Electrical Requirements
General Information
• Oven requires a separate, grounded
4-wire, 240V (AC), 30 amp (single ovens)
and 50 amp (double ovens) service with
its own circuit breaker.
• This unit is equipped with a No. 10
• All openings in the wall behind the
appliance or in the floor under the
appliance should be sealed.
• Detach the product from the metal anchor
ground wire in the conduit.
strip by removing the attachment screw.
• The electrical conduit must be kept to the
top left for a flush installation. NEVER cut
the conduit.
• DO NOT remove the protective wrapping
from the product control panel until the
product is installed.
• Keep appliance area clear and free from
combustible materials, gasoline and other
flammable vapors.
• Wire sizes and connections must conform
with the rating of the appliance and to the
requirements of the National Electrical
Code, ANSI/NFPA 70 – latest edition, or
Canadian Electrical Code, CSA
• Connect the flexible armored cable
directly to 4-wire, 240V household service.
If codes permit and separate grounding
wiring is used, we recommend that a
qualified electrician determine the
Recommendations for Moving
• Disconnect the electrical supply prior to
servicing or cleaning.
CAUTION
C22.1-1982 and C22.2 No. 01982 –
latest edition, and all local codes and
ordinances.
• When removing the appliance for cleaning
or service, disconnect AC power supply
and carefully remove the appliance by
pulling forward.
The oven is heavy—use extreme care
when handling.
grounding path and that the wire gauge is
in accordance with local codes.
• Oven must be connected to the proper
electrical voltage and frequency as
specified on the model/serial rating plate
(located inside the vent ont the right sode
of the oven).
• Junction boxes installed on rear wall
directly behind oven must be recessed .
WARNING
• Electrical requirements are listed in the
product specifications under the electrical
requirements section.
DO NOT use the handle or oven door
to lift the oven. Remove door before
installation to ensure that it is not used to
lift the unit. DO NOT lift or carry the door
by the handle.
• A UL-Listed conduit connector must be
provided at the junction box.
• Oven must be connected to grounded
metal permanent wiring system. Check
with a qualified electrician to make sure
the oven is properly grounded.
Recommendations for Unpacking
• Products are shipped on pallets with foam
footings and corrugated inner-packing
and exterior hoods.
• DO NOT install a fuse in the neutral or
grounding circuit. We recommend a time-
delayed fuse or circuit breaker. Connect
directly to the fused disconnect (or circuit
breaker box) through flexible armored, or
non-metallic sheathed, copper cable (with
grounding wire).
• Only proper equipment should be used to
move products.
• DO NOT ground to a gas pipe.
• Products are anchored to the pallet using
metal straps that are screwed to the
bottom of the product and the pallet.
• DO NOT use an extension cord with this
appliance, because this may result in
electrical shock or other personal injury.
• ALWAYS take steps to protect flooring at
the installation location when moving
products.
• DO NOT remove protective packaging
until you are ready to perform the
installation.
• To remove the packaging, first remove the
staples located at the bottom perimeter
of the corrugated cover.
• Remove the corrugated cover by lifting
it off the product and remove the inner-
packing.
10
11
Download from Www.Somanuals.com. All Manuals Search And Download.
