Owner's Manual
IBAR 12
IBAR 12 ULTRA
IBAR 12/20 ULTRA
IBRM 12/15A-L20P
IBRM 8/20A-L20P
1111 W. 35th Street
Chicago, IL 60609 USA
Customer Support: (773) 869-1234
ISOBAR® RACKMOUNT SURGE
SUPPRESSORS & LINE-NOISE FILTERS
Designed to occupy one standard 19 in. rack space
Congratulations! You now own the best quality surge suppressor available. The UL-listed IBAR series features
proven ISOBAR® surge-suppression technology, providing maximum protection against harmful AC transients,
including voltage spikes, surges and RFI/EMI line noise. These types of interference are common in all commercial
AC power systems.
INSTALLATION
(ALL MODELS): Four screws* will secure the IBAR into rack position. After screwing IBAR into rack, simply
plug the line cord into a grounded 3-conductor, 120-Volt AC outlet. DO NOT use 2-wire extension cords or adapters.
Lack of a proper ground connection will eliminate common-mode protection and cause a small leakage potential
on the case. However, you can plug 2-wire devices into any of the outlets.
* Rack screws are user-supplied on IBAR 12 & IBRM 12/15A-L20P. IBAR 12 ULTRA, IBAR 12/20 ULTRA & IBRM 8/20A-L20P include 4 rack
screws and an allen wrench.
NOTE!
(IBAR 12, IBAR 12 ULTRA & IBRM 12/15A-L20P) DO NOT exceed the MAXIMUM LOAD of 15 amps
that can be drawn from each AC outlet. DO NOT exceed the MAXIMUM LOAD of 15 amps that can be
drawn from all twelve outlets combined.
(IBAR 12/20 ULTRA & IBRM 8/20A-L20P) DO NOT exceed the MAXIMUM LOAD of 15 amps that can
be drawn from each AC outlet located on the front of the unit. DO NOT exceed the MAXIMUM LOAD of
20 amps that can be drawn from each AC outlet located on the rear of the unit. DO NOT exceed the
MAXIMUM LOAD of 20 amps that can be drawn from all of the eight outlets combined.
FEATURES
CIRCUIT BREAKER (ALL MODELS)
If the current draw of the equipment connected to the IBAR exceeds 15 amps (or 20 amps for IBAR 12/20 and IBRM
8/20A-L20P) for longer than a few seconds, the circuit breaker will open (trip) to prevent any possible damage.
When the circuit breaker trips, its plunger will be extended. Allow the breaker to cool for one minute before
depressing its plunger to reset.
ILLUMINATED “ON/OFF” SWITCH (IBAR 12, IBAR 12 ULTRA & IBRM 12/15A-L20P)**
With the IBAR plugged into a 120V AC, 60 Hz AC outlet, this switch will illuminate RED whenever moved to the
“ON” position. This indicates 120V AC power is present at the IBAR’s AC receptacles.
** IBAR 12/20 ULTRA features an unilluminated “ON/OFF” Switch which displays a RED marking along its edge when it is in the “ON”
position.
ISOLATED FILTER BANKS & CASCADE CIRCUITRY
(IBAR 12, IBAR 12 ULTRA & IBRM 12/15A-L20P)
Isolated Filter Banks prevent equipment plugged into each filter bank from interacting with equipment plugged
into the other filter bank. Cascade Circuitry provides different levels of protection between the Isolated Filter Banks.
There are two Isolated Filter Banks on the IBAR 12, IBAR 12 ULTRA & IBRM 12/15A-L20P.*** Isolated Filter Bank
#2 provides the highest level of protection for your most sensitive equipment. Isolated Filter Bank #1 provides
standard protection for your less-sensitive or noise-producing equipment.
*** See rear panel diagrams on page 3 to locate the filter banks on your model.
9907030 Isobar Rackmount OM DRAFT.p65
1
7/11/00, 2:22 PM
Download from Www.Somanuals.com. All Manuals Search And Download.
UL 1449 (1999 rev.): IBAR 12, IBAR 12/20 ULTRA, IBRM 12/15A-L20P and
IBRM 8/20A-L20P: 330V let-through (UL’s best rating for surge suppression);
IBAR 12: 400V let-through
UL 1283: for line-noise filtering
CUR: meets Canadian National Standards as recognized by UL
FRONT PANELS
FRONT PANEL FEATURES
1) Protection Present LED
2) Line Fault LED
3) Line "OK" LED
4) 15-amp Outlets
(Standard Protection)
5) Circuit Breaker
6) On/Off Switch
4
5
6
IBAR 12
IBRM 12/15A-L20P
1 2 3
4
5 6
IBAR 12 ULTRA,
IBAR 12/20 ULTRA
IBRM 8/20A-L20P
REAR PANELS
REAR PANEL FEATURES
7)
8)
9)
AC Power Cord
Grounding Post
Filter Bank #1
15-amp Outlets
(Standard Protection)
7
9
10
10) Filter Bank #2
15-amp Outlets
(Increased Protection)
11) 20-amp Outlets
(Standard Protection)
IBAR 12
IBRM 12/15A-L20P
9 7 8
9
10
IBAR 12 ULTRA
7 8
11
11
IBAR 12/20 ULTRA
IBRM 8/20A-L20P
9907030 Isobar Rackmount OM DRAFT.p65
3
7/11/00, 2:22 PM
Download from Www.Somanuals.com. All Manuals Search And Download.
LIFETIME LIMITED WARRANTY
Seller warrants this product, if used in accordance with all applicable instructions, to be free from original defects in material and
workmanship for its lifetime. If the product should prove defective in material or workmanship within that period, Seller will repair
or replace the product, in its sole discretion. Service under this Warranty can only be obtained by your delivering or shipping the
product (with all shipping or delivery charges prepaid) to: Tripp Lite, 1111 W. 35th Street, Chicago, IL 60609. Seller will pay return
shipping charges. Call Tripp Lite at (773) 869-1234 before sending any equipment back for repair.
The warranties of all TRIPP LITE surge suppressors are null and void if they have been connected to the output of any UPS system.
The warranties of all TRIPP LITE UPS Systems are null and void if a surge suppressor has been connected to its output receptacles.
THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT, MISUSE, ABUSE
OR NEGLECT. SELLER MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY EXPRESSLY SET FORTH HEREIN.
EXCEPT TO THE EXTEND PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES, INCLUDING ALL WARRANTIES
OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN DURATION TO THE WARRANTY PERIOD SET FORTH ABOVE; AND
THIS WARRANTY EXPRESSLY EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL DAMAGES. (Some states do not allow
limitations on how long an implied warranty lasts, and some states do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitations or exclusions may not apply to you. This Warranty gives you specific legal rights, and you may
have other rights which vary from jurisdiction to jurisdiction).
TRIPP LITE
1111 W. 35th Street
Chicago, IL 60609
WARNING: The individual user should take care to determine prior to use whether this device is suitable, adequate or safe for the
use intended. Since individual applications are subject to great variation, the manufacturer makes no representation or warranty as to
the suitability or fitness of these devices for any specific application.
Policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.
ULTIMATE LIFETIME INSURANCE POLICY
(Valid in U.S. and Canada ONLY)
TRIPP LITE warrants, for the lifetime of the product, (at TRIPP LITE’S option) to repair or replace (on a pro rata basis) directly
connected equipment, that is damaged due to power transients while properly connected to TRIPP LITE products offering the
ULTIMATE® Insurance Policy. Reimbursement or restoration for data loss is not included. Power transients include spikes and surges
on the AC power, data, or telephone lines that the TRIPP LITE products have been designed to protect against (as recognized by
industry standards).
AC Power Line Transients: To claim damages the TRIPP LITE product must be plugged into a properly wired and grounded outlet.
No extension cords, or other electrical connections may be used. The installation must comply with all applicable electrical and safety
codes set forth by the National Electrical Code (NEC). Except as provided above, this warranty does not cover any damage to properly
connected electronic equipment resulting from a cause other than an “AC power transient”. If user meets all of the above requirements,
TRIPP LITE will repair or replace (at TRIPP LITE’S option) equipment up to the specified value (See ULTIMATE® Insurance Policy
Limits). No coverage is allowed for damage entering from telephone or data lines, unless they are separately protected as described
below.
Reimbursement dollar limits will be equal to that of the Tripp Lite power protection protector. Coverage is excluded where a suitable
environment for the protection device is not provided, including, but not limited to, lack of a proper safety ground. Telephone service
equipment must also include a properly installed and operating “primary protection” device at the telephone service entrance (such
devices are normally added during telephone-line installation).
All above warranties are null and void if the TRIPP LITE product has been improperly installed, tampered with or altered in any way,
or if the connected equipment was not used under normal operating conditions or in accordance with any labels or instructions. All
claims under this warranty must be submitted in writing to Tripp Lite within 30 days of the occurrence or the claim will not be
considered. This warranty does not include damage resulting from accident or misuse, and applies to the domestic (USA & Canada)
use of these products only.
Tripp Lite reserves the right to determine whether the damage to the connected equipment is due to malfunction of the Tripp Lite
product by requesting the equipment in question be sent to Tripp Lite for examination. This policy is above and beyond, only to the
extent needed, of that provided by any coverage of connected equipment provided by other sources, including, but not limited to, any
manufacturer’s warranty and/or any extended warranties.
EXCEPT AS PROVIDED ABOVE, TRIPP LITE MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Some states do not permit limitation or exclusion of implied
warranties; therefore, the aforesaid limitation(s) or exclusion(s) may not apply to purchaser.
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL TRIPP LITE BE LIABLE FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL,
OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OF THIS PRODUCT, EVEN IF ADVISED OF THE POSSIBILITY OF
SUCH DAMAGE. Specifically, TRIPP LITE is not liable for any costs, such as lost profits or revenue, loss of equipment, loss of use of
equipment, loss of software, loss of data, costs of substitutes, claims by third parties, or otherwise.
To receive service under this warranty, you must be the original purchaser/user of the product in question. You must obtain a
Returned Material Authorization (RMA) number from TRIPP LITE. Products must be returned to TRIPP LITE with transportation
charges prepaid and must be accompanied by a brief description of the problem encountered and proof of date and place of purchase.
93-1465B (9907030) 1199
9907030 Isobar Rackmount OM DRAFT.p65
4
7/11/00, 2:22 PM
Download from Www.Somanuals.com. All Manuals Search And Download.
|