Registration Form
All WAGAN Corporation products are warranted to the original purchaser of this product.
Warranty Duration: This product is warranted to the original purchaser for a period of one (1)Year
from the original purchase date, to be free of defects in material and workmanship. WAGAN
Corporation disclaims any liability for consequential damages. In no event will WAGAN
Corporation be responsible for any amount of damages beyond the amount paid for the product
at retail. In the even of a defective item, please ship the item, prepaid, with a complete
explanation of the problem, your name, address and daytime phone number. WAGAN
Corporation will, at its option, replaces or repair the defective part. This warranty is void if the
product has been damaged by accident, in shipment, unreasonable use, misuse, neglect,
improper service, commercial use, repairs by unauthorized personnel or other causes not arising
out of defects in materials or workmanship. This warranty is effective only if the product is
purchased and operated in the USA and does not extend to any units which have been used in
violation of written instructions furnished.
Warranty Disclaimers: This warranty is in-lieu of all warranties expressed or implied and no
representative or person is authorized to assume any other liability in connection with the sale of
our products. There shall be no claims for defects or failure of performance or product failure
under any theory of tort, contract or commercial law including, but not limited to negligence,
gross negligence, strict liability, breach of warranty and breach of contract.
Warranty Performance: During the above one (1)Year warranty period, a product with a defect
will be replaced with a comparable model when the product is returned to WAGAN Corporation
with an original store receipt. The replacement product will be in warranty for the balance of the
one (1)Year warranty period.
Please activate my limited warranty for WAGAN Corp.5000 Watt Industial Power Inverter
Enclosed copy of original sales receipt.
Name
Mail Address
City
State, Zip Code
Item Purchased 5000 Watt Industrial AC to DC Power Inverter
Stores Name
Date of Purchase
Signature
Date
All WAGAN Corporation Products must be registered within (30) days of purchased to activate this warranty.
Mail the complete registration form, along with a copy of the original receipt to:
Attn: Customer Service
WAGAN Corporation
3589Yale Way
Fremont, CA 94538
c 2003 WAGAN Corp.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
|