WDECT3305
Accessory handset for
WDECT3315 and
WDECT3355 Series
OWNER’S MANUAL
Download from Www.Somanuals.com. All Manuals Search And Download.
Connect the Charger
Connect the AC
1
2
adapter to the DC
In 9V jack and to a
standard AC wall outlet.
set the charger on a
AC adapter
(supplied)
desk or tabletop, and
place the handset in To AC outlet
the charger with the
To DC IN 9V
keypad facing forward.
Make sure the charge lED illuminates. If the lED does not
illuminate, check to see that the AC adapter is plugged in
and that the handset makes good contact with the charger
charging contacts.
3
•Use only the supplied aC adapter. Do not use any
other aC adapter.
•place the charger close to the aC outlet so that you
can unplug the aC adapter easily.
Installing the Battery Pack
Press down on the battery cover
release and slide the cover down until it
comes off.
1
2
Plug the battery pack connector (red
& black wires) into the jack inside the
battery compartment. (The connector
notches fit into the grooves of the
jack only one-way.) Match the wire
colors to the polarity label in the
Black Red
Wire Wire
battery compartment, and push the
connector in until you hear a click.
Make sure you have a good
connection by slightly pulling on the
battery wires. If the connection is
secure, the battery jack will remain in
place.
3
4
Place the battery case cover back on
the handset by sliding it upwards until
it clicks into place.
[ 2 ]
Download from Www.Somanuals.com. All Manuals Search And Download.
Place the handset in the charging cradle with
the keypad facing forward.
5
•Use only the Uniden battery (Bt-
446) supplied with your phone.
replacement batteries are also
available through the nearest Uniden
dealer. (see page 1.)
•recharge your handset on a regular
basis by returning the handset to the
charger after each phone call.
Battery Information
Battery use time (per charge)
From fully charged (15-20 hours charge time)
•Up to 7 hours continuous use
(up to 5 hours when the Clarity Booster is On)
•Up to 10 days when the handset is in the standby mode
(up to 15 hours in the Directlink mode)
recharge your handset on a regular basis by returning
the handset to the charger after each phone call.
Low battery alert
When the batteries are very low and need to be charged, the
phone is programmed to eliminate functions in order to save
power.
The batteries need to be charged when :
- The empty battery icon
appears.
- ‘Low Battery’ appears in the display.
If the phone is in the standby mode, none of the keys
will operate. If you are on a call, complete your
conversation as quickly as possible, and return
the handset to the charging cradle.
Cleaning the battery charging
contacts
To maintain a good charge, it is
important to clean the charging contacts
on the handset once a month.
Use a dry cloth or pencil eraser to clean.
Do not use paint thinner, benzene, alcohol, or other chemical
products. Doing so may discolor the surface of the telephone
and damage the finish.
[ 3 ]
Download from Www.Somanuals.com. All Manuals Search And Download.
Register the Handset
YoU neeD to regIster the WDeCt3305
to the maIn Base Before Use!
If the WDECT3305 has not been registered
before then the display will show....
‘Place handset on main base to register’
The WDECT3305 must show this display before
proceeding to the registration procedure. If the
WDECT3305 was de-registered from another
base, select ‘System Reset’ from handset menu
then select ‘Replacing Base’ and select ‘Yes’.
The above display will then show.
Before registering the
1
1
handset, the battery
pack must be charged
for 15-20 hours.
Charge the handset
for 15-20 hours.
WDECT3305
Handset
Charger
Find the base model you wish to register the
WDECT3305 handset to and follow the instructions
for that model.
2
• WDeCt3315 and
WDeCt3355 series.
WDECT3305
Handset
2
Place the extra handset
in the main base unit
to begin registration
(Picture is the
Place the WDECT3305
handset in the main
base to register.
Main Base
WDECT3315 series
main base).
[ 4 ]
Download from Www.Somanuals.com. All Manuals Search And Download.
While the handset is
registering, ‘Handset
Registering’ will appear
in the lCD.
When ‘Registration
Complete’ is displayed,
3
Handset
Registering
Registration
Complete
WDECT3305 Handset
+
3
Main Base
the handset has been registered to the base.
If ‘Registration Failed’ appears, please try these
steps again.
•The handset can be registered when the main
base is in standby mode.
•standby Mode - The handset is not in use and
has not been pressed.
[ 5 ]
Download from Www.Somanuals.com. All Manuals Search And Download.
Warranty
one Year LImIteD WarrantY
UnIDen WDeCt3305 aCCessorY CorDLess phone
Important :
Warrantor :
Evidence of original purchase is required for warranty service.
Uniden Australia Pty limited A.B.n. 58 001 865 498
Uniden new Zealand limited
Warranty only available in original country of purchase.
eLement of WarrantY :
Uniden warrants to the original retail owner for the duration of this warranty, its WDECT3305 Accessory
Cordless Phone (herein after referred to as the Product), to be free from defects in materials and
craftsmanship with only the limitations or exclusions set out below.
WarrantY DUratIon:
This warranty to the original retail owner only, shall terminate and be of no further effect OnE (1) year after
the date of original retail sale. This warranty will be deemed invalid if the Product is;
(A) Damaged or not maintained as reasonable and necessary,
(B) Modified, altered or used as part of any conversion kits, subassemblies, or any configurations not sold
by Uniden,
(C) Improperly installed,
(D) repaired by someone other than an authorized Uniden repair Agent for a defect or malfunction
covered by this warranty,
(E) Used in conjunction with any equipment or parts or as part of a system not manufactured by Uniden,
or
(F) Where the serial number label of the product has been removed or damaged beyond recognition.
Warranty only valid in the country of original retail/sale.
parts CoVereD:
This warranty covers for one (1) year, the Product and included accessories.
statement of remeDY:
In the event that the Product does not conform to this warranty at any time while this warranty is in effect,
the warrantor at its discretion, will repair the defect or replace the Product and return it to you without
charge for parts or service. This warranty does not provide for reimbursement or payment of incidental or
consequential damages.
This EXPrEss WArrAnTY is in addition to and does not in any way affect your rights under the TrADE
PrACTICEs ACT 1974 (Cth) (Australia) or the COnsUMEr GUArAnTEEs ACT (new Zealand).
proCeDUre for oBtaInIng performanCe or WarrantY:
In the event that the Product does not conform to this warranty, the Product should be shipped or
delivered, freight pre-paid, with evidence of original purchase (e.g. a copy of the sales docket), to the
warrantor at:
UnIDen aUstraLIa ptY LImIteD
serVICe DIVIsIon
UnIDen neW ZeaLanD LImIteD
serVICe DIVIsIon
345 Princes Highway, rockdale nsW 2216
Fx(02) 9599 3278
150 Harris road, East Tamaki, Auckland
Fx(09) 274 4253
Customers in other states should ship or deliver the Product freight pre-paid to their nearest Uniden
Authorized repair Centre (Contact Uniden for the nearest Warranty Agent to you).
Download from Www.Somanuals.com. All Manuals Search And Download.
© 2007
Uniden Australia Pty Limited
Uniden New Zealand Limited
Printed in China
UUZZ01642BZ(0)
Download from Www.Somanuals.com. All Manuals Search And Download.
|