Congratulations on your purchase of the Uniden
TR622-2 (General Mobile Radio Service) radio.
This product is a lightweight, palm-sized radio.
Use it at sporting events to stay in contact with
family and friends, hiking, skiing, outdoors, or in
a neighborhood watch for vital communication.
This compact, state-of-the-art device is equipped
with many features.
charging time to fully charge the battery pack.
Adjusting the Sound (Key Beeps)
Talking on Your Radio
Key Lock
TR622-2
Your radio emits a beep each time one of the
buttons or keys (except for the PTT button and call
key) are pressed. To turn this sound OFF, press
and hold call while turning ON the radio. Repeat
this step to turn the sound ON.
To talk to others using the radio:
To Lock the keypad:
Note: Always make sure your battery pack is fully
discharged before recharging to prolong the life of
the battery pack. The LED will illuminate while the
radio is in the charging cradle.
• 8 GMRS / 14 FRS Channels
• 38 CTCSS Codes
• 2 NiMH Battery Packs
• Dual Recharging Cradle
with AC Adapter
1) Press and hold the PTT button and speak in a
clear, normal voice about 2-3 inches away from
the microphone. While you are transmitting, the
icon will appear on the display. To avoid
1) Enter the Menu. Advance through the Menu until
the
icon appears on the display. The current
• Up to 2 Mile Range*
• 5 Selectable Call Tone Alerts
• Backlit LCD Display
key Lock status (OFF) blinks on the display.
2) To switch the key Lock mode from OFF to ON,
press the channel/scan L key.
• Battery Level Meter
• Channel Monitor
• Channel Scan
cutting off the first part of your transmission,
pause slightly after pressing the PTT button
before you start talking.
To install 4 AAA alkaline batteries:
Navigating through the Menu
To access the advanced features of the TR622-2,
your radio has a Menu function.
• Battery Recharge Circuit
• Optional NiMH Battery Pack
and Charger
3) To confirm the setting, press the sel/ key.
The radio returns to the "Normal" mode.
• Keypad Lock
1) Make sure your radio is OFF.
OPTIONAL ACCESSORIES
2) Remove the battery compartment door by
pressing the tab at the bottom of the
compartment door allowing the door to be
removed.
2) When you are finished speaking, release the PTT
button.You can now receive incoming calls. While
Note: If you exit the setting mode before confirming
your selection by pressing the sel/ key, the key
Lock setting will be set to OFF.
Your package contains two TR622-2 radios, this
reference guide, including a product registration
card. You may operate the unit using 4 AAA alkaline
batteries or the rechargeable NiMH battery pack
(not included). The following optional accessories
may be purchased from your participating Uniden
dealer or call1-800-554-3988 or visit us on the web
at www.uniden.com. Use only Uniden accessories.
Normal
CTCSS
Call Tone
1-5
Key Lock
ON-OFF
Normal
receiving, the
icon will appear on the display.
3) Install 4 AAA alkaline batteries (not included)
into the battery compartment. Be certain to
follow the + and – symbols in the compartment.
Installing the batteries incorrectly will prevent the
radio from operating.
Transmitting a Call Tone
To Unlock the keypad:
off, 1-38
Your TR622-2 radio is equipped with 5 selectable
Call Tones that will be transmitted when the call
key is pressed.
1) Press and hold the sel/ key to turn the radio
OFF.
1) To enter the Menu, press the sel/ key.
2) Additional presses of the sel/ key will
advance you through the Menu until exiting to
"Normal" operating mode.
2) Press and hold the sel/ key again to turn the
radio ON. The keypad is unlocked.
4) Replace the battery compartment door.
To select a Call Tone:
• NiMH Battery Pack - #BP38
• Recharging Cradle - #RC6248
1) Enter the Menu. Advance through the Menu until
Automatic Power Save Feature
3) Other methods of exiting the Menu function are:
a. Press and hold the sel/ key again.
b. Press PTT, mon, volume L/M, and call.
c. Wait 10 seconds until the unit automatically
returns to “Normal” mode.
the call icon is shown on the display.
The current Call Tone number (
indicated.
Your TR622-2 radio has a unique circuit designed
to dramatically extend the life of the batteries.
If there is no transmission nor an incoming call
within 3 seconds, your radio switches to the Power
Save mode. The radio is still able to receive
transmissions in this mode.
-
) will be
BATTERY LEVEL AND
LOW BATTERY ALERT
FCC GMRS LICENSE
*Range may vary depending on environmental and/or topographical conditions.
2) Press the channel/scan L or M key to
increase or decrease the number to the desired
Call Tone. Each tone will be heard through the
speaker.
The TR622-2 radio operates on the General
Mobile Radio Service (GMRS) frequencies which
require a Federal Communication Commission
license to operate. For licensing information and
application forms, visit the FCC online at:
This unit has a battery level meter on the display to
indicate the status of the batteries. When the
batteries in the radio are low, the battery level
TR622-2 RADIO
Choosing a Channel
meter icon
will flash. Replace the alkaline
3) Exit the Menu.
Your radio has 22 channels and 38 CTCSS codes
you can use to talk to others. In order to speak to
someone, each of you must be set to the same
channel and CTCSS code.
batteries immediately or if you are using the NiMH
battery pack, you must recharge the battery pack in
order to continue using the radio.
To transmit the selected Call Tone, press the call
key. The selected tone will automatically be
transmitted for a fixed length of time.
Call Tone will be canceled when the PTT button
is pressed.
1-800-418-3676. If you have any questions you
can contact the FCC direct at 1-888-225-5322.
LCD Backlight
The LCD Backlight will automatically turn ON when
any key (except PTT button) is pressed. The LCD
display will illuminate for 10 seconds before turning
OFF.
Warning! To avoid the risk of personal injury or
property damage from fire or electrical shock, only
use the Uniden accessories specifically designated
for this product.
To choose a channel:
INSTALL THE BATTERIES
With the radio in "Normal" operating mode press
the channel/scan L or M key to increase or
decrease the channel number displayed.
Channel Scan Feature
Your TR622-2 radio uses the included NiMH battery
pack or 4 AAA alkaline batteries. If alkaline
batteries are used, we recommend using high
quality alkaline batteries.
Monitor Mode Feature
Your TR622-2 radio has a channel Scan feature
that allows you to easily Scan all 22 channels.
When an active channel is detected, the radio will
pause on that channel until the channel is clear.
Then after a 2 second delay, the radio will continue
scanning. Pressing PTT while the Scan is paused
on a channel will allow you to transmit on that
channel.
Your TR622-2 radio allows you to listen for weak
signals on the current channel at the press of
a key.
Choosing a CTCSS Code
USING THE RADIO
Each of the channels 1-22 may have any one of
the codes, OFF or 1-38 selected. Code "OFF"
indicates no CTCSS code selected and your radio
can receive a signal regardless of the code settings
of the transmitting radio.
In order to get the most out of your new radio, read
this reference guide completely before attempting to
operate the unit.
To turn ON the Monitor Mode:
To install the NiMH battery pack:
1) Press mon for brief listening, the
blink.
icon will
1) Make sure your radio is OFF.
2) Remove the battery compartment door by
pressing the tab at the bottom of the
Turning the Radio On and Adjusting the Volume
2) Press and hold mon for 2 seconds for
To turn ON channel Scan:
continuous listening. The receiver circuit will stay
open, and let in both the noise and weak
signals.
compartment door allowing the door to be
removed.
1) Press and hold the sel/ key to turn the radio
ON, and increase the speaker volume by
pressing the volume L key. To decrease the
volume, press the volume M key.
1) Enter the Menu. The CTCSS code on the LCD
display will flash.
1
2
3
4
5
6
7
8
9
Antenna
11 Charging LED’s
Press and hold either the channel/scan L or M
key until the scan icon is displayed. The channel
number on the display will change as the radio
rapidly cycles through the channels.
3) Place the NiMH battery pack in the
compartment, making sure that the charge
contacts are on the lower half of the battery pack
and facing out. If the NiMH battery pack is
installed incorrectly, the radio will not operate.
4) Replace the battery compartment door.
5) The battery pack must be charged before using
for the first time. Place the GMRS622-2 radio into
the charging cradle allowing 16 hours
PTT (Push-To-Talk) Button
Channel/Scan Up Key
Call Key
12 Battery Level Meter
13 Receive Indicator
14 Scan Indicator
2) Press the channel/scan L or M key to
increase or decrease the code number
displayed. You can also select “OFF” at this
stage.
To turn OFF Monitor Mode:
2) Press and hold the sel/ key again to turn the
radio OFF.
Press mon to return to "Normal" mode, and the
icon stops blinking.
Channel/Scan Down Key
Select/Power Key
Speaker
15 Channel Indicator
16 Call Indicator
To turn OFF channel Scan:
3) Exit the Menu to return to “Normal” mode.
17 Keypad Lock Indicator
18 Transmit Indicator
19 Volume Setting Indicator
20 CTCSS Indicator
Press sel/
call, or PTT.
,
Monitor Key
Volume Up Key
10 Volume Down Key
Download from Www.Somanuals.com. All Manuals Search And Download.
|