VH02
Sanitizing Sweeper
with Verilux® SaniClean Lightwave Technology™
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPORTANT SAFETY INSTRUCTIONS
We appreciate you purchasing the Sanitizing Sweeper. Before using this
product, please study this manual carefully to avoid any damage to the
product or to you.
• Before using, please make sure the Sweeper is securely assembled.
• The Sweeper is not intended for use by children under 8 years of age.
• Do not use flammable or combustible liquids to clean the sweeper.
• The sweeper contains a rechargeable 4.8v Ni-MH battery. Please be
sure to fully charge the battery for 12 hours prior to initial use and do
not leave on charger for longer than 24 hours. Old batteries should be
disposed of properly and never incinerated.
• Do not use the Sweeper to clean any burning or heated materials
such as cigarettes, matches, ash or any flammable liquids, such as
gasoline. Use on dry surfaces only.
• Keep fingers, hair, all other body parts and clothes away from rotating
cleaning brushes.
• Do not use wet hands to touch battery or battery parts directly.
• Do not use the sweeper to clean shag carpet, wet floors or rough
stone or concrete surfaces. The Sweeper should be used on hardwood
and low-pile carpeted floors only.
• Before cleaning the dust from the dust bin, turn off the power.
• The Sweeper employs a powerful UV-C light source to kill household
germs. The Sweeper should never be turned over when turned on and
the light allowed to shine in eyes or on exposed skin.
SAVE THESE INSTRUCTIONS
2
Download from Www.Somanuals.com. All Manuals Search And Download.
ASSEMBLY INSTRUCTIONS
Before assembling, please review all instructions.
1. Carefully remove all parts from the box and make sure all parts listed on
the spare parts illustration are included. If any parts are missing, please
contact Verilux at 1-888-544-4865.
2. Assemble 3 shaft sections (A) according to the illustration and make sure
sections are joined together securely.
NOTE: The middle shaft section can be taken out when using Sweeper on
stairs or on upholstery
3. Remove Part B from the handle assembly by pulling it apart (photo 1). Fully
insert knurled end of shaft into handle assembly (photo 2). Slide Part B over
shaft, line up arrows on part B and handle assembly (photo 3), and push
together against handle assembly to lock shaft to the handle.
4. Your Sweeper was shipped with the “smart” battery disconnected from the
Sweeper. Prior to charging the battery, turn the Sweeper upside down, slide
the battery compartment door toward the rear of the Sweeper (see arrow on
cover door), insert the male connection of the battery wire into the female
connection of the Sweeper.
5. To charge the battery, plug included AC
Adapter/Battery Charger into the charger
B
socket on the side of the base of the Sweeper
and charge initially for 12 hours before using.
When charged, carefully remove the battery
charger cable prior to using. Never leave the
charger connected for longer than 24 hours at
a time.
1
6. Turn on power switch and begin to use
on proper surfaces.
B
2
3
3
Download from Www.Somanuals.com. All Manuals Search And Download.
ASSEMBLY INSTRUCTIONS
4
Download from Www.Somanuals.com. All Manuals Search And Download.
OPERATION
• Gently step on the power switch once to
activate the Sweeper and the UV-C light
function.
2 Step Switch
SWEEP / STERILIZE /
• Press switch second time to switch off.
1st Step
2nd Step
LIGHT UP
ATTENTION: This Unit features a safety cut-
off switch for the UV-C light. When the wheels
come off the floor, the light automatically
switches off. Do not allow the UV-C Light to
come into direct contact with the eyes or skin.
TURN OFF
CHARGING INSTRUCTIONS
• Connect battery charger to the Sweeper
unit. Plug the charger into the electric outlet
located on your household wall to start
charging.
Recharge Status
Initial
Charging Phase
RED LIGHT
Final
Charging Phase
ORANGE LIGHT
GREEN LIGHT
• Sweeper may be charged after each use
for not more than 24 hours or damage to
batteries might occur.
Fully charged–
remove charger
• You can notice the power condition
according to the LED indicator light located on the charger.
• When charging the Sweeper, sweeping and sterilizing functions are
inoperable.
REPLACING THE BATTERY
• Turn off the power.
• Turn the Sweeper upside down and open
the battery cover according to the illustration
shown.
• Pull out the battery pack and disconnect it from
the power wire.
• Insert a new battery pack and reconnect the
power wire.
• Replace the battery cover and recharge the
sweeper to get it ready to operate.
ATTENTION: New batteries require an initial
12 hour charge before using. After that, recharge until green light appears.
Never charge for more than 24 hours or damage to the batteries may occur.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
EMPTYING THE DUST BIN AND CLEANING THE DUST FILTER
ATTENTION: Please ensure that the power is off when performing any
maintenance operation.
1. To turn off the power. step
gently on the switch.
2. Leave the Sweeper on floor
and carefully pull upward
to remove the dust bin and
filter.
3. Remove and gently clean
the filter cover. Carefully
empty dust bin into trash
receptacle.
CLEANING BRUSH ROLL
1. Use screwdriver (not included) to open the brush cover.
2. Carefully pull brush roller up
and move transmission belt
to the outside, allowing the
brush roller to be lifted out for
cleaning.
3. Remove hair and fiber from
the brush roll.
4. Reassemble unit as before.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
One-Year Limited Warranty
ATTENTION! ONCE OPENED, PLEASE DO NOT RETURN THIS PRODUCT TO THE
STORE WHERE IT WAS PURCHASED FOR REPAIR OR REPLACEMENT!
customer service department at 1-888-544-4865.
This limited warranty is provided by:
Verilux, Inc., 340 Mad River Park, Waitsfield, VT 05673
Verilux® warrants this product to be free from defects in material and workmanship for a period of one year from
the date of the original retail purchase. Rechargeable batteries are not included in this warranty. During the limited
warranty period, Verilux, Inc. will, at its option, repair or replace defective parts of this product, at no charge to the
customer, subject to the following limitations. This limited warranty does not include any postage, freight, insurance or
delivery fees. This warranty does not cover damage, defect or failure caused by or resulting from accident, external
destruction, alteration, modification, abuse, misuse, or misapplication of this product.
If, during the first year of ownership, this product fails to operate properly, it should be returned as specified below:
Please pack the defective product in its original protective packing and box, with a copy of your sales receipt, along
with $6.95 (check or money order to cover shipping and handling), and send to:
For U.S. Postal Service Only:
Verilux Warranty
For Fed Ex & UPS Only:
Verilux Warranty
Service Center, c/o WTB
Service Center, c/o WTB
P.O. Box 119, West Redding, CT 06896
32 Henry Street, Bldg 17A, Bethel, CT 06801
Please allow 4-6 weeks before you receive the repaired or replaced product.
ATTENTION: When returning a product, be aware that damage during shipping is the
responsibility of the purchaser and will void any warranty claim. We recommend that
you insure the shipment by shipper when returning this product or any parts. Be sure to
return product in original packaging.
Due to ongoing improvements, actual product may have slight variations from the product described in this manual.
340 Mad River Park, Waitsfield, VT 05673
Printed in China for Verilux, Inc.
© Copyright 2007 Verilux, Inc. All rights reserved.
VH02-MAN-Rev4
Download from Www.Somanuals.com. All Manuals Search And Download.
|