NBW-100U
2.4GHz Wireless Presenter
User’s Manual
Download from Www.Somanuals.com. All Manuals Search And Download.
Table of Contents
Safety Instructions
Always read the safety instructions carefully
Any attempt to disassemble, adjust or repair the presenter may result in exposure to laser light
or other safety hazards.
Never point the presenter’s laser light at people, especially their eyes, or look directly into the
laser light to avoid possible eye damage.
Avoid pointing the presenter’s laser beam at a mirror or other highly reflective surface.
Keep this User’s Manual for future reference
Keep this equipment away from humidity
If any of the following situation arises, get the equipment checked by a service technician:
•
•
•
•
The equipment has been exposed to moisture.
The equipment has been dropped and damaged.
The equipment has obvious sign of breakage.
The equipment is not working properly or you cannot get it work according to User’s
Manual.
Copyright Statement
No part of this publication may be reproduced in any form by any means without the prior written
permission. Other trademarks or brand names mentioned herein are trademarks or registered
trademarks of their respective companies.
Disclaimer
Information in this document is subject to change without notice. The manufacturer does not make
any representations or warranties (implied or otherwise) regarding the accuracy and completeness
of this document and shall in no event be liable for any loss of profit or any commercial damage,
including but not limited to special, incidental, consequential, or other damage.
- i -
Download from Www.Somanuals.com. All Manuals Search And Download.
Table of Contents
Table of Contents
1. Introduction .......................................................................................................3
Features.............................................................................................................................3
Package Contents..............................................................................................................3
System Requirements........................................................................................................3
2. Installation .........................................................................................................4
Installing the Batteries ......................................................................................................4
Installing the Receiver ......................................................................................................4
Windows XP/2000/ME..............................................................................................................4
Windows 98SE ..........................................................................................................................4
Verify the Device Installation ....................................................................................................7
3. Using the Presenter ..........................................................................................8
Using the Keys..................................................................................................................9
Activate / De-Activate Laser Point Function....................................................................9
Establishing a Communication Link.................................................................................8
Sleeping Mode ................................................................................................................10
Changing Mode...............................................................................................................10
4. Troubleshooting..............................................................................................11
5. Warranty / Contact ..........................................................................................13
6. Specifications..................................................................................................13
7. Regulatory Compliance..................................................................................14
FCC Conditions ..............................................................................................................14
CE ...................................................................................................................................14
WEEE Information .........................................................................................................14
- ii -
Download from Www.Somanuals.com. All Manuals Search And Download.
NBW-100U 2.4GHz Wireless Presenter User’s Manual
1. Introduction
The Vantec NBW-100U wireless presenter is an ideal presentation tool to make
your presentations more efficient and effective. Using RF technology, it allows you
to wirelessly control your computer from a distance of up to 15 meters. The
integrated laser pointer helps highlight your key points and the mini stick gives full
cursor control. Moreover, it provides function keys in two modes: PowerPoint and
Windows Media Player mode. The keys can emulate page up/down, volume
up/down, play, pause keys, etc. Wirelessly take control of your computer with the
Vantec NBW-100U
Features
An ideal assistant tool for presentation
Remotely control your slides from a distance of up to 15 meters
Switch between PowerPoint and Windows Media modes.
Laser pointer to easily highlight emphasis
2.4GHz Radio Frequency (worldwide license free radio frequency)
USB 1.1 interface on receiver, easy to connect with your computer
Supports Plug-and-Play; hot swappable
Built-in sleeping mode when not operated for more than 10 minutes
Mini Stick controller to control cursor movement (optional)
Package Contents
Before installation, please check the items in the package.
Wireless Presenter
Receiver
X 1
X 1
X 2
X 1
1.5V AAA Battery
User’s Manual
System Requirements
Intel Pentium compatible computer with USB port.
Windows XP/2000/Server 2003/ME/98SE
- 3 -
Download from Www.Somanuals.com. All Manuals Search And Download.
NBW-100U 2.4GHz Wireless Presenter User’s Manual
2. Installation
Installing the Batteries
Slide off the battery cover on the back of the presenter to open it and insert the
supplied batteries in the correct orientation. Slide the cover back into position.
Caution: Do not mix new and used batteries in the device.
Installing the Receiver
Connect the receiver to a free USB port on your computer.
Windows XP/2000/ME
Upon detection, Windows will automatically install the appropriate drivers. You will
not need to supply any drivers.
Windows 98SE
Follow these steps to install the receiver:
1. When Windows detects the USB Human Interface Device, click the Next.
- 4 -
Download from Www.Somanuals.com. All Manuals Search And Download.
NBW-100U 2.4GHz Wireless Presenter User’s Manual
2. Select Search for the best driver for you device (Recommended) and click
Next.
3. Select only Specify a location and click Browse to specify the location of
C:\Windows. Then click Next.
4. When Windows finds the driver, click Next.
- 5 -
Download from Www.Somanuals.com. All Manuals Search And Download.
NBW-100U 2.4GHz Wireless Presenter User’s Manual
5. If the screen below appears, click OK.
Insert your Windows 98 SE CD-ROM and then click Browse to specify the
directory to the Windows 98 SE CD. Click OK.
6. Click Finish to complete the installation.
Windows will detect another USB Human Interface device. Repeat the steps above
to finish the installation.
- 6 -
Download from Www.Somanuals.com. All Manuals Search And Download.
NBW-100U 2.4GHz Wireless Presenter User’s Manual
Verify the Device Installation
To verify your receiver installation, select Control Panel > System > (Hardware) >
Device Manager. Your device list should be similar to the screen shot displayed
blow.
If there is a question or exclamation mark next to any of the items, then the driver is
not properly installed. Please delete the item and repeat the installation steps.
- 7 -
Download from Www.Somanuals.com. All Manuals Search And Download.
NBW-100U 2.4GHz Wireless Presenter User’s Manual
3. Using the Presenter
Using the Keys
The mouse emulation keys (i.e., right, left and navigation keys) and Laser key
function in the same way in both modes. The remaining keys offer different function
according to the current operation mode. See the table below for details:
Key
PowerPoint Mode
Windows Media Player Mode
Controls cursor movement. Click center for mouse left button.
Cursor Control
Press and hold: Shoots the laser light.
Release: Turns off the laser light.
Page Up, Page Down
Volume +, Volume -
Press twice:
Press twice:
Start / exit slide show
Play / pause playing media.
Press and hold for about 1 sec: Press and hold for about 1 sec:
Turn the presentation screen to all Mute on / off
black / Restore to normal state.
Mouse left button, Mouse right button
Press and hold for about 1.5 seconds until the LED flashes:
Switch between PowerPoint and Windows Media Player modes.
- 8 -
Download from Www.Somanuals.com. All Manuals Search And Download.
NBW-100U 2.4GHz Wireless Presenter User’s Manual
Activate / De-Activate Laser Point Function
The laser pointer function is de-activated by default. To activate this function, press
and hold the Laser key & Mode key simultaneously for about 3 seconds until the
LED flashes red to confirm activation. To de-activate the laser point, just repeat
these steps.
+
= Activate / De-activate Laser Point Function
When laser point is activated, you can press and hold the Laser Light key to shoot
the laser light and release the key to turn it off.
Note: If the batteries inside the presenter are replaced, you will need to re-activate
the laser point function before you can use it.
Establishing a Communication Link
If your presenter is not working or RF interference with other remote device occurs,
then you need to reset the ID shared by the presenter and the receiver so that they
can establish a communication link. To reset the ID, make sure the receiver is
plugged to a computer and take the steps below:
1. Press the Mode key in conjunction with the Mouse Left key for about 3
seconds until the LED flashes in green. Then release the keys.
Press simultaneously
until the LED flashes.
2. Insert a pin or bent paperclip into the small hole on the receiver. Press it lightly
and then release.
3. The reset is complete and now the presenter is ready to use. You can verify the
link just using the mini stick to see if it controls the cursor.
Note: As the laser point function is independent from the receiver, it cannot be
used to verify the link.
- 9 -
Download from Www.Somanuals.com. All Manuals Search And Download.
NBW-100U 2.4GHz Wireless Presenter User’s Manual
Sleeping Mode
When the presenter is not operated for more than 10 minutes, the presenter goes
into sleeping mode and de-activates the laser pointer function in order to save
battery life. To wake up the presenter, just press any key on the device. To use the
laser light function, you need to activate it again by following the steps above.
Changing Mode
The presenter has two operation modes: PowerPoint mode and Windows Media
Player mode. To switch between these two modes, press the Mode key for about
1.5 seconds until the LED flashes green to confirm the change.
- 10 -
Download from Www.Somanuals.com. All Manuals Search And Download.
NBW-100U 2.4GHz Wireless Presenter User’s Manual
4. Troubleshooting
Q1. Why does my presenter doesn’t work?
A1. Check that the receiver is firmly attached to the USB port on your computer and
Windows built-in drivers are properly installed.
Make sure you have established a communication link between the presenter
and its receiver. Refer to “Using the Keys” section for instructions.
Q2. I have re-established the link between the presenter and its receiver. But some
of the keys still do not work.
A2. The keys’ functions depend on the operation mode. For example, if you find the
Page Up / Page Down keys don’t work, it may because that the presenter is in
the Windows media player mode.
Q3. Is there any method that I can identify the presenter’s current operation mode?
A3. No. If you find the keys don’t work as expected, use the Mode key to switch the
operation mode.
Q4. Why does the laser point function doesn’t work?
A4. The laser point function is not activated by default. You should activate it before
you can use it. Refer to the “Activate / De-Activate Laser Point Function”
section for details.
Also, if the presenter is not operated for more than 10 minutes, the presenter
goes into sleeping mode and de-activates the laser point function. To wake up
the presenter, just press any key on the device. To use the laser light function,
you need to activate it again.
- 11 -
Download from Www.Somanuals.com. All Manuals Search And Download.
NBW-100U 2.4GHz Wireless Presenter User’s Manual
Q5. While in the multimedia mode, can I use the presenter to control playback
software other than Windows Media Player?
A5. The presenter in media mode might work with playback software from other
vendors; however, we do not guarantee the compatibility with software other
than Windows Media Player.
5. Warranty / Contact
Warranty
The NBW-100U Wireless Presenter comes with a 1 year limited warranty (90 day parts). If your unit
information on how to receive warranty exchange or repair. Cosmetic defects and missing parts are
not covered under this warranty. Please check the contents of the unit to make sure you received all
parts. Also, check for any cosmetic flaws. If any parts are missing or if there are cosmetic defects,
please contact the retailer from which you purchased the unit immediately and ask for a
replacement.
Contact
Vantec Thermal Technologies
43951 Boscell Rd.
Fremont, CA 94538
tel: 510-668-0368
fax: 510-668-0367
- 12 -
Download from Www.Somanuals.com. All Manuals Search And Download.
NBW-100U 2.4GHz Wireless Presenter User’s Manual
6. Specifications
Items
Description
2.4GHz frequency ISM band for
worldwide
RF Frequency
Power Source
AAA battery X 2
Presenter
3V 1.2mA
Power Consumption
3V 27mA while Laser Pointer is on
Laser wavelength at peak
emission
650nm+-20nm (Red Light)
Laser Pointer
Indicator
Max to 15 meters
1mW
Power consumption
Interface
USB 1.1
Receiver
Power consumption
5V 30mA
Operation Distance
15 meters, from presenter to receiver
* Specification is subject to change without further notice.
- 13 -
Download from Www.Somanuals.com. All Manuals Search And Download.
NBW-100U 2.4GHz Wireless Presenter User’s Manual
7. Regulatory Compliance
FCC Conditions
This equipment has been tested and found to comply with Part 15 of the FCC
Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received. Including interference that
may cause undesired operation.
CE
This equipment is in compliance with the requirements of the following regulations:
EN 55 022: CLASS B
WEEE Information
For EU (European Union) member users:
According to the WEEE (Waste electrical and electronic equipment) Directive, do
not dispose of this product as household waste or commercial waste. Waste
electrical and electronic equipment should be appropriately collected and recycled
as required by practices established for your country. For information on recycling
of this product, please contact your local authorities, your household waste
disposal service or the shop where you purchased the product.
- 14 -
Download from Www.Somanuals.com. All Manuals Search And Download.
|