Uniden Car Satellite Radio System GMR635 2 User Manual

UT01915ZZ_1 11/28/03 12:20 PM Page 1  
Congratulations on your purchase of the Uniden  
GMR635-2/GMR635-2CK (General Mobile Radio  
Service) radio. This product is a lightweight, palm-  
sized radio. Use it at sporting events to stay in  
contact with family and friends, hiking, skiing,  
outdoors, or in a neighborhood watch for vital  
communication.  
5) The battery pack must be charged before using  
for the first time. Place the GMR635 radio into  
the charging cradle allowing 16 hours charging  
time to fully charge the battery pack.  
Talking on Your Radio  
3) To confirm the setting, press the call/sel key. The  
radio returns to the "Normal" mode.  
USING THE RADIO  
GMR635-2/GMR635-2CK  
To talk to others using the radio:  
In order to get the most out of your new radio, read  
this reference guide completely before attempting to  
operate the unit.  
Note: If you exit the setting mode before confirming  
your selection by pressing the call/sel key, the key  
Lock setting will be set to OFF.  
• 15 GMRS / 7 FRS Channels  
• Up to 6 Mile Range*  
Battery Level Meter  
Channel Monitor  
Channel Scan  
Keypad Lock  
Roger Beep  
1) Press and hold the PTT button and speak in a  
clear, normal voice about 2-3 inches away from  
the microphone. While you are transmitting, the  
icon will appear on the display. To avoid  
cutting off the first part of your transmission,  
pause slightly after pressing the PTT button  
before you start talking.  
Note: Always make sure your battery pack is fully  
discharged before recharging to prolong the life of  
the battery pack. The LED will illuminate while the  
radio is in the charging cradle.  
• 5 Selectable Call Tone Alerts  
• Backlit LCD Display  
• Battery Recharge Circuit  
• NiMH Battery Pack and Charger  
(GMR635-2CK only)  
Turning the Radio On and Adjusting the Volume  
To Unlock the keypad:  
1) Press and hold the  
key to turn the unit ON,  
This compact, state-of-the-art device is equipped  
with many features.  
Key Beep  
1) Press and hold the  
2) Press and hold the  
key to turn the unit OFF.  
key again to turn the unit  
and increase the speaker volume by pressing the  
vol L key. To decrease the volume, press the vol  
M key.  
To install 4 AAA alkaline batteries:  
2) When you are finished speaking, release the PTT  
button.You can now receive incoming calls. While  
ON. The keypad is unlocked.  
1) Make sure your radio is OFF.  
OPTIONAL ACCESSORIES  
2) Press and hold the  
OFF.  
key again to turn the unit  
2) Remove the battery compartment door by  
pushing up the tab at the bottom of the  
compartment door allowing the door to be  
removed.  
3) Install 4 AAA alkaline batteries (not included)  
into the battery compartment. Be certain to  
follow the + and symbols in the compartment.  
Installing the batteries incorrectly will prevent the  
radio from operating.  
receiving, the  
icon will appear on the display.  
Automatic Power Save Feature  
Your package contains two GMR635 radios, two  
rechargeable NiMH battery packs (#BP38), AC  
adapter (#AC6248), Recharging cradle (#RC6348),  
two belt clips and this reference guide.You may  
operate the unit using the rechargeable NiMH  
battery pack or 4 AAA alkaline batteries  
(not included). The following optional accessories  
may be purchased from your participating Uniden  
dealer or call1-800-554-3988 or visit us on the web  
at www.uniden.com. Use only Uniden accessories.  
Transmitting a Call Tone  
Your GMR635-2/GMR635-2CK radio has a unique  
circuit designed to dramatically extend the life of the  
batteries.  
If there is no transmission nor an incoming call  
within 3 seconds, your radio switches to the Power  
Save mode. The radio is still able to receive  
transmissions in this mode.  
Your GMR635-2/GMR635-2CK radio is equipped  
with 5 selectable call tones that will be transmitted  
when the call/sel key is pressed.  
Adjusting the Sound (Key Beeps)  
Your radio emits a beep each time one of the  
buttons or keys (except for the PTT button and  
call/sel key) are pressed. To turn this sound OFF,  
press and hold call/sel while turning ON the radio.  
Repeat this step to turn the sound ON.  
To select a call tone:  
1) Enter the Menu. Advance through the Menu until  
the call icon is shown on the display. The  
4) Replace the battery compartment door.  
current call tone number (  
indicated.  
2) Press the ch/scan L or M key to increase or  
decrease the number to the desired call tone.  
Each tone will be heard through the speaker.  
3) Exit the Menu.  
-
) will be  
LCD Backlight  
Navigating through the Menu  
The LCD backlight will automatically turn ON when  
any key (except PTT button) is pressed. The LCD  
display will illuminate for 10 seconds before turning  
OFF.  
NiMH Battery Pack - #BP38  
USING THE CHARGING CRADLE  
To access the advanced features of the  
GMR635-2/GMR635-2CK, your radio has a Menu  
function.  
Recharging Cradle - #RC6348  
* Range may vary depending on environmental and/or topographical conditions.  
If you use the rechargeable NiMH battery pack, two  
GMR635-2CK radios can be charged by using the  
charging cradle.  
Make sure to turn the radio OFF before placing  
the radio in the charging cradle. Otherwise the  
battery level meter icon won’t indicate properly.  
GMR635 RADIO  
FCC GMRS LICENSE  
To transmit the selected call tone, press the  
call/sel key. The selected tone will automatically be  
transmitted for a fixed length of time.  
Monitor Mode Feature  
Normal  
Call Tone  
Key Lock  
Normal  
The GMR635-2/GMR635-2CK radio operates on  
the General Mobile Radio Service (GMRS)  
frequencies which require a Federal  
Your GMR635-2/GMR635-2CK radio allows you to  
listen for weak signals on the current channel at the  
press of a key.  
1-5  
ON-OFF  
1) Connect the AC adapter (# AC6248) to DC IN 9V  
jack and to a standard 120V AC wall outlet.  
2) Set the charging cradle on the desk or tabletop,  
and place the radio in the charging cradle with  
the keypad facing forward.  
3) Make sure that the LED illuminates. Charge the  
battery pack for 16 hours and remove the radio  
from the charging cradle after charge.  
Channel Scan Feature  
Communication Commission license to operate.  
For licensing information and application forms,  
call the FCC hotline at 1-800-418-3676. If you  
have any questions you can contact the FCC  
direct at 1-888-225-5322.  
Your GMR635-2/GMR635-2CK radio has a channel  
Scan feature that allows you to easily Scan all 22  
channels. When an active channel is detected, the  
unit will pause on that channel until the channel is  
clear. Then after a 2 second delay, the unit will  
continue scanning. Pressing PTT while the Scan is  
paused on a channel will allow you to transmit on  
that channel.  
1) To enter the Menu, press and hold the call/sel  
key.  
2) Additional presses of the call/sel key will  
advance you through the Menu until exiting to  
"Normal" operating mode.  
3) Other methods of exiting the Menu function are:  
a. Press PTT, mon, or vol L/M.  
b. Wait 10 seconds until the unit automatically  
returns to Normalmode.  
To turn ON the monitor mode:  
Press mon for brief listening, the  
icon will  
blink.  
Press and hold mon for 2 seconds for continuous  
listening. The receiver circuit will stay open, and  
letting in both the noise & weak signals.  
INSTALL THE BATTERIES  
Note: The charge indicator LED's will remain on as  
long as the radios are left in the charger.  
To turn OFF monitor mode:  
To turn ON channel scanning:  
Your GMR635-2/GMR635-2CK radio uses the  
NiMH battery pack(included in GMR635-2CK) or  
4 AAA alkaline batteries (not included). If alkaline  
batteries are used, we recommend using high  
quality alkaline batteries.  
Press mon to return to "Normal" mode, and the  
Press and hold either the ch/scan L or M key  
until the scan icon is displayed. The channel  
number on the display will change as the radio  
rapidly cycles through the channels.  
icon stops blinking.  
Choosing a Channel  
BATTERY LEVEL AND  
LOW BATTERY ALERT  
Roger Beep  
Your radio has 22 channels you can use to talk to  
others. In order to speak to someone, each of you  
must be set to the same channel.  
Roger Beep is a BEEP that is sent to notify the end  
of transmission.  
Roger Beep can be heard through the speaker  
when Key Beep is on.  
Roger Beep is transmitted even if key beep is turned  
off. However Roger Beep will not be heard from the  
speaker.  
To turn OFF channel scanning:  
This unit has a battery level meter on the display to  
indicate the status of the batteries. When the  
batteries in the unit are low, the battery level meter  
To install the NiMH battery pack:  
Press call/sel, or PTT.  
1) Make sure your radio is OFF.  
1 Antenna  
11 Charging LED’s  
To choose a channel:  
2) Remove the battery compartment door by  
pushing up the tab at the bottom of the  
compartment door allowing the door to be  
removed.  
3) Place the NiMH battery pack in the  
compartment, making sure that the charge  
contacts are on the lower half of the battery  
pack and facing out. If the NiMH battery pack is  
installed incorrectly, the radio will not operate.  
4) Replace the battery compartment door.  
2 PTT (Push-To-Talk) Button  
3 Monitor Key  
4 Channel/Scan Up Key  
5 Channel/Scan Down Key  
6 Speaker  
7 Call/Select Key  
8 Volume Up Key  
9 Power Key  
12 Battery Level Meter  
13 Receive Indicator  
14 Scan Indicator  
15 Channel Indicator  
16 Volume Setting Indicator  
17 GMRS/FRS Indicator  
18 Transmit Indicator  
19 Call Indicator  
icon  
will flash. Replace the alkaline  
Keypad Lock  
With the radio in "Normal" operating mode press  
the ch/scan L or M key to increase or decrease  
the channel number displayed.  
batteries immediately or if you are using the NiMH  
battery pack, you must recharge the battery in  
order to continue using the radio.  
To Lock the keypad:  
To turn OFF Roger Beep: Press and hold the  
ch/scan L key while turning ON the radio.  
1) Enter the Menu. Advance through the Menu until  
Warning! To avoid the risk of personal injury or  
property damage from fire or electrical shock, only  
use the Uniden accessories specifically designated  
for this product.  
Note: Channels 1-7 have an expectancy range of  
up to 6 miles. Channels 8-14 have an expectancy  
range of up to 2 miles. Channels 15-22 have an  
expectancy range of up to 6 miles.  
the  
icon appears on the display. The current  
key Lock status (OFF) blinks on the display.  
2) To switch the key Lock mode from OFF to ON,  
press the ch/scan L key.  
To turn ON Roger Beep: Press and hold the  
ch/scan L key while turning the radio ON again.  
10 Volume Down Key  
20 Keypad Lock Indicator  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Top Innovations Carpet Cleaner MC1235 User Manual
Toshiba Computer Drive HDTC610XK3B1 User Manual
Toshiba Network Card DK16 User Manual
Toshiba Personal Computer SATELLITE U200 User Manual
Tripp Lite Automobile Accessories SR25UBEXPKD User Manual
Tripp Lite Network Card SR25UBSP1 User Manual
Tyco Smoke Alarm 579 769 User Manual
ViewSonic Projector VS13646 User Manual
Vivitek Home Security System VTC IRLED30HD User Manual
Wayne Dalton Garage Door Opener 346919 User Manual